GOOLRC LS-XT6 RC Drone Mini Drone 6-Axis Gyro User Manual
- June 5, 2024
- GOOLRC
Table of Contents
GOOLRC LS-XT6 RC Drone Mini Drone 6-Axis Gyro
FORBIDDEN :
Special despecial design for indoor & outdoor,please keep it away from
obstacle
This product is suitable for indoor(the wind grade should be no more than
4),please dhoose a place without obstade,and keep distance from crowd and
pets,don’t play it under unsafty, for instaance,heat source,heat source,v.rire
or electonic power source in order not to be damaged by collision
landing,entanglement and lead to a fore,e!ectric shock and cause losses of
lives and property.
WARNING:
Obtain the assistance of an experienced pilot. The products are suitable for
more than 14 years old age,at the beginning it will have some certain
difficulty in learing,suggestion guidance by exprienced when playing.
LEAF CHANGE
-
The leaf to be replaced must be replaced with the relative position on the machine.
The blades A need to be installed in the position of A, the wind blade B must be installed in the position of B, such as the replacement of the wind blade error will not be able to control. -
When the flight leaves a clockwise rotation, the fan B to counterclockwise rotation
IMPORTANT NOTES
-
This product is NOT A TOY.It may cause damage by use rt wrongly.
Please use this priduct follow by this instrcution.And please do not disassemble this product by yourself. -
This flying model requires practice before you use it Please use the product follow by this instruction and please di not dosassembly the product. Otherwise. manufacturer shall not be responsoble to any damge of the product or injury to any person.
SAFETY NOTES
CAUTIAN :Fly only in safe areas away flam other people. Do not operate RIC aircraft within the vicinty of crowds or people.RIC aircraft are prone to accidents ,failures for their actions and damage or injury ocrurred during Pilot error,and radio interference.pilots are respinsible for their actions and damage or injury occurred during theoperation or as of a fesult of R/C aira-aft models
Introduction of transmitter
Assembled remote controller
Open the battery cover on the back of remote controller.Insert two #7 alkaline
batteries in accordance with the instructions on battery box.(Battery should
be purchased separately.old and new or different types of batteries shouldn’t
be mixed.) Recharge the quadcopter battery
Insert the factory equipped charger plug into the power,the recharger
indicator is green, then connect the product battery, the indicator will turn
to red.it indicate the battery is under recharging.when the indicator turns to
green again under the recharge status,that means recharge finish and the
battery is full.Whole recharge time will be around 30 minutes Press 30 mode
key.the transmitter indicator turns on.fly the quadcopter to 2 meters high and
press the right control stick to any direction quickly to its bottom and
release ii, the quacopter ‘Nill roll lo the direclion corresponding to the
right control slick, If need to quit then press the key again
Battery safety instructions:
READY TO FLY
Make sure the prnpeller is installed correctly and fastened
- Turn the right remote control support to tum on the remote control
- Frequency: first vertical up the left joystick, then allocated to the bottom: aircraft indicator light is always on, the frequency to complete
TAKEOFF METHOD 1:
- Place the aircraft on the horizontal plane two rocker at the same time as the operation of 2-3 seconds, the aircraft indicator light in often the aircraft. turned into a fast flash, and then 2-3 seconds into a straight. that calibration is successful.
- Two rocker at the sane time as s h o wn in Figure 2-3 seconds to unlock
- Slovly push the thro ttle stick to take off.
TAKEOFF METHOD 2:
Place the aircraft on the horizonta1 plane, two rocker at the same as the operation of 2-3 seconds, the aircraft indicator light is often turned into a fast flash, and then l seconds into a straight, that calibration is successful. Press the thro ttle stick, the aircraft a key to take off.
Flying controlled and fine tuning
Headless mode: In no open mode, the aircraft took off in the
direction of East and West position, the rear of the aircraft to take off this
south, a tube aircraft flying far, what direction to go, then pull back
forward, backward / left and right side joystick to fly the aircraft will fly
back to retreat south. (Vehicle chassis have ON-OFF of the back)
A return key: Press a buttor to return the vehicle will automatically fly back
to the starting position at takeoff.
Flying practice
Accelerating operation:
Slowly push the acceleration lever until the quadcopter take off from the ground and hovers in the air.then pull the acceleration lever back until the quadcopter slowly descends. Practice this repeatedly until you could control the acceleration lever smoothly.
Vice-blade operation:
When the quadcopter hovers in the air, push the right lever slowly to make the quadcopter fly forward/back ward/to left/to right.
Turning operation:
When the quadcopter hovers in the air, push the turning rudder slowly to make the quadcopter turns left or right.
Camera / Video
Camera led status description:
- When the bottom camera kit blue indicator light ,red LED flashes then the vehicle has power but no SD card or the SD card is not inserted.
- Photo button the remote control aircraft camera box red blinking lights on the bottom, then the aircraft take a photo and automatically stored in SD card photo.
- Video button the remote control aircraft camera boxes on the bottom red light stay lit. it means that aircraft are video photo/video button then press the remote control aircraft camera boxes on the bottom red led is not lit.it means that the fly exit the camera status and automatically stored in SD card video.
- Power off the aircraft take out SD card through the card reader connected to the computer or SD card directly your mobile phone using the corresponding format player to play videos and view photos
TIPS:
When matching signal, keep the quadcopter on horizontal position for faster matching and starting a stable flight.
indoor’s flight: please select spacious place without obstacle, pets and people for flight.
outdoor’s flight: please select a warm sunny and no wind or breeze for flight.
Note:
Don’t fly in the extreme weather and the model maybe damag e d in extreme heat or cold w eather which will aff ect flight effect.
Don’t fly in the strong wind weather which will cause limitations to the flight or hinder your flight control. In the case of strong wind, your aircraft will vanish or damage.
Common problem and solution instruction
Accessories
FCC Compliance Statements
This device complies with Part 15 of the FCC Rules, Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules_ These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>