GKOLED GKOFD08 Series LED Flood Light with Yoke Mount Installation Guide
- June 5, 2024
- GKOLED
Table of Contents
GKOLED GKOFD08 Series LED Flood Light with Yoke Mount
WARNING
PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
-
To prevent personal injury or product damage only licensed electricians should install.
-
To avoid electric shock or component damage disconnect power before attempting installation or servicing.
-
This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state and local electric codes and safety standards.
-
Disconnect product and allow cooling prior to servicing.
-
Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage and/or product malfunction.
-
To prevent product malfunction and/or electrical shock this product must be properly grounded.
-
LIMIT RANGE OF ADJUSTMENT TO. – Suitable for operation in ambient temperatures ranging from -40°c to 45°c.
-
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product
and the hazards involved. -
In 75°c supply conductors.
-
Suitable for mounting within 1.2 m (4 ft) of the ground
-
This product is not available for several special environments, such as places with corrosive gas liquids or high pressure water vapor.
1/2″ NPS Knuckle Mount
- Thread knuckle into the 1/2″ NPS hole and secure it with 1/2″ locknut.
- Make electrical connections from the supply ground (L/N) lead to fixture ground (L/N) lead respectively, making sure to follow all National Electrical Code and all applicable local codes and ordinances.
- Aim fixture by loosening screw on knuckle of fitter and rotating fixture to desired tilt angle. Re-tighten screw.
- While making electrical connections, ensuring water does not enter fixture through 1/2″ fitter. 5. Installation and service of luminaires should be performed by a qualified licensed electrician.
Trunnion Mounting
- Mount fixture onto surface using the hole pattern provided on the trunnion bracket.
- Make electrical connections from the supply ground (L/N) lead to fixture ground (L/N) lead respectively, making sure to follow all National Electrical Code and all applicable local codes and ordinances.
- Aim fixture by loosening screw on knuckle of fitter and rotating fixture to desired tilt angle. Re-tighten screw.
- While making electrical connections, ensuring water does not enter fixture through 1/2″ fitter.
- Installation and service of luminaires should be performed by a qualified licensed electrician.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>