ENFORCER SM-4302 Rollerball-Type Recessed-Mount Contact User Manual

June 5, 2024
ENFORCER

ENFORCER SM-4302 Rollerball-Type Recessed-Mount Contact

ENFORCER SM-4302
-Rollerball-Type-Recessed-Mount-Contact-PRODUCT

Specifications

Loop type Closed loop
Electrical configuration N.O. (SPST)
Switch type Rollerball
Switch travel ¼″ (6mm)
Connectors 18″ (46cm) Leads
Housing color White
Material Switch
Contacts Iridium-plated
Contact rating 1.0A@10VDC (max.)

10W (max.)
Switch cycles| 50 Million (0.1mA@5VDC)
Operating temperature| -15°~160° F (-25°~70° C)
Dimensions| 19/16″x15/16″x15/8″ (40x24x41 mm)
Magnet type| Rare-earth neodymium

Installation

Please read the manual carefully before you begin the installation.

  1. Mount the switch in the frame so that when the door or window closes, the rollerball will be pressed in.
  2. Connect the two wires to the alarm control panel.
  3. Test to ensure that the switch is consistently closed when the door/window is closed and install a spacer (provided) if needed so that the gap, when door/ window is closed, does not exceed 1/4″ (6mm).
  • Used for protecting sliding doors and windows where space is limited
  • Magnet and reed switch contained in a housing
  • Plunger travel is 1/4″ (6mm)
  • 18″ (46cm) Wire leads
  • Contact reed switch is SPST, iridium-plated to have a high melting point and Vickers hardness for higher power handling and longer expected life
  • For closed-loop circuits
  • Spacer and screws included
  • Lifetime limited warranty

Parts List

  • 1x Contact switch
  • 1x Spacer
  • 2x Mounting screws
  • 1x Manual

Overview

  • Protected side of the door/window.

California Proposition 65 Warning: These products may contain chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

LIMITED LIFETIME WARRANTY

This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for the lifetime of the product. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. Under no circumstances will SECO-LARM be responsible for anycosts or charges for removal, installation, or reinstallation. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to repair or replacement only, at SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else. This lifetime limited warranty is for products sold and installed in the United States and Canada. For all other countries the warranty is 1 (one) year.

NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2022 SECO-LARM U.S.A., Inc. All rights reserved.

U.S.A., Inc.

16842 Millikan Avenue, Irvine, CA 92606

Phone

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

ENFORCER User Manuals

Related Manuals