rebel ZAB0031 ELECTRIC KICK SCOOTER Instruction Manual

rebel ZAB0031 ELECTRIC KICK SCOOTER Instruction Manual

AN IMPORTANT MESSAGE TO PARENTS

important information. For your child’s safety, it is your responsibility to review this information with your child and make sure that your child understands all warnings, cautions, instructions and safety topics. We recommend that you periodically review and reinforce the information in this manual with younger riders and that you are required to inspect and maintain your child’s scooter to insure their safety.

GENERAL WARNING:

Scooter riding can be a hazardous activity. Scooters can, and are intended to move and it is therefore possible to get into dangerous situations and/or lose control and/or fall. If such things occur you can be seriously injured.
LIKE ANY OTHER MOVING PRODUCT, USING A SCOOTER CAN BE A DANGEROUS ACTIVITY AND MAY RESULT IN INJURY EVEN WHEN USED WITH PROPER SAFETY PRECAUTIONS. USE AT YOUR OWN RISK
AND USE COMMON SENSE

• Protect this device from water, humidity and other liquids. Avoid using/storing it in extreme temperatures. Do not expose it to direct sunlight and other sources of heat.
• Before connecting the device to power supply socket, make sure the voltage indicated on the device corresponds to the voltage in the power supply socket.
• This appliance may be used by children who are above 8 years old and by persons with reduced physical, sensory or mental capabilities,or lack of experience and knowledge, if they are supervised and  guided by a person who is responsible for their safety in a cautious manner for all the safety precautions being understood and followed. Children should be supervised to ensure that they do not play with the appliance. Children should not perform cleaning and servicing of the device unsupervised.
• Product is not suitable for the use of persons whose health might be in danger in case of possible falling down from the vehicle (children, the elderly, pregnant women, etc.).
• Do not use the product in case of abnormal operation.
• Use only authorized accessories.
• Do not disassemble nor repair this device yourself. In case of damage, contact authorized service point for check-up or repair.
• Always disconnect the product from the power source before cleaning.
• o not use this device near flammable products.
• The vehicle is designed for one person at a time only! It’s prohibited for two persons to drive the vehicle at once.
• Do not lift the device off the ground when it is turned on. Do not turn it on in midair.
• Do not ride this device off of curbs, ramps or attempt to operate in a skate park, empty pools or any ways similar to a skateboard. Do not attempt any trick or stunts. This vehicle is not suitable to ride upstairs, downstairs.
• Do not climb up or down steep hills.
• Do not jump off nor on your scooter.
• Always check the vehicle before using it for abnormalities or damages. Do not use the scooter in case of any damages!
• IMPORTANT: Product warranty does not cover elements which are subjects to natural wear out during use!
• Do not allow exceed 50 kilograms on the scooter. The weight of the user and their belongings should not exceed the maximum load indicated in the instruction.
•  Remember to wear a helmet, knee pads, elbow pads and other protective gears. Always wear a helmet when riding your scooter and keep the chinstrap securely buckled.
• Always wear shoes. Keep shoelaces tied and out of the way of the wheels.
• Always maintain a hold on the handlebars.
• Avoid sharp bumps, drainage grates, and sudden surface changes.
• Avoid streets and surfaces with water, sand, gravel, dirt, leaves, and other debris. Wet, slick or uneven and rough surfaces may impair traction and contribute to possible accidents.
• Do not ride at night or when visibility is impaired.
• Avoid excessive speed associated with downhill rides.
• Adults must assist children in the initial adjustment procedures to assemble the scooter.
• Obey all local traffic and scootering laws and regulations.

PRODUCT DESCRIPTION

1. Handlebar
2. Handle height adjustment lock
3. Folding mechanism lever
4. Folding mechanism lock
5. Charging port
6. Power pedal
7. Foot brake

INSTALLATION

1. With the scooter folded, pull the folding mechanism lever and lift the fork up until you hear a click.
2. Lock the lever by tightening the folding mechanism lock.
3. Use an Allen key to attach the handlebar to the fork.
4. To adjust the height of the handlebar, release the handlebar height adjustment lock, press down on the locking element and pull the handlebar up or down.
5. After adjusting the height, tighten the handlebar height adjustment lock.
6.   fold the scooter, release the folding mechanism lock and pull thefolding lever up.

OPERATION

1. Hold the handlebar with both hands.
2. Place one foot on the round power pedal.
3. Then push the other leg back and place it on the scooter. Upon reaching 5-6 km / h, a short beep will be heared and the engine wil start to drive the machine.
4. Maximum speed of the scooter is 12 km/h.
5. To stop engine, step off the power pedal.
6. To brake, press the brake with your foot.
7. A low battery is signaled by a series of beeps when trying to start the

BATTERY

1. Please be sure the battery has been fully charged before use. Charge the battery when the battery indicator shows a low charge.
2. Never disassemble/modify the battery.
3.  Do not use the device when it is charging!
4. Ensure the charging port is dry prior to charging!
5. Charge the vehicle only with the included/authorized power adapter.
6. Charge the battery after each use to keep it in optimum condition.
7. Do not charge the device in temperature below 5ºC or above 45ºC

CHARGING

1. Plug the charger into mains socket (110-240 V, 50/60 Hz). The light on the charger lights up green.
2. Plug the other end of the charger into the vehicle. The indicator on the charger will turn red. (otherwise, make sure the charger is connected properly).
3. When the indicator turns from red to green, the charging is complete. Disconnect charger from the device and power mains outlet.
4. not overcharge the device, as it may affect battery life.

IMPORTANT: Remember to close the rubber plug after the charging is completed to ensure protection against water and dust ingression.

CLEANING AND MAINTENANCE

1. Do not clean this device when in the process of charging!
2. Clean the device with a soft, slightly damp cloth. Do not use any chemical agents to clean this device.
3. Do not store the device unused for longer than 4 months without charging as it may result in battery damage

Do not wrap up the vehicle or place it in the package right aftercharging it, as it may get warmer during charging – risk of fire.

SPECIFICATION

General
Power: 100 W
Maximum load: 50 kg
Maximum speed: 12 km/h
Range per charge: up to 6 km*
Maximum slope: 5º
IP rating: IPX4
Chassis height: 60 mm
Platform height: 100 mm
Front wheel size: 5,5”
Rear wheel size: 5,5”
Material: aluminum + plastic
Foldable construction
Auto power off
Foot brake

Battery

Rechargeable lithium-ion battery Voltage: 25,2 V Capacity: 2 Ah
Working temperature: -10ºC ~ +45ºC
Storage temperature: 0ºC ~ +25ºC
Charging temperature: 5ºC ~ +45ºC
Approximate charging time: up to 180 minutesCharger:
Input: 110-240 V, 50/60 Hz Output: 25,2 V; 1 A

Physical parameters

Net weight: 4,5 kg
Dimensions (unfolded): 720 x 350 x (640-840) mm
Dimensions (folded): 660 x 360 x 230 mm
Set includes: kick scooter, user manual, charger
*please note, range is directly dependent on numerous factors and it
represents maximum approximate value

LEARN MORE

For more information on this device visit: www.rebelelectro.com.
Read owner’s manual carefully before using your device.
Visit www.rebelelectro.com website for more products and accessories.

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment) (Applicable in the European Union and other European countries with separate collection systems)
This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal. Made in China for Lechpol Electronics Leszek Sp.k., ul. Garwolińska 1, 08-400 Miętne

Read More About This Manual & Download PDF:

References

• Rebel Electro - Co weekend SuperOkazje

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>