BN-LINK 20220225 Wireless Remote Control Socket User Manual
- June 5, 2024
- BN-LINK
Table of Contents
BN-LINK 20220225 Wireless Remote Control Socket User Manual
TECHNICAL DATA
Voltage: 125V-60Hz
Max.power: 10A 1250W
Transmission frequency: 433.92MHz
Remote battery: 12V (23A)
BN-LINK INC.
12991 Leffingwell Avenue, Santa Fe Springs
Customer Service Assistance: 1.909.592.1881
E-mail: support@bn-link.com
Http://www.bn-link.com
Hours: 9AM – 5PM PST, Mon – Fri
Designed in California Made in China
PRODUCTS VIEW
FEATURES
- Easily controlled by the remote control from up to 100 feet in line-of-sight.
- Separate on and off buttons on the remote control.
- Outlets will remain powered off after a power outage to save energy.
- Power output up to 1250W at 125V(60Hz).
- Low power consumption, reduces energy use and extends product life by up to 15%.
- Manual pairing and unpairing.
SETUP
- Install one 12V/23A battery in the remote control’s battery compartment, making sure the polarity of the battery is correct.
- Plug each outlet switch into a socket and plug a device or appliance into each outlet.
- Press the on/off buttons for the respective channel on the remote control to operate the outlet switch.
NOTES
- Regularly change the battery in the remote control for best performance. If you find the outlet switches are not responding or the LED indicator on the remote control becomes dim, the battery should be replaced. Always dispose of old batteries properly with consideration for the environment.
- Make sure the battery and outlets are installed firmly and correctly for safe operation.
- These outlet switches are for indoor use only. Avoid exposure to high temperature sources, strong sunlight and moisture. The outlets are best used in air as with good air circulation.
- Do not exceed the maximum load current of 10A(Approximately 1250W).
PROGRAMMING THE OUTLETS
Notes: The outlets are pre-programmed for immediate use, but the configuration can be customized to meet your needs.
To program a remote control transmitter and outlets switch receiver:
- Remove the outlet receiver from the power socket, then plug the outlet receiver back into the power socket.
- Press and hold the teaming & ON/OFF” button till the indicator start to flash.
- Release the “Learning & ON/OFF” button, press and hold the corresponding “ON” button on the remote until you hear a “click”.
- The indicator will stop flashing indicating that pairing is successful.
RESETTING AN OUTLET
Should you wish to unpair an outlet receiver from the remote, or if your outlets are unresponsive to the remote, the outlets can be reset following below steps.
- Remove the outlet receiver from the power socket.
- Press and hold “Learning & ON/OFF” button on the outlet receiver.
- While still holding the button, plug the outlet receiver to a power socket and wait to see the indicator to flash.
- When the indicator stops flashing, you may release the button, and the reset process is now complete. 5. You may program the outlet after resetting.
TROUBLESHOOTING
In the case that one or more of the outlet receivers do not respond to the remote control, please follow the steps given below to resolve the issue:
- Check to see if the battery of the remote is low and needs replacement.
- Make sure that the outlet receiver correctly placed in the power socket.
- Make sure that the outlet receiver is used in an area with proper air circulation to avoid overheating.
- Reset and program the outlet(s).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>