MONGOOSE SP904 Security Upgrade Pack Instruction Manual

: June 3, 2024
: MONGOOSE

Table of Contents

SP904 Security Upgrade Pack
INSTALLATION & WIRING GUIDE
Documents / Resources

Model: SP904 – SECURITY UPGRADE PACK FOR VT904

SP904 Security Upgrade Pack

Includes;

An engine starter immobilizer relay kit (For engine immobilization via the APP)
A vehicle’s car alarm connection kit (Sends the SOS text alert)
An ‘SOS’ emergency button (Sends the SOS alert text alert)
NOTE: 24-volt vehicles – relays not supplied.

INSTALLATION & WIRING GUIDE

Use in conjunction with the ‘Activation Manual’ supplied with the VT904 GPS tracker MONGOOSE SP904 Security Upgrade Pack

ENGINE STARTER IMMOBILISER
To prevent engine starting, as a means of protection against theft or nonauthorized use, only the starter motor is to be immobilized as this does not affect the safe operation of the vehicle. Turn ON/OFF with the mobile APP or text command.
IMPORTANT NOTE:
Immobilizing circuits other than the starter motor (eg: ignition or fuel pump) may result in the vehicle stopping unexpectantly whilst being driven which could cause death or injury.
CAR ALARM SIREN & SOS BUTTON INPUT
The wiring diagram above shows how a (+) positive trigger Mongoose car alarm siren is connected. If connecting to a negative trigger alarm system, connect pin 85 to constant
(+) positive supply and pin 86 to the negative trigger of the siren.
NOTE: The siren input does not provide for a pulsed siren or horn triggers.
USE THE MOBILE APP TO TEST THE SP904 INSTALLATION
The ‘WIZARD’ must be completed to allow access to TEXT COMMANDS
It is critical that the SP904 options are tested by the tracker’s owner/user by using the 4G
MONGOOSE GPS mobile APP as detailed in the VT904 manual supplied with the tracker.
STARTER IMMOBILISATION

Open the mobile APP. Complete the Wizard if not done previously, then log on.
Select ‘menu’ and then ‘text commands’
Select the immobilizer command and choose ‘ON’.
The APP will ask for confirmation to prevent accidental immobilization.
Test immobilization by attempting to start the engine.
Assuming immobilization is successful, re-engage the starter by sending the ‘OFF’ text command. Test for correct operation by starting the engine.

SOS or CAR ALARM TEXT ALERT
When the alarm Siren is activated, or the SOS button is pressed, the VT904 will alert the owner and authorized mobile phones with an ‘SOS’ text message.
There is a built-in 4~5 second delay before the alert is sent to allow for false alarms afor the vehicle owner to cancel the alarm sounding.
Arming/d isarming and pre-intrusion chirps do not cause an alert.
YOU must send TEXT command to VT904 to set up 2 phone numbers that the VT904will text when SOS- SIREN alert is triggered. Must enter 2 x phone numbers
SEND TEXT to VT904 sos,XXXXXXXXX,XXXXXXXXX XXXXXXXXX = mobile phone numbers that you want VT904 to send SMS Alert to. (can use one phone number twice instead of 2 difference phone numbers)
Reply from VT904 SOS! S1:XXXXXXXXX S2:XXXXXXXXX
Please download the full manual from either of the official websites below as it contains a greater range of operation commands and detailed operating instructions and explanations.

Australia
Email: sales@mongoose.com.au
www.mongoose.com.au
New Zealand
Email: sales@mongoose.co.nz
www.mongoose.co.nz
GPS tracking website: www.mongoosegps.com
Mobile APP:- 4G MONGOOSE GPS

Documents / Resources

| MONGOOSE SP904 Security Upgrade Pack [pdf] Instruction Manual
SP904 Security Upgrade Pack, SP904, Security Upgrade Pack, Upgrade Pack
---|---
| MONGOOSE SP904 Security Upgrade Pack [pdf] Instruction Manual
SP904 Security Upgrade Pack, SP904, Security Upgrade Pack, Upgrade Pack