BaByliss T800E Trimmer User Manual

: June 5, 2024
: BaByliss

Table of Contents

PRODUCT FEATURES
CHARGING THE TRIMMER
USING THE CUTTING GUIDE
TURNING IT ON AND USING IT
MAINTENANCE
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

BaByliss T800E Trimmer

T800E

Please read the following instructions carefully before using the appliance.

PRODUCT FEATURES

35mm blades: · Moving blade: CMS (Chrome-Molybdenum-Stainless Steel):
• Fixed blade: stainless steel
Hair collector
1 cutting guide for 19 lengths (from 1 mm to 20 mm, in 1 mm increments)
ON/OFF switch
Power indicator light
Trimmer charging plug
Cleaning brush

CHARGING THE TRIMMER

Insert plug into appliance and connect the adapter.
Before using the trimmer for the first time, allow it to charge for 16 hours. Make sure the trimmer’s switch is in the OFF position.
Check that the charging indicator light is on.
A full charge provides a minimum of 60 minutes’ use of the trimmer.
Subsequent charges should be 8 hours.

IMPORTANT INFORMATION REGARDING THE NI-MH BATTERIES OF THIS UNIT
To obtain and maintain the longest battery life possible, allow it to charge for 16 hours approximately every three months. Moreover, full battery life of the unit will only be obtained after three complete recharge cycles (one 16-hour cycle followed by two 8-hour cycles).

USING THE CUTTING GUIDE

Ensure that the appliance is off before positioning or removing the cutting guide.
To position the cutting guide:
– slide the guide onto the trimmer head until it clicks into place (Fig.1).
– press the guide locking/unlocking button to adjust the height and then release to lock into place (Fig.2). To remove the guide:
– press the locking/unlocking button and slide the guide upwards.

TURNING IT ON AND USING IT

Operate the ON/OFF button.
You can change the cutting length at any time.

IMPORTANT! Make sure you keep the cutting guide flat against the skin. That is, the tips of the teeth and the little corners protruding from the comb should always be in contact with the skin. If not, the precision of the cut may change **(Fig. 3-4).

**

MAINTENANCE

Regular maintenance of the blades and hair collector will keep the trimmer in optimal working condition.

Removable blades

To make cleaning easier, the BaByliss trimmer blades can be removed. Make sure that the trimmer is turned off and remove the cutting guide. Hold the trimmer with the blades pointing up and remove them by pressing their points (Fig. 5).

Carefully brush the blades using the cleaning brush to remove hair. Rinse the blades. The appliance must never come into contact with water. Let the blades dry in the open air before putting them back onto the appliance.

Self-lubricating blades

The blades of the appliance have a reservoir pad for releasing the necessary amount of oil for proper operation of your appliance, time after time. Nevertheless, it is recommended that the reservoir pad be refilled occasionally when you notice performance is not as good as usual. Remove the blades as described above. Carefully squeeze a few drops of suitable oil onto the pad (Fig. 6). Then replace the blades on the appliance. It is possible to obtain replacement blades when these are worn out or damaged.

Hair collector

For best hygiene, we recommend regularly removing the hair collector for cleaning: Remove the collector by pulling the upper part (Fig. 7). Empty the collector. Rinse the collector and leave to dry in the open air before putting them back onto the appliance. To replace the collector, place the lower part of the collector in the appropriate slot and finalise by clipping the upper part into place **(Fig. 8).

**