GKOLED GKOHB06180W27V50KB Circular High Bay Installation Guide

CIRCULAR HIGH BAY
Installation Guide

WARNING

PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION

• To prevent personal injury or product damage only licensed electricians should install.

• To avoid electric shock or component damage, disconnect power before attempting installation or servicing.

• This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state, and local electric codes and safety standards.

• Disconnect product and allow cooling prior to servicing.

• Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage, and/or product malfunction.

• To prevent product malfunction and/or electrical shock this product must be properly grounded.

• This luminaire is designed to operate in ambient temperatures ranging from -40°C to 50°C and to be horizontally mounted with the LEDs facing down.

• This product must be installed in accordance with the applicable installation code by a Person familiar with the construction and operation of the product and
  the hazards involved.

• In 75°c supply conductors.

• This product is not suitable for several special environments, such as places with corrosive gas liquids or high-pressure water vapor

Installation Guide

Hook Installation

1. Remove the line cord protector before installation.
2. Take the hook from the accessory packet and thread the power cord through the hole in the hook, while ensuring the gasket is kept inside the hole of the fixture for a waterproof seal.
3. Tightly thread the hook into the 3/4″ hole in the fixture.
4. Thread the hook onto the desired place, then tighten the screw to lock the hook in place.
5. Connect the wiring according to the wiring diagram.
   

Pendant Mounting With 3/4″ Conduit (Not Included)

1. Remove the line cord protector before installation.
2. Tightly thread the LED luminaire onto the ¾” NPT conduit, then secure the M4x8 screw.
3. Connect the wiring according to the wiring diagram.
4. Caulk the conduit openings such as sealing kits, to ensure that moisture does not enter the fixture through the ¾” NPT conduit.
5. Use silicone rubber to ensure water does not enter the fixture through the 1/2″ fitter.

Wire Connection

Note: Two dimming wires in the driver box

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>