ENFORCER SM-4601-LQ Industrial Wide-Gap Magnetic Contacts User Manual

: June 5, 2024
: ENFORCER

Table of Contents

ENFORCER SM-4601-LQ Industrial Wide-Gap Magnetic Contacts
Parts List
Specifications
Installation
Overview
LIMITED LIFETIME WARRANTY
SECO-LARM° U.S.A., Inc
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ENFORCER SM-4601-LQ Industrial Wide-Gap Magnetic Contacts

ENFORCER-SM-4601-LQ-Industrial-Wide-Gap-Magnetic-Contacts-
product

Useful for industrial situations where a wide gap, surface mount contact is needed
36″ (91cm) Wire leads enclosed in armored cable
Contact switch has iridium-plating for a high melting point and Vickers hardness for higher power handling and a longer expected life
Weatherproof (IP65) and sealed for outdoor use
Rugged aluminum housing
3″ (76mm) Gap
Mounting bracket included
Lifetime limited warranty

Parts List

1x Contact switches
1x Magnets
2x Mounting screws
1x Manual
1x Mounting bracket

Specifications

ENFORCER-SM-4601-LQ-Industrial-Wide-Gap-Magnetic-Contacts-
fig-1

Installation

Please read the manual carefully before you begin the installation.

Mount the contact on the track in a safe location away from equipment interference and near where the magnet will be when the door is closed.
Run the armored cable out of the way. Run wires from the alarm control panel and connect to the corresponding wires extending from the cable armor.
Mount the magnet on the roll-up door so that it will trigger the contact when the door is closed. Be sure that the gap between the contact and magnet does not exceed 3″ (76mm).

Overview

Contact and magnet must be installed on the protected side of the door.
Wiring shown is for the SM-4601-LQ. SM-4601-L3Q will be different.

California Proposition 65 Warning: These products may contain chemicals that are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

LIMITED LIFETIME WARRANTY

This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for the lifetime of the product. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. Under no circumstances will SECO-LARM be responsible for any costs or charges for removal, installation, or reinstallation. This Warranty is void if the damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or] alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to repair or replacement only, at SECO-LARM’s option. In no event shall sec-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else. This lifetime limited warranty is for products sold and installed in the United States and Canada. For all other countries, the warranty is 1 (one) year.

NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2022 SECO-LARM U.S.A., Inc. All rights reserved.