Neomounts NM-D775DXWHITE Monitor desk mount Instruction Manual

: June 5, 2024
: Neomounts

Table of Contents

PARTS
Clamp
Grommet
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SELECT

INSTRUCTION MANUAL
NM-D775DXWHITE

Monitor desk mount

PARTS

Clamp

STEP 1
Install the clamp to the desk – for desktop thickness between 10-45 mm

Grommet

STEP 1
Install the grommet through the desk – for desktop thickness between 10-45 mm

STEP 2
Attach the lower arm to the base

STEP 3
Attach the upper arm to the lower arm

STEP 4
Attach the cross bar to the upper arm

STEP 5
Do not tighten the screws completely to allow the selfbalancing head to self- align and to be able to adjust the mount during use

STEP 6
Attach the handle to the upper arm

STEP 7
Attach the VESA plates to the screens – Note: Do not tighten/loosen the screw in the middle of the VESA plate

STEP 8
Install the monitors

STEP 9
Adjust the gas spring

STEP 10
Remove the cable cover

STEP 11
Run cable through the cable cover

STEP 12
For correct horizontal alignment, position the screens in the exact middle of the crossbar and place the monitor arm to the left side

STEP 13
Adjust the mount to your desired position and loosen or tighten the screws if necessary

CAUTION

To ensure safety, please read this manual carefully before installation and follow the instructions. Store this manual in a secure place for future reference.
The manufacturer shall not be legally responsible for any equipment damage or personal injury caused by incorrect installation or operation other than that covered in this manual.
The mount is designed for easy installation and removal. The manufacturer shall not be liable for damage to equipment or personal injuries arising out of human factors or acts of nature, such as earthquake or typhoon.
It is recommended that the mount be installed by qualified personnel only.
At least two persons are needed to install or remove the product to avoid hazard of falling objects.
Please carefully inspect the area where the mount is to be installed:
• Avoid places that are subject to high temperatures, humidity, or contact with water.
• Do not install the product near air conditioning vents or areas with excess dust and fumes.
• Only install on vertical walls and avoid slanted surfaces.
• Do not install in places subject to any shock or vibration.
• Do not install in places subject to direct exposure to bright light, as it may cause eye fatigue when viewing the display panel.
Maintain sufficient space around the display to ensure adequate ventilation.
To ensure safe installation, first check the structure of the wall, ceiling, or floor and select a secure mounting location.
The wall, ceiling or floor should be strong enough to sustain a weight of at least four times of the display and mount combined. The mounting location must be able to withstand earhquake or other strong shock.
Do not modify any accessories or use broken parts. Contact your dealer with any questions.
Tighten all screws (do not exert excessive force to avoid breaking the screw or damaging its thread).
Drill holes and bolts will be left in the wall, ceiling or floor once the display and bracket are removed. Stains may occur after extended use.
Since the manufacturer has no way to control the wall, ceiling or floor type and installation of the mount, the warranty of the product shall only cover the body of the mount. The warranty period of the product is 5 years.
Please consult the English language manual for any dispute on conditions.