JBC RHB Rework Hand Support for PHBK Instruction Manual
- June 5, 2024
- JBC
Table of Contents
JBC RHB Rework Hand Support for PHBK
Packing List
The following items are included:
Features
Assembly
Setting up the Hand Support Arm
Fit the shaft into the base bushing (1) and tighten the headless screw (2).
Then assemble first the height adjustment flange (3) and finally the hand
support arm (4) onto the shaft. The hand support arm position should be as
shown in the image. The right-hand support ist marked at its bottom side with
the letter “R”.
Height Adjustment
According to your work needs the hand support arm allows adjustment for different heights through the vertical axis. Slide the arm to the appropriate height (1) and secure by tightening the knob (2) to guarantee stability.
Work Position Adjustment
RHN arm allows adjustment for different positions according to your work
needs. The articulated arm covers all work areas.
The correct hand work posion ist shown in the following images:
Accessories
If a second hand support ist need, Left Hand Support HRL is available. HRL
also allows adjustment for different positions.
In case of using both left and right arms, assemble both as shown in the
illustration according to the letters on the back of the hand support, to
keep the hand supports at the same level.
Compatible JBC Articles
HRR and HRL can be combined with RWT, RWS or RWB.
Maintenance
- Check periodically that RHS is clean, especially the sliding parts and the shaft.
- Use a damp cloth when cleaning. Alcohol can only be used to clean the metal parts.
- Replace any defective damaged parts. Use original JBC spare parts only.
WARNING
Not leave up RHN over the preheater when the preheater is working.
Safety
It is imperative to follow safety guidelines to prevent electric shock, injury, fire or explosions.
- Do not use the equipment for any purpose other than PCB rework.
- The temperature of accessible surfaces may remain high after the unit is turned off. Handle with care.
- Be careful with the fumes produced when soldering.
- Keep your workplace clean and tidy. Wear appropriate protection glasses and gloves when working to avoid personal harm.
- Not leave up the arms directly above heat surfaces.
- Utmost care must be taken with liquid tin waste which can cause burns.
- This appliance can be used by children over the age of eight as well as persons with reduced physical, sensory or mental capabilities or lacking experience provided that they have been given adequate supervision or instruction concerning use of the appliance and understand the hazards involved. Children must not play with the appliance.
- Maintenance must not be carried out by children unless supervised.
Specifications
RHB
Rework Hand Support for PHNK Ref. RHB-A
- Base Dimensions:
- Total Height:
- Arm Height:
- Arm Lenght:
- ESD Connector
- Total Net Weight:
- (L x W x H)
- Complies with CE standards ESD Safe
- 480 x 550 mm / 18.9 x 21.7 in 205 mm / 8.07 in
- 200 mm / 7.87 in
- 498 mm / 19.61 in
- 12.13 kg / 26.74 lb
- 23.43 x 20.67 x 7.28 / 31.24 lb
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>