Havit Lighting HV2882-SLV Elite Deck or inground light Installation Guide

: June 5, 2024
: Havit Lighting

Table of Contents

Product Specifications
Important Safety Issues:
Steps for Installation:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Elite Deck or Inground Light Installation Instructions

Product Specifications

Model No.| HV2881W-SLV| HV2881N-SLV| HV2881C-SLV| HV2881W-BLK| HV2881N-BLK| HV2881C-BLK| HV2882W-SLV| HV2882N-SLV| HV2882C-SLV| HV2882W-BLK| HV2882N-BLK| HV2882C-BLK
---|---|---|---|---|---|---|---|---|---|---|---|---
Name| Elite| Elite
Material| Aluminum| Aluminum
Colour| Silver| Black| Silver| Black
IP Rating| IP65| IP65
Input Voltage| 12v DC| 12v DC
Lamp Base| Built-in LED| Built-in LED
Lamp Wattage| 1x 3w| 1x 5w
Colour Temp| 3000k| 4000k| 5500k| 3000k| 4000k| 5500k| 3000k| 4000k| 5500k| 3000k| 4000k| 5500k
Lumens| 240lm| 250lm| 270lm| 240lm| 250lm| 270lm| 400lm| 420lm| 450lm| 400lm| 420lm| 450lm
CRI| > 80| > 80
Wiring| Parallel| Parallel
Dimmable| Yes – Triac| Yes – Triac
Warranty| 3 Years Replacement| 3 Years Replacement

Important Safety Issues:

This product must be installed by a qualified electrician according to AS/NZS 3000.
Ensure all electrical mains are disconnected before any installation.
Modification of this product will void any warranty.
Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
Aluminum and 304SS fittings must not be installed within 5km of any saltwater environments.
All o-rings and seals must be in place correctly to maintain the warranty.
These instructions may be updated at any time due to product improvements, Please visit the website for the most current installation instructions.

HV2881 Dimensions	HV2882 Dimensions
Sample Wiring Diagram	Sample Adequate Drainage Diagram

Steps for Installation:

Make sure that the electrical circuit is free of voltage (master switch off)
Make a hole where the fitting is to be placed using dimensions provided on line drawings, making sure adequate drainage is allowed.
Using an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
If installing into concrete, insert canister making sure it is flush with ground level.
Connect the cable – If more than one fitting is installed, wiring must be done in parallel.
Strip back the cable on both fitting and cable run and twist the positive cables together. Then connect neutral cables together
Solder all joins using solder and either a heat gun or butane gas torch.
Cover connections using an adhesive-lined heat shrink or gel cap to make the connection watertight. Failure to do this will void the warranty.
Heat the heat shrink or crimp the gel cap making sure all connections are covered.
Insert fitting into hole or canister
Apply silicone around the edge of the fitting to prevent any water from getting inside to electrical connections.
All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.