ZEISS IKON The Pantar Convertible Lens for the Contina III Instructions
- June 3, 2024
- ZEISS IKON
Table of Contents
ZEISS IKON The Pantar Convertible Lens for the Contina
The Contina Ill
is equipped with a convertible Panter lens. By exchanging the front elements
of this lens the following focal lengths and speeds can be obtained:
f/2.8, 45 mm Standard lens with which the camera is originally supplied
f/4, 30 mm Wide-angle lens
f/4, 75 mm Portrait and telephoto lens
All three lenses are hard coated throughout and colour corrected. Since the speed of the wide-angle and telephoto lenses is f/4, the diaphragm must not be fully opened ta f/2.8 when these lens units are used. As usual with our cameras the exposure value indicated by the exposure meter of .the Contino Ill should be transferred to the exposure value shutter of the camera.
Exchanging the lens units
All interchangeable lens units for the Cantina Ill have a special bayonet mount. When removing a unit the camera should be held with the left hand (fig. 1). The thumb should depress the lock pawl bearing the red dot, while the front unit of the lens should be turned to the left as far
as it will go. It can then be lifted upwards and removed. When inserting a
different unit, the red dot on the mount of the front element should be
opposite the red dot on the lock pawl of the camera (fiQ. 2). Then the new
unit should be pressed in firmly and at the same time turned to the right
until an audible click indicates that it is in the correct position.
In order to prevent the high-quality lenses from being damaged or soiled, the
glass surfaces should never be touched. For storing the units the Plexiglass
containers, which are supplied with them or the practical leather case (see
page 13) should be used.
The viewfinders
The built-in viewfinder of the Contino Ill can be used only when the exposures
are made with the Panter f/2.8, 45 mm lens. If the Panter 30 mm or 75 mrn is
inserted the correct special viewfinder must be slipped into the accessory
shoe.
Wide-angle and telephoto viewfinders. Both these special viewfinders
(wide-angle finder, order no. 422; telephoto finder, order no. 423) can be
recognized by the size of the viewfinder lens opposite the eyepiece. The
larger lens belongs to the wide-angle finder .. furthermore, Epoch viewfinder
has the focal length engraved on the top.
Tele-view/ rangefinder. For the Panter 75 mm a tele-view/rangefinder is
also available (order no. 425). When looking through the eyepiece of this
viewfinder a bright square area will be seen in the centre of the image field
in which all outlines appear double (fig. 3).
By turning the milled disc on the side and pointing the finder towards a vertical line, such as a tree or the edge of a house, etc., these double outlines will merge until they coincide completely (fig. 4).
The correct distance can then be read off from the distance scale on the disc of the viewfinder and should be transferred to the Panter 75 mm.
Universal viewfinder. There is also a universal viewfinder (order no. 426). When looking through the eyepiece of this finder several bright frame lines can be seen (see fig. 5).
The two bright angles an the upper and lower sides of the central rectangle denote the image field of the Steriti-D attachment for stereo exposures.
- the outer rectangle denotes the image field of the Pantor 30 mm wide-angle lens),
- the rectangle in the center denotes the image field of the standard Pantar 45 mm lens,
- the inner rectangle shows the image field of the Pantar 75 mm (telephoto lens).
In order to compensate for the finder-parallax, the small lever (see arrow in
fig. 6) of the universal viewfinder should be set as follows:
to for distances between 13 ft and to : for distances between 6ft 6 ins and
13ft to . for distances between 3 ft 3 ins and 6 ft 6 ins
Distance and depth of field
The correct distance for all the lens combinations should be set on the chromiumploted front ring of the Panter. The depth-of-field scale on the camera body applies only to the standard Panter f/2.8, 45 mm. The 30 mm and 75 mm Pantars have each a depth-of-field scale of their own from which the zone of sharp definition can be read off. The exact ranges of these zones can be found in the tables on pages 11 and 12. The depth-of-field range of the wide- angle Panter, due to its short focal length, is far greater than that of the Tele-Panter, the sharp zone of which is considerably smaller. For this reason pictures with the telephoto lens must be focused as correctly as possible and the employment of the tele view/rangefinder is highly recommended therefore (see page 5).
Depth of field table for Pantar 1: 4 / f = 30 mm
Depth of field table for Panter 1: 4 / f = 75 mm
Accessories Leather Case
For both the 30 mm and 75 mm Ponto rs on attractive leather case is available (Yoder no. 798), which con accommodate also two viewfinders and two filters. The Pontors ore inserted into the recesses at the
bottom of the case, while there are two accessory shoes on the side walls to
accept the viewfinders. The tele-viewfinder should be slipped edgewise into
the shoe on the rear side wall so that the adjusting wheel is on top {fig. 7).
If the universal viewfinder is inserted there will be no space for another
finder, however.
The filters are slipped underneath the elastic ribbons in the lid of the case.
Filters
With the 30 mm and 75 mm Pantars coated Zeiss Ikon precision screw in
filters, diameter 60 mm, can be used (yellow, yel. cw-green, orange, red,
lkolor-8, lkolor-A, ultra-violet).
Lens hood for 75 mm Pantar:
A lens hood prevents irradiation in back-light exposures and protects the lens
from roan and snow. The Zeiss Ikon lens hood ((/) 60 mm) can also be screwed
into the filters. A leather case for the lens hood, available on request, can
be attached to the strap of the lens case. This lens hood should not be used,
however, with the f/4, 30 mm Panter on account of the wide angle of view of
this lens.
Maintenance of the lenses
The lenses should be cleaned only when it is absolutely necessary. Before
wiping them with a very soft linen rog, any dust must be removed by means of a
soft lens cleaning brush.
Serial numbers
Every lens unit for the Panter has a serial number engrooved on its mount. It
is strongly recommended that a record should be kept of these numbers, which
may be of valuable aid in establishing ownership in cases of loss or theft.
photographic advice
If you w9nt expect advice ask your photo-dealer who will be always gild to be’
of assistance.
Further technical developments may inv· /ve slight changes in design or
operation ol the lenses as compared with these instructions.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>