BaByliss AS121E 1200W Multistyle Hot Air Ionic Ceramic Brush Instructions
- June 5, 2024
- BaByliss
Table of Contents
AS121E 1200W Multi style Hot Air Ionic Ceramic Brush
Instruction Manual
AS121E
Please read the safety instructions before use.
PRODUCT FEATURES
- BE LISS straightening head with Tension Control System® 4 settings: 1. waves, 2. loose curls, 3. tight curls, 4. very tight curls
- 38mm thermal brush with ceramic coating
- 20mm round boar-bristle brush
- 25mm round brush
- Power 1200W
- Ionic technology: shine and antistatic 3 speeds
- Cool air button: sets the hairstyle
- Swivel cord
- Hinged rear filter for easy maintenance and extended life of the unit.
FITTING AND REMOVING THE ATTACHMENTS
Fit the brushes and the straightening head onto the body of the unit by lining
up the guides on the two parts and then press the two together until you hear
a click.
To remove an attachment, press the unlocking buttons located on the sides of
the unit and gently pull the attachment off.
USE
The brush has 4 settings: 0 (off), I (low), II (medium), and III (high).
The low setting is ideal for fine hair, and the high setting for thicker hair.
The separate ‘cool air’ button makes it easy to use a shot of cool air at the
end of straightening or blow-drying to set the movement of each section and
give it a ‘long-lasting’ effect.
Use your hot air straightening brush on pre-dried, slightly damp hair that is
completely tangle-free.
Use clips to separate the hair so that you can work on one section at a time.
Start with the sections underneath. Sections should be a maximum of 2cm wide
and as even as possible. Always work from the roots to the tips and slide the
brush slowly down the length of the section.
THE BE LISS STRAIGHTENING HEAD
Perfect straightening and shine!
- Select the tension for your hair type using the Tension Control System® (1. waves, 2. loose curls, 3. medium curls, 4. tight curls) Fig.1
Advice from the hairstylist
- When using the straighteners for the first time, select tension setting 1 (the lowest setting) to become familiar with the BE Liss straightening head.
- Then gradually increase the setting until you find the tension that works best with your hair.
Careful! Whatever straightening you adopt, we recommend holding the tips of the section to be straightened with your free hand so that you can keep your hair evenly distributed between the teeth of the straightening head. And before each stroke make sure the thin section is properly positioned with the roots at the base of the comb, then slowly and steadily slide the unit down the length of hair while holding the tips with your free hand. Fig.2
THE 38MM THERMAL BRUSH WITH CERAMIC COATING FOR PERFECT GLIDE AND TO OFFER
YOUR HAIR BETTER PROTECTION
The combination ‘brush/hair dryer’ will revolutionize your blow drying!
This ideal diameter, recommended by BaByliss, creates a smooth movement and
adds body to your hair without tangling it and for the best blow-dry results
for hair full of softness.
The hot air of the unit heats the metal barrel of the attachment.
The heat is thus distributed directly over your hair making it soft and
smooth.
THE 20MM ROUND BOAR-BRISTLE BRUSH
This size is more specially suited for the finishing touches: this brush will
accentuate the shaping of certain sections like the fringe, the tips or the
roots.
The use can also vary according to the length of your hair:
- on short hair, it can be used horizontally, like the thermal brush, for gentle and natural blow-drying with the ends flicked out or turned under
- on long hair, it can be used vertically for a spiral curl effect at the tips
THE ROUND STYLING BRUSH
This brush can be used on dry or damp hair and is perfect for curling and
adding body to your hair!
Take up a section of hair, brush it from the roots to the tips with the brush
then coil the hair around it. Hold for 15 to 20 seconds depending on the
thickness of the section. Let the hair cool before combing it out.
MAINTENANCE OF THE UNIT
- Unplug the unit and allow it to cool completely before cleaning or storing.
- We advise you to clean the straightening head and brushes regularly to avoid build-up of hair, styling products, etc. Use a comb to remove hair from the brushes. Use a dry or very slightly damp cloth for the plastic and ceramic surfaces.
BABYLISS
99 avenue Aristide Briand – 92120 Montrouge – France
www.babyliss.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>