Rowenta CF7013F0 Crimper Wave Instruction Manual
- June 5, 2024
- Rowenta
Table of Contents
Rowenta CF7013F0 Crimper Wave
SAFETY PRECAUTIONS
For your safety, this appliance complies with the technical rules and standards for safety currently in force, including the Electromagnetic Compatibility and Low Voltage Directives. The appliance’s accessories become very hot during use. Avoid contact with the skin. Make sure that the supply cord never comes into contact with the hot parts of the appliance The appliance must be unplugged :
- before moving the plates,
- before cleaning and maintenance procedures,
- if it is not working correctly,
- as soon as you have finished using it,
- if you leave the room, even momentarily.
Check that the voltage of your electricity supply matches the voltage of your appliance. Any error when connecting the appliance can cause irreparable harm, and will be not covered by the guarantee. As an additional safety measure, we recommend the installation of a residual current difference device in the electrical circuit supplying the bathroom, acting at not more than 30 mA. Ask your installer for advice.
Caution
Never use the appliance with wet hands or near baths, basins or other recipients containing water. When using the appliance in the bathroom, unplug it after use as the presence of water nearby may pose a danger even when the appliance is turned off. Close supervision is necessary when the appliance is used on or in the presence of children or severely disabled people. If the power cord is damaged, it must be replaced by the manufacturer, its after- sales service or a person with similar qualifications, to avoid all danger. Stop using your appliance and contact an Authorised Service Centre if :
- your appliance has fallen
- it does not work correctly.
- If your appliance is not working correctly, see “Troubleshooting”, or contact our Customer Helpdesk or your dealer.
- Do not leave within the reach of children.
- Do not use if the cord is damaged.
- Do not immerse or put under running water, even for cleaning purposes.
- Do not hold with damp hands.
- Do not hold the appliance by the casing, which is hot, but by the handle.
- Do not unplug by pulling on the cord, rather pull out by the plug.
- Do not use an electrical extension lead.
- Do not clean with abrasive or corrosive products.
- Do not use at temperatures below 0°C and above 35°C.
DESCRIPTION
- Crimper
- Accessory locking – and unlocking – ring
- Crimping plates with ceramic coating : tight crimping
- Crimping plates with ceramic coating : large crimping
- “Power on” light
- On/Off switch (1-0)
- Handle
- Swivel power cord
BEFORE YOU START
Inserting the crimping plates Choose the plate (large crimping fig.1 or close
crimping –fig.2) according to the effect you want.
Press the lever to open the tong. Insert the first plate by sliding it on the
groove until you hear a “CLICK “- fig. 3.
Repeat the procedure with the second plate. Plugging in your hair styler Place
the appliance in a stable position on its rest on a flat surface. Plug it in
and set the On/Off switch to On (position 1). The ‘Power on’ light will come
on- fig. 4 and the accessory will begin to heat up. Wait a few minutes to
allow your hair styler to reach its working temperature (10 min).
IMPORTANT: The ceramic coating protects your hair from excessive heat, thanks to an even distribution of the heat.
OPERATION: IMPORTANT Use this product on clean, untangled, DRY hair (to avoid damaging your hair). Gather a section of hair approximately 5 cm across, starting at the root of the hair. Press the lever to open the crimper attachment, and place the hair between the crimping plates – fig.6. Close the crimping plates for around 10 seconds Release the hair and start again just below the wave that just formed.
PROFESSIONAL TIPS
- Always work from the roots towards the tips of the hair. To enhance the effect, you can apply styling mousse before crimping.
CLEANING
- Unplug your styler and leave to cool down. Clean the crimper’s plates when fully cooled. To clean the handle, wipe with a soft, damp cloth. Never allow water or any other liquid to enter the handle. Do not use aggressive or abrasive products. Never put the appliance or accessories under the running water.
GUARANTEE
- Your appliance is designed for use in the home only. It should not be used for professional purposes. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. The guarantee becomes null and void in the case of improper usage.
ENVIRONMENT PROTECTION FIRST
- Your appliance contains valuable materials which can be recovered or recycled. Leave it at local civic waste collection point. If you have any product problems or queries, please contact our Customer Relations Team first for expert help and advice: 0845 602 1454 – UK (01) 4751947 – Ireland or consult our website –www.rowenta.co.uk
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>