BaByliss 700w-pro rotating Brush User Manual
- June 5, 2024
- BaByliss
Table of Contents
BaByliss 700w-pro rotating Brush
Instructions
AS531E
Read the safety instructions first.
FEATURES
- 35 mm round boar-bristle brush
- 700W power
- 2 temperature settings + ‘cool-air’ setting
- Two-way rotation
- Swivel cord
- Hinged rear filter for easy maintenance and extended life of the unit.
INSTRUCTIONS FOR USE
- After shampooing your hair, towel dry and untangle it carefully with a large-toothed comb.
- Always start untangling your wet hair at the tips, then gradually work your way up. Gentle untangling prevents split ends from forming.
- Use your hot-air brush on pre-dried, slightly damp hair that is completely tangle free.
- Use clips to separate hair so that you can work on one section at a time. Start with the sections underneath. Sections should be a maximum of 2 cm wide and as even as possible.
Two-way rotation
To roll the section of hair around the rotating head automatically, press the
button for the desired direction (right or left) and hold throughout the blow-
drying. The right or left rotation corresponds to the handling as well as to
the desired effect of blow-drying under or out. To stop rotating, release the
button.
Using the rotating brush
- To prepare the section and to untangle, lift the roots of the small section and straighten the section, with the unit set to hot, in one or two strokes but without turning the brush; (1)
- Hold the section of hair at a 90° angle to your head so that the hair underneath doesn’t get tangled; (2)
- Slide the brush over the section while turning the brush, but not completely, repeat several times while sliding the brush from the roots to the tips; (3)
- Finish with a full turn of the section around the brush from roots to tips, hold a few seconds so that the section is completely heated and shaped and so that the roots are lifted; (4)
- Repeat the operation if necessary, according to your hair type;
- Don’t forget the shot of cool air at the end for a long-lasting set. To do this, use the cool-air setting without turning the rotating head.
Blow-drying outwards
Place the brush under the section at the tips of your hair, and start the
automatic rotation to turn outwards. (5) + (6)
Blow-drying under
Place the brush under the section at the tips of your hair, and start the
automatic rotation to turn under. (7) + (8)
MAINTENANCE OF THE UNIT
- Unplug the unit and allow to cool completely before cleaning or storing.
- We advise you clean the brush regularly to avoid build-up of hair, styling products, etc. Use a comb to remove hair from the brush. Use a dry or very slightly damp cloth for the plastic surfaces.
- Warning: when you have finished using the rotating head, do not place it, as is, on the support, you risk damaging and bending the bristles. Store it in the case intended for this purpose.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>