EFFYDESK ED-PMONA-DA Aircraft Aluminum Dual Monitor Arms Installation Guide
- June 5, 2024
- EFFYDESK
Table of Contents
- STEP 1 The Preparation Before Monitor Installation
- STEP 2-A Option1 Clamp
- STEP 2-B Grommet
- STEP 3 Connect the plate and monitor
- STEP 4 Install the monitor to the arm
- STEP 5 Adjust the monitor
- STEP 6 Adjust the Rotation arm
- Cable Management
- Specification
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
ED-PMONA-DA Aircraft Aluminum Dual Monitor Arms
Installation Guide
1.Support arm (1 PC) | 7.Long screw (1PC) |
---|---|
2.Base Mounting Plate (1PC) | 8.Protection pad (1PC) |
3.Protection pad (2PCS) | 9.Knob nut (1PC) |
4.Protection pad (1PC) | 10.Pressure plate (1PC) |
5.Plastic cable cover (1PC) | 11.Mount Plate (2PCS) |
6.Perforated plate (1 PC) | 12.Clip (2PCS) |
STEP 1 The Preparation Before Monitor Installation
- Make sure there are VESA holes 100x100mm or 75x75mm in the monitor. If not, the mount couldn’t be installed.
- Remove the original fixed base of the monitor. Be careful not to scratch the screen.
STEP 2-A Option1 Clamp
STEP 2-B Grommet
STEP 3 Connect the plate and monitor
STEP 4 Install the monitor to the arm
STEP 5 Adjust the monitor
STEP 6 Adjust the Rotation arm
When the size of the monitors is small and the distance between the two monitors is too large, the arms can be rotated to adjust the distance between the two monitors.
Cable Management
- Take off cable management and put cable management back to cover cables once finishing the management
Specification
CAUTION
This product contains small items that could be a choking hazard if
swallowed. Keep these items away from young children.
- Make Sure these instructions are read and completely understood before attempting installation.|f you are unsure of any part of this installation, please contact a professional installer for assistance.
- The desk or mounting surface must be capable of supporting the combined weight of the mount and the display, otherwise, the structure must be reinforced.
- Safety gear and proper tools must be used.A minimum of two people are required for this installation. Failure to use safety gear can result in property damage, serious injury, or death.
- please check joint parts every two months, making sure the screws are loosened or not.
This product was designed to be installed on the desk. Before installing, make
sure the mount will support the combined load of the equipment and
hardware. Never exceed the maximum load capacity of 9 KG, or else it may
result in product failure or personal injury.
Note: this product is intended for indoor use only. The use of this
product outdoors could lead to product failure or personal injury.
Warning: This product contains high-pressure gas spring parts, please do
not put it on fire, at high temperature, or disassemble it, which will lead to
unexpected
personal injury. The obsolete products can be sent back to the manufacturer or
handed over to professional institutions.
To ensure the sealing performance of the gas spring, it is suggested to have a
complete adjustment to the upper arm (with spring) one time or several times
every month.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>