Philips HR2721 Grinder 50 Hz Stainless Steel Plastic User Manual

June 5, 2024
Philips

Philips HR2721 Grinder 50 Hz Stainless Steel Plastic User Manual

Important

Read these instructions for use carefully before using the appliance and save them for future reference.

Danger

  • Do not immerse the motor unit in water nor rinse it under the tap.
  • Do not connect the appliance to a timer switch.

Warning

  • Always switch off the appliance and disconnect from the supply if it is left unattended and before assembling, disassembling, cleaning, changing accessories or approaching parts that move in use.
  • Before you connect the appliance to the power, make sure that the voltage indicated on the bottom of the appliance corresponds to the local power voltage.
  • If the power cord, the plug, or other parts are damaged, do not use the appliance.
  • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
  • Appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved.
  • Be very careful when you handle the cutter, especially when you remove it from the worm shaft and during cleaning. The cutting edges are very sharp!
  • Do not use your fingers or an object (e.g. a spatula) to push ingredients into the hopper while the appliance is running. Only the pushers are to be used for this purpose.
  • Do not insert your fingers in the metal drum while the appliance is running.
  • Make sure you fully assemble and lock the hopper before putting in the worm shaft, blade and screen into the hopper.
  • This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
  • Children shall not play with the appliance.
  • Do not use the appliance if the rotating sieve or the protecting cover is damaged or has visible cracks

Caution

  • The appliance is intended for household use only.
  • Before you connect the appliance to the mains, make sure that the appliance is assembled correctly.
  • Never use any accessories or parts from other manufacturers or that Philips does not specifically recommend. If you use such accessories or parts, your guarantee becomes invalid.
  • Always switch the appliance off by pressing the O/I button.
  • Do not let the appliance run unattended.
  • Do not exceed the maximum operating time of 5 minutes at all applications.
  • Let the appliance cool down to room temperature before next operation.
  • In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
  • Noise level: Lc = 89 dB [A]

Safety system

This appliance is equipped with overheat protection. If the appliance overheats, it switches off automatically. Unplug the appliance and let it cool down until room temperature. Then, put the mains plug back into the power outlet and switch on the appliance again. Please contact your Philips dealer or an authorized Philips service center if the overheat protection is activated too often.

The appliance is also equipped with mechanical protection. To protect the motor, the plastic gear has been designed to break if bones or utensils are fed into the appliance. When this happens, simply remove the gear and exchange it.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today.

Recycling

Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When you see the crossed-out wheel bin symbol attached to a product, it  means the product is covered by the European Directive 2002/96/EC: Never dispose of your product with other household waste. Please inform yourself about the local rules on the separate collection of electrical and electronic products. The correct disposal of your old product helps prevent potentially negative consequences on the environment and human health.

Introduction

Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com. With this product, you can

  • mince meat
  • make sausages
  • make kebbe
  • cut vegetables and grate cheese

Tip

For more recipes, go to www.kitchen.philips.com.

What’s in the box

  1. Hopper release button

    • Press and hold it when you remove the hopper.
  2. Motor unit

  3. O/l
    Switch off or on the appliance.

  4. Handle

  5. Metal hopper

  6. Worm shaft

  7. Cutter/Knife

  8. Grinding discs

    • A : Coarse grinding disc (diameter of 8 mm)
    • B : Fine grinding disc (diameter of 5 mm)
  9. Screw ring

  10. Sausage horns

    • A: Large sausage horn (diameter of 22 mm)
    • B: Small sausage horn (diameter of 12 mm)
  11. Sausage separator

  12. Kebbe maker

    • A: Kebbe separator
    • B: Kebbe shaper
  13. Innovative cleaning too

  14. Pusher for the plastic hopper

  15. Plastic hopper

  16. Metal drums

    • A: Coarse grater drum
    • B: Slicer drum
  17. Pusher for the metal hopper

  18. Feeding tray

Before first use

Before you use the appliance and accessories for the first time, thoroughly clean the parts that come into contact with food. (See “Cleaning” in Fig. 5 and Fig. 6).

Mince meat

Before you start, make sure you assemble according to Fig. 2-1.
Mince meat

Mince meat (Fig. 3-1)
Mince meat

Note

  • Never grind bones, nuts, or other hard items.
  • Never use frozen meat! Before you grind the meat, defrost it first.
  • Do not overload the appliance by pushing too much meat into the hopper.
  • You can select the appropriate grinding disk for the preferred granularity of minced meat. You can also grind more than once for finer texture.

Tip

  • Remove bones, gristle, and sinews out of the meat as much as possible.
  • Before your make sausages, mince the meat first. (refer to “Make sausages”)
  • If the hopper is stuck, switch off the appliance and disassemble the hopper from the motor unit. Then remove the stuck stuff from the hopper.

Make sausages

Before you start, make sure you assemble according to Fig.2-2.

Make sausages (Fig. 3-2)
Make sausages

Note

  • Make sure that the projections on the hopper align with the notches of the motor.
  • Do not block the air outlet grooves of the sausage horn.
  • Do not make the sausages too thick in case the sausage skin is overstretched.
  • Keep the sausage skin wet to prevent it from sticking on the sausage horn.
Recipe

Sausages

Ingredients:

  • 4,500 g ground pork
  • 5 Tbsp. of salt
  • 1 Tbsp. of ground white pepper
  • 2 Tbsp. of rubbed sage
  • 1 tsp. of ginger
  • 1 Tbsp. of nutmeg
  • 1 Tbsp. of thyme
  • 470 ml ice water
  • 1 Tbsp. of ground hot red pepper

Directions

  1. Mince the meat with the coarse grinding disc.
  2. Thoroughly mix the minced meat and other ingredients.
  3. Follow the instructions above to make your own sausages.

Make kebbe

Before you start, make sure you assemble according to Fig. 2-3.
Make kebbe

Make kebbe (Fig. 3-3)

Recipe

Kebbe’

Yield: 5-8 servings

Ingredients: ‘

Outer casing

  • 500 g lamb or fat-free mutton, cut into strips
  • 500 g bulgur wheat, washed and drained
  • 1 small onion

Filling

  • 400 g lamb, cut into strips
  • 15 ml oil
  • 2 medium onions, finely chopped
  • 5-10 ml ground allspice
  • 15 ml plain flour
  • salt and pepper

Directions

Outer casing

  1. Mince the meat, wheat, and onion together with the fine grinding disc.
  2. Thoroughly mix the minced ingredients, and then mince the mixture twice again.
  3. Use the kebbe maker to shape the mixture into kebbe casing

Filling

  1. Mince the meat with the fine grinding disc.
  2. Fry the onion chops until they turn golden brown.
  3. Add the minced meat and other ingredients in, and then cook for 1-2 minutes.
  4. Drain off excessive fat and cool the filling down.

Cooking

  1. Push some filling into the outer casing, and then pinch both ends to seal it.
  2. Heat the oil for deep frying (190°C).
  3. Deep fry the kebbe for 3-4 minutes, or until it turns golden brown.

Cut vegetables

Before you start, make sure you assemble according to Fig. 2-4.
Cut vegetables

Cut vegetables (Fig. 2-4)
Cut vegetables

Fig. 4 indicates the foods that each drum is applicable to and the cutting shapes.
Food drum

**Note**

Only use the plastic hopper in combination with the metal drums and the pusher for plastic hopper.

Tip

  • You can also grate cheese.
  • When processing apples, peel off the skin for best results.

Cleaning and maintenance

Cleaning
Fig. 5

Fig. 6

  • Before you remove accessories or clean the motor unit, switch off and unplug the appliance.
  • Do not immerse the motor unit in water nor rinse it under the tap.
  • Do not clean the metal parts in a dishwasher.
  • Clean the main unit with a moist cloth.
  • Pass pieces of bread through the hopper to remove any meat left.
  • Wash removable parts with a soft brush in soapy water, rinse them with clear water, and then dry them with soft cloth or tissues immediately.
  • Lightly brush the metal parts with fat or oil to prevent rusting.

Note

  • Use the innovative cleaning tool to remove the remains stuck in the grinding discs. rinse them with clear water, and then dry them with soft cloth or tissues immediately

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals