PHILCO PHWK 2000 Electric Kettle with Temperature Control Instruction Manual

PHILCO PHWK 2000 Electric Kettle with Temperature Control Instruction Manual

IMPORTANT SAFETY INSTRUCTIONS

• This appliance may be used by children 8 years of age and older and by persons with physical or mental impairments or by inexperienced persons if they are properly supervised or have been informed about how to use of the product in a safe manner and understand the potential dangers. Cleaning and maintenance performed by the user must not be performed by children unless they are older than 8 years of age and under supervision. Keep this appliance and the power cord out of reach of children younger than 8 years of age.
• Children must not play with the appliance.

READ CAREFULLY AND STORE FOR FUTURE USE.

• Before connecting the variable temperature kettle to a power socket check that the voltage stated on the rating label matches the electrical voltage in the socket.
• Connect the variable temperature kettle only to a properly grounded socket.

ATTENTION:
This variable temperature kettle is not designed to be controlled using a programmed device, external timer switch or remote control.

• The variable temperature kettle is designed for domestic use and similar places such as:
  • staff kitchens in stores, offices and other workplaces;
  • hotel or motel rooms and other living areas;
  • bed and breakfast establishments;
  • agricultural farms.
• Do not use the variable temperature kettle outdoors.
• Do not place the variable temperature kettle on window sills or on unstable surfaces. Always place the variable temperature kettle on a stable, even and dry surface.
• Never use the variable temperature kettle in the near vicinity of a bath, shower or swimming pool.

WARNING:
Do not submerge the variable temperature kettle or its base in water or any liquids.

• Only use the variable temperature kettle with the base that was supplied with it. Do not use the base supplied with this variable temperature kettle for other types of kettles.
• Use the variable temperature kettle only for boiling water.
• If the variable temperature kettle is overfilled, then boiling water could splash out.
• Don’t move the kettle lid or open it while the water is boiling.
• The body of the kettle is heated up while water is boiled. Do not touch the hot surface. This could cause skin burns. Use the handle for lifting and carrying the variable temperature kettle.
• Pay extra attention when handling a kettle fi lled with hot water.
• The variable temperature kettle is protected against damage caused by accidentally running it without water.
• If the variable temperature kettle is running, do not leave it unattended.
• Always disconnect the variable temperature kettle from the power socket if you will not be using it or before moving or cleaning it.
• Do not place the variable temperature kettle on an electric or gas stove or in its vicinity, do not place it in the vicinity of an open fi re or an appliance that is a source of heat.
• Ensure that the power cord does not come into contact with water or moisture.
• Do not place heavy items on the power cord. Make sure the power cord does not hang over the edge of a table, or that it does not touch a hot surface.
• Do not disconnect the variable temperature kettle from the power socket by pulling on the power cord. This could damage the power cord or the power socket. Disconnect the cord from the power socket by gently pulling the plug of the power cord.
• Do not use the variable temperature kettle if it has fallen on the fl oor, has visible signs of damage or if it is leaking.
• If the power cord is damaged, have it replaced at an expert service centre. It is forbidden to use the variable temperature kettle if it has a damaged power cord or plug.
• To avoid the danger of injury by electrical shock, do not repair the variable temperature kettle yourself or make any adjustments to it. All repairs of this variable temperature kettle should be carried out at an authorised service centre. Tampering with the appliance during the warranty period may void the warranty
  policy.

DESCRIPTION OF THE FAST BOIL KETTLE

1. Spout with a removable fi lter
2. Lid
3. Open lid button
4. Display
5. Control buttons
6. Handle
7. Kettle body
8. Water level mark with light
9. Base with a central connector

DESCRIPTION OF THE DISPLAY WITH CONTROL BUTTONS

1. Quick 100°C boil button
2. Set temperature 20-30-40-50-60-70-80-90-100 °C button
3. Button for setting the maintain water temperature function (KEEP WARM)
4. 3-minute boil button (CLEAN WATER)
5. Preset temperature
6. Current water temperature

BEFORE FIRST USE

1. Remove all wrapping material from the variable temperature kettle and its base.

2. Fill the variable temperature kettle with clean water up to the maximum water mark. Boil the water and empty the contents of the kettle. Repeat this process 2 to 3 times.
   NOTE:
   To boil water in the variable temperature kettle proceed according to the instructions in chapter Using the kettle.

3. Now the variable temperature kettle is ready for use (for preparing warm beverages, etc.).

USING THE FAST BOIL KETTLE

Quick 100 °C boil

1. Plug the power cord into an electric socket. The connection of the kettle will be accompanied by a sound and the display will be backlit and the water level mark (8) and control buttons (5) will be backlit for a short time. The current temperature inside the kettle will be shown on the display.
2. Take the kettle off the base (9) and press the open lid button (3).
3. Fill with the required amount of water, close the lid and place the kettle back on to the base. Check that the kettle lid is properly closed.
4. Press the quick boil button (1) to start the kettle, the pressed button and the water level mark will be lit.
5. As soon as the water in the kettle starts to boil, the heating of the water will automatically be stopped, which will be accompanied by 5 sound signals. The backlit water volume indicator will turn off.
6. The current water temperature will be shown on the display.
7. The colour of the water level mark backlight changes during the course of the boil depending on the water temperature (see table below).

Heating water to a required temperature

Using this function you can set a specific temperature for the heated water.

1. Fill the kettle with the required amount of drinking water.
2. Repeatedly press the temperature setting button (2) to set the desired water temperature (20, 30, 40, 50, 60,70, 80 or 90 ˚C), the pressed button and the water level mark of the kettle will be lit.
3. The current water temperature will be shown on the display together with the water temperature you set.
4. As soon as the water in the kettle reaches the preset temperature, the heating of the water will automatically be stopped, which will be accompanied by a sound. The backlit water volume indicator will turn off.

NOTE:
It is not possible to use the heat water to desired temperature function to lower the temperature of the water in the kettle. If you pour room temperature water at 25 °C into the kettle and set the target water temperature to 20 °C, the kettle will not run in this mode.

Maintaining the set water temperature (KEEP WARM function)

NOTE:
The keep warm function can be used to maintain the water temperature of water heated to a desired temperature or water boiled and subsequently cooled to the desired temperature. Both these methods are described further on in this manual in points E and F.

1. Press the keep warm button (3) to activate the function for maintaining a desired water temperature, the pressed button and the water volume indicator will be lit.
2. The display will show the current water temperature in the kettle together with the water temperature at the instant that the heating button is pressed.
3. The water temperature will be maintained at the desired level for 30 minutes.

NOTE:
It is not possible to use the keep warm function to lower the temperature of the water in the kettle. If the ambient temperature is higher than the set temperature, the kettle will not run in this mode.

3-minute boil button (CLEAN WATER function)

1. Press the 3-minute boil button (4) to activate the long boil function, the pressed button and the water volume indicator will be lit.
2. The kettle will bring the water to a boil and boil it for 3 minutes.
3. The long boil function reduces the chlorine level in the water and ensures the cleanness of the beverage.
4. Before boiling water again, leave the kettle off for 15-30 seconds.

Heat water to a desired temperature after a boil

The target temperature can be set to 20, 30, 40, 50, 60, 70, 80 or 90 °C.

1. Repeatedly press the set temperature button (2) to set the desired water temperature.
2. Confirm by pressing the quick boil button (1).
3. The kettle will bring the water to a boil and as soon as it cools to the preset temperature, a short sound will be made.

NOTE:
It is not possible to use the heat water to desired temperature function to lower the temperature of the water in the kettle. If you set the target water temperature lower than the ambient temperature, the kettle will not run in this mode.

Heat water to a desired temperature and maintain that temperature

The target temperature can be set to 20, 30, 40, 50, 60, 70, 80 or 90 °C.

1. Repeatedly press the set temperature button (2) to set the desired water temperature.
2. Press the keep warm button (3).
3. Water will heat up to the desired temperature at which is will be maintained for 30 minutes.

NOTE:
It is not possible to use the heat water to desired temperature function to lower the temperature of the water in the kettle. If you pour room temperature water at 25 °C into the kettle and set the target water temperature to 20 °C, the kettle will not run in this mode.

Heat water to a desired temperature after a preceding boil and maintain that temperature.

The target temperature can be set to 20, 30, 40, 50, 60, 70, 80 or 90 °C.

1. Repeatedly press the set temperature button (2) to set the desired water temperature.
2. Press the keep warm button (3).
3. Press the quick boil button (1).
4. As soon as the water in the kettle reaches the boiling point, the temperature will start to gradually fall. After reaching the set temperature, the water in the kettle will be maintained at this temperature for 30 minutes.

NOTE:
It is not possible to use the heat water to desired temperature function to lower the temperature of the water in the kettle. If you set the target temperature to a lower level than the ambient temperature, the kettle will not run in this mode.

CLEANING AND MAINTENANCE

•  Before cleaning, disconnect the power cord from the el. power socket. Empty the variable temperature kettle and allow it to cool down.

Cleaning the filters

• The removable filter serves to capture scale deposits and prevents them from getting into the prepared beverage. Regularly clean the filter under running water using a fi ne nylon brush or submerge it for several hours into a vinegar & water solution (recommended dilution ratio 1:2). After applying the solution, rinse the filter under clean running water.

Cleaning the variable temperature kettle

• Regularly remove water scale deposits from inside the variable temperature kettle based on how frequently the kettle is used. During standard use (3 to 5 times per day), we recommend water scale deposits be removed:
  • once per month in areas with hard and very hard water;
  • once every two to three months in areas with soft and medium hard water.
• To remove water scale deposits it is possible to use:
  • 8% white wine vinegar, generally available in stores. Put ½ l of vinegar into the kettle and allow it to settle for 2 hours without boiling. Then empty the variable temperature kettle and before further use boil clean water in it four to five times.
  • citric acid. Boil ½ l of water in the kettle. Into the boiled water add 30 g of citric acid and allow it to settle for about 30 minutes. Then empty the variable temperature kettle and before further use boil clean water in it four to five times.
• To clean the external parts of the variable temperature kettle use a dry cloth or a cloth lightly dipped in a weak solution of neutral kitchen detergent. After applying the kitchen detergent, wipe the surface with a lightly damp cloth and then wipe dry.
• To clean the base use only a dry cloth.
• To clean the variable temperature kettle and its base, never use cleaning agents causing abrasion, petrol, solvents, etc.

TECHNICAL SPECIFICATIONS

Nominal voltage range: 220−240 V
Nominal frequency: 50/60 Hz
Rated power input: 2000−2400 W
Capacity:  1.7 l

We reserve the right to change text and technical specifications.

INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING MATERIALS

Dispose of used packaging material at a site designated for waste in your municipality.

DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT

This symbol on products or original documents means that used electric or electronic products must not be added to ordinary municipal waste. For proper disposal, renewal and recycling hand over these products to determined collection points. Or as an alternative in some European Union states or other European countries you may return your products to the local retailer when buying an equivalent new product. Correct disposal of this product helps save valuable natural resources and prevents damage to the environment caused by improper waste disposal. Ask your local authorities or collection facility for more details. In accordance with national regulations penalties may be imposed for the incorrect disposal of this type of waste.

For business entities in European Union states If you want to dispose of electric or electronic appliances, ask your retailer or supplier for the necessary information.

Disposal in other countries outside the European Union This symbol is valid in the European Union. If you wish to dispose of this product, request the necessary information about the correct disposal method from the local council or from your retailer.

This appliance complies with EU rules and regulations regarding electromagnetic and electrical safety.

Changes in the text, design and technical specifications may be made without prior notice and we reserve the right to make such changes.

is a registered trademark used under license from Electrolux International Company, U.S.A.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>