GKOLED GKOHB06 Series 215W Tunable Circular High Bay Installation Guide
- June 9, 2024
- GKOLED
Table of Contents
GKOLED GKOHB06 Series 215W Tunable Circular High Bay
WARNING
PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
-
To prevent personal injury or product damage only licensed electricians should install.
-
To avoid electric shock or component damage disconnect power before attempting installation or servicing.
-
This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state and local electric codes and safety standards.
-
Disconnect product and allow cooling prior to servicing.
-
Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage and/or product malfunction.
-
To prevent product malfunction and/or electrical shock this product must be properly grounded.
-
This luminaire is designed to operate in ambient temperatures ranging from -40°F to 113°F (-40°C to 45°C) and to be horizontally mounted with the LEDs facing down.
-
This product must be installed in accordance with the applicable installation code by a Person familiar with the construction and operation of the product and
the hazards involved. -
MIN 167°F (75°C) SUPPLY CONDUCTORS
-
This product is not suitable for several special environments, such as places with corrosive gas liquids or high pressure water vapor.
Installation Guide
- Tightly screw the hook into the M10 hole on the top of the fixture.
- Tighten the M4x8 screw to secure the hook.
- Make electrical connections according to the wiring diagram.
Adjustable Surface Mounting Bracket
- Secure the mounting bracket to the surface, adjust to the desired angle, and lock the angle adjustment screw.
- Make electrical connections according to the wiring diagram.
Power & CCT Adjustment Controls
Remove the screw plug at the bottom of the fixture, adjust the dial switch to the desired power level and color temperature to match the application requirements, then reinstall the screw plug as demonstrated below:
Multi-Level Motion Sensor
To install the sensor, remove the screw plug in the middle of the fixture, insert the sensor and tighten clockwise, as demonstrated below:
WIRING DIAGRAM
Note: 2 dimming wires are in the driver box.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>