HYUNDAI RT 910 RIP TURNTABLE wITh STEREO RADIO RECEIVER Instruction Manual

HYUNDAI RT 910 RIP TURNTABLE wITh STEREO RADIO RECEIVER

WARNING:

TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE THE COVER. PILOT LAMPS SOLDERED IN PLACE. NO USER- SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL

Danger:

The lightning flash with the arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated „dangerous voltage“ within the product‘s enclosure that may be of sufficient magnitude to constitute risk of electric shock to persons.

Note:

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

SPECIFICATION

• Power Source: AC 230V ~ 50Hz
• Power Consumption: 8W
• Frequency Range: AM 540 – 1600 KHz
• FM 88 – 108 MHz
• Speed: 33/ 45/ 78 RPM
• Speaker: 70 mm x 30 mm x 2 mm
• Unit Dimension: 40,5 (L) x 30,5 (W) x 11,5 (H) cm
• Weight (NETTO): 4.3 Kg

We reserve the right to change technical specifications.

IMPORTANT SAfEGUARDS fOR AUDIO PRODUCTS

1. Read Instructions – All the safety and operating instruction should be read before the product is operated.
2. Retain Instructions – The safety and operating instruction should be retained for future reference.
3. Heed Warnings – All warnings on the product and in the operating instructions should be adhered to.
4. Follow Instructions – All operating and use instructions should be followed.
5. Cleaning – Unplug this product from the wall outlet before cleaning.
6. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. Attachments – Do not use attachments not recommended by the product manufacturer as they may cause hazards.
7. Water and Moisture – Do not use this product near water – for example, near a bath tub, wash bowl, kitchen sink, or laundry tub; or in a wet basement, or near a swimming pool, and the like.
8. Accessories – Do not place this product on an unstable cart, stand tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand tripod, bracket, or table recommended by the manufacturer or sold with the product. Any mounting of the product should follow the manufacturer’s instructions and should use a mounting accessory recommended by the manufacturer
9. Ventilation – Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or another similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s instructions have been adhered to.
10. Power Sources – This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company. For products intended to operate from battery power, or other sources, refer to the operating instruction.
11. Grounding or Polarization – This product may be equipped with a polarized alternating-current line plug ( a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.
12. Alternate Warnings – This product is equipped with a three-wire grounding type plug, a plug having a third (grounding) pin. This plug will only fit into a grounding-type power outlet. This is a safety feature. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the grounding type plug.
13. Power Cord Protection – Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and point where they exit from the product.
14. Protective Attachment Plug – The product is equipped with an attachment plug having overload protection. This is a safety feature. See Instruction Manual for replacement or resetting of protective device. If replacement of the plug is required, be sure the service technician has used a replacement plug specified by the manufacturer that has the same overload protection as the original plug.
15. Lightning – For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges.
16. Power Lines – An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. Overloading – Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock.
17. Object and Liquid Entry – Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.
18. Servicing – Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
19. Damage Requiring Service – Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:
20. When the power supply cord or plug is damaged,
21. If liquid has been spilled, or objects have fallen into the product,
22. If the product has been exposed to rain or water,
23. If the product does not operate normally by following the operating instructions.  Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.
24. If the product has been dropped or damaged in any way, and
25. When the product exhibits a distinct change in performance – this indicates a need for service.
26. Replacement Parts – When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.
27. Safety Check – Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.
28. Heat – The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

POWER SOURCE

1. Unwind the AC POWER CORD (16) at the back of the unit and connect it to a power outlet.
2. Plug the A/C cord into an appropriate outlet.

UNPACKING The TURNTABLE

1. Carefully remove the unit from its package and take it out of the plastic bag.
2. Open the lid and remove the black tie-wrap by untwisting and gently sliding out from under TONE ARM (10).
3. Remove the white protective needle cover by gently pulling towards the front of the unit.

TURNTABLE OPERATION

1. Turn the unit on by pressing the POWER SWITCH (6) at the side of the unit, to the “O“ position. The power indicator (5) at the front of the unit will light up.
2. Turn the FUNCTION SWITCH (2) to PHONO mode.
3. Move the SPEED CONTROL SWITCH (11) to the desired speed, select from 33, 45 or 78 rpm. Place the record on the turntable (8).
4. Adjust the VOLUME CONTROL (4) and set this at mid-range.
5. Use a finger to raise the tone arm (10) off its rest. Move the tone arm over the record and gently release the tonearm to the point where you want to play the record.
6. Adjust the VOLUME CONTROL CNOB (4) to your desired sound level.
7. At the end of the record, the TONEARM (10) will stop automatically at the center. The TONE ARM (10) has to be returned manually to the ARM REST (12).

RADIO OPERATION

1. Turn the unit on by pressing the POWER SWITCH (6) at the side of the unit, to the “O“ position. The power indicator (5) at the front of the unit will light up.
2. Turn the Function Switch (2) to enter Radio mode, and use AM/FM band switch (16) to select either AM or FM frequency position.
3. Turn the TUNING KNOB (12) to select your desired position.
4. Adjust the VOLUM CONTROL KNOB (4) to your desired sound level.
5. Turn the unit off by pressing the POWER SWITCH (6) at the side of the unit, to the “I“ position.

FUNCTION AND OPERATION fOR USB

1. Turn the Function Switch (2) to the USB position at the front panel.  The USB led light indicator will light up and enter USB mode.
2. Insert the USB Flash into the USB 2.0 Port (9). Press the “Play/Pause“ button (7) for playback. The ACC Green Led light indicator will light up. Press the “Play/Pause“ button (7) again to pause mode. The ACC Green Led light indicator will flash again in around 1 second. Repeat these steps to select playback or pause mode.
3. Press “Next Button“ (11) to skip to the next song. Press “Back Button“ (10) to reverse to the previous song. Press and hold the “Next“ or “Back“ Button for fast forward and Rewind respectively.
4. “USB POWER“ Button (12): When the function is in Phono or Radio or Line-in mode, press the USB Power Button (12), and the USB led light indicator will light up and will enter recording mode. (If you do not need to use the  recording function while in the Radio mode, we suggest you turn off the USB Power Button (12) in order to avoid any distortion to achieve better radio reception.)
5. “Delete“ Button (13): This delete function is only applies to the track that it is currently under playback. Once deleted the current track, will automatically into stop mode. You need to press the Play/Pause Button (7) again to enter the next track. (When a record is completed, you must go to playback mode in order to delete tracks. Repeat Step 5 to operate the delete function)
6. Recording Button:
7. When the function is in Phono or Radio or Line-in mode, press the USB Power Button (12). Press “Record Button“ (14) once to start the record function. Also, The ACC led light indicator will be flash in red color. Press “Record Button“ (14) one more time to stop recording. Repeat these steps for rotation. (Remark: Do not suggest pressing the “Record Button“ (14) continuously for a short period of time).
8. If the Function Switch (2) to USB position, the USB Led light indicator will light up. Press “Record Button“ (14) and also be able to enter the recording function (if there is an SD card, they will be able to record each other).
9. During recording, the „Play/Next/Back/Delete“ Button is unable to operate.

LINE-OUT JACK OPERATION

1. Connect the RCA Line-out Jack (24/55) into the external amplifier to play the music from an outside source.

LINE IN OPERATION

1. Turn the unit on by pressing the power switch (6) to connect the music source you want to play with the Line-in jack (23), then you can use the unit to play the connected music source.

ACCESSORY: ADAPTER FOR 45 RPM
To play a 45 rpm record, place the supplied adaptor (9) on the SPINDLE (7)

TROUBLEShOOTING GUIDE

The unit will not operate.

• Check that the unit is properly connected to an A/C power outlet.

No sound is coming from the unit

• Check that the ON/OFF VOLUME KNOB (4) and see the volume level..
• The white protective needle cover has not been removed from the tone arm.

The tonearm will not move

• Remove black tie wrap from the tone arm.
• The tonearm hold-down clip has not been released.

No Radio

1. The FUNCTION SWITCH (13) has not been moved from the PHONO position.
2. Adjust the ON/OFF VOLUME KNOB (4) and see the volume level.
3. Rotate the TUNING KNOB (3) to find the desired radio station.

LOCATION Of PARTS

1. Speaker
2. Function switch (Radio/Phono/USB) Knob Tuning Knob
3. Volume Control Knob
4. Power Led Indicator
5. Power Switch
6. Play/Pause Button
7. Playback/Pause/Recording Light Indicator USB 2.0 Port
8. Back Button
9. Next Button
10. USB Power and Record ON/OFF Button Delete Button
11. Record Button
12. USB Led Indicator
13. Am/Fm Band Switch
14. Spindle
15. Turntable
16. Adaptor for 45 rpm records
17. Tone Arm
18. Speed Control Switch (33, 45, 78 rpm) Security Hook/Arm Rest
19. Line In
20. RCA line-out jack – right channel
21. RCA line-out jack – left channel
22. AC power plug cord

WARNING: Do not use this product near water, in wet areas to avoid fire or injury of electric current. Always turn off the product when you don’t use it or before a revision. There aren’t any parts in this appliance that are reparable by consumers. Always appeal to a qualified authorized service. The product is under dangerous tension.

Disposal

Old electrical appliances used batteries, and accumulators disposal

This symbol appears on the product, on the product accessories, or on the product packing means that the product must not be disposed of as household waste. When the product/ battery durability is over, please, deliver the product or battery (if it is enclosed) to the respective collection point, where the electrical appliances or batteries will be recycled. The places, where the used electrical appliances are collected, exist in the European Union and in other European countries as well. By proper disposal of the product, you can prevent possible negative impacts on the environment and human health, which might otherwise occur as a consequence of improper manipulation with the product or battery/ accumulator. Recycling of materials contributes to the protection of natural resources. Therefore, please, do not throw the old electrical appliances and batteries/ accumulators in the household waste. Information, about where it is possible to leave the old electrical appliances for free, is provided at your local authority, at the store where you have bought the product. Information, on where you can leave the batteries and accumulators for free, is provided to you at the store, at your local authority.

References

• ASEKOL
• Úvod - ECOBAT
• Hyundai Electronics– Hyundai CZ

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>