hobbytech 8.BXR-S2.KIT Combo Brushless Buggy Instruction Manual

INSTRUCTION MANUAL

BXR-S2.KIT VERSION

Item # 8.BXR-S2.KIt
• This is not a toy! Not suitable for children under 14 years old without adult supervision.

RECOMMENDED TOOLS (NOT PROVIDED)

ITEMS REQUIRED (NOT PROVIDED)

HARDWARE LIST

Real size elements: Put the item to compare and check its size and prevent from mistakes!

90 DAYS WARRANTY AND SERVICE INFORMATIONS

COMPONENT WARRANTY PERIOD
PLEASE READ THE FOLLOWING INFORMATION CAREFULLY !
Please note this is a high-quality hobby product and not a toy. Therefore, it is necessary that children under 14 years are supervised by an adult. The guardians and / or parents have the responsibility to provide the appropriate guidance and supervision of the minors .
This product has a 90 day warranty, which is only guaranteed to the original purchaser. The warranty valid only to products that have been purchased from an authorized Hobbytech dealer. Warranty claims will be processed only with a valid proof of purchase / receipts. If within the warranty period, a portion of the product fails due to manufacturing defects, then it is within the discretion of Hobbytech to repair it or replace it. The decision to repair or replace the part will be taken by Hobbytech. After use, we do not offer new for old warranty.

WARRANTY DISCLAIMER
This high performance model was made with highest attention and care and should be treated with respect. Excluded from the warranty are components that have been damaged by wrong installation, mishandling, accident, operation, maintenance, lack of maintenance and care, as well as abuse and / or repair attempts. Furthermore excluded from the guarantee are wearing parts such as fuses and batteries, visual impairments, shipping -, transport costs.
WARRANTY CLAIM
Please contact your dealer with the warranty claim and / or repair. Your dealer and Hobbytech will make an proper decision that will help you as soon as possible. For invalid warranty claims you may be charged for the processing costs before the parts are returned. All repairs which are necessary by negligence or abuse are bill in advance. In case you decide that you not want to repair your product then Hobbytech editing and reserves the right to charge shipping costs .

IMPORTANT – READ THIS BEFORE RUNNING

PLEASE READ ALL INSTRUCTIONS AND FAMILIARIZE YOURSELF WITH THE PRODUCTS AND CONTROL BEFORE OPERATION.
This product is not a toy. It is a high performance model product. It is important to familiarize yourself with the model, its manual, and its construction before assembly and operation. Adult supervision is necessary

CAUTION
To avoid serious personal injury and property damage, operate all remotely controlled models in a responsive manner as out- lined below.
R/C car models can exceed speeds of 70km/h (43mph), and cannot be stopped quickly.

1. Never run R/C models on the street or highways, as it could cause or contribute to serious traffic accidents.
2. Never run an R/C model near people or animals, nor use people or animals as obstacles when operation R/C vehicles.
3. To avoid injury to persons or animals, and damage to property, never run a R/C model in a confined or crowed area.
4. Running R/C models into furniture or other inanimate objects will cause damage to the objects and the R/C models.

CAUTION DURING OPERATIONS

When the R/C model is in operation, dot not touch any of its moving parts, such as drive shafts, wheels, as the rotating parts can cause serious injury.

1. The vehicle motor gets very hot during running and could cause burns if touched.
2. Make sure that no one else is using the same frequency as yours in your running area. Using the same frequency at the same time, whether is driving, flying or sailing, can cause loss of control of the R/C models, resulting in serious accidents.
3. Properly connect plugs. To prevent electrical shock and/or damage to the product resulting from a short-circuit: insulate connections with heat shrink tubing or electrical tape. Before running vehicle, check that battery wiring and plugs are not so loose as to drag on the ground. Properly secure cables using electrical tape or nylon tie-wraps.
4. Stiff rotation of gears, shafts, joints and wheels can burn out the motor. It’s recommended to check proper joint and shaft rotation by using one 1,5V dry cell during assembly of the model. A worn motor will overheat and result in a short running time. Replace a worn out motor as soon as possible.
5. R/C models will run out of control when either the receiver or transmitter battery voltage drops off. Stop the vehicle immediately when the car starts to show down to prevent it from running out of control.

SAFETY PRECAUTIONS

Follow the outlined rules for safe radio control operation.
Avoid running the car in crowed area and near small children.
Make sure that no one else is using the same frequency in your running area. Using the same frequency at the same time can cause serious accidents, whether it’s driving, flying or sailing.
Avoid running in standing water and rain. If R/C unit, motor, or battery get wet, clean and dry throughly in a dry shaded area.
R/C operating procedures
❶ Make sure the transmitter controls and trims are in neutral. Switch on transmitter.
❷ Switch on receiver.
❸ Inspect operation using transmitter before running.
❹ Adjust steering servo and trim so that the model runs straight with transmitter in neutral.
❺ Reverse sequence to shut down after running.
❻ Make sure to disconnect/remove all batteries.
❼ Completely remove sand, mud, dirt etc
❽ Store the car and batteries separately when not in use

FRONT & REAR DIFFERENTIAL ASSEMBLY

(H/S/M)
HTR570720| 95mm  BIG BORE 13mm Fully alum. adjustable shocks +3 springs (H/S/M)
REV-003| L/R Front C-hub
REV-004| C-Hub Pin
REV-010| Lower suspension hinge
REV-014| Shock cap bushing
REV-015| Steering servo saver post
REV-016| Servo saver arm bushing
REV-024| Ball stud
REV-025| Rear drive shaft BX10
REV-026| C-Hub Screw
REV-027| Shock and stabilizer ball
REV-028| Wheel nut M4
REV-030| Turnbuckle M3x26
REV-031| Turnbuckle M3x35
REV-032| Turnbuckle M3x44
REV-033| Stabilizer ball (upper)
REV-034| Servo saver spring
REV-038| Front sway bar
REV-039| Rear sway bar
REV-047| Rear Hub set
REV-050| Rear tie-rod holder
REV-057| Rear to-in plate/Lower Susp arm
REV-059| Servo mount
REV-063| Servo horn arm
REV-064| Front tie-rod holder
REV-066| Front L/F steering block
REV-068| Front steering hub bushing
REV-069| Rear C-hub bushing
REV-070| C-hub washer
REV-072| Bearing set
REV-077| F/R body post
REV-078| Steering plate
REV-079| Steering set
REV-080| Servo saver pipe
REV-089| Servo saver nut
REV-095| Sway bar ball end set
REV-103| Rear hub washer
REV-104| Rear arm washer
REV-140| Pinion Diff Center F/R drive
REV-141| Pinion Diff Metal Bevel Gear 16T
REV-142| F/R diff drive cup set
REV-143| Differential bevel gear
REV-144| Differential O-Ring
REV-145| Differential Gaskets
REV-146| Diff Bevel gear 13T
REV-147| Diff case bushing
REV-148| 10T Diff Bevel gear
REV-149| Diff. Bevel Gear Shaft
REV-150| Diff case
REV-151| BX10/ST10 Complety screw set
REV-153| Pinion Diff complety set
REV-157| New F/R/steering  Ball Cups
REV-158| Watreproff receiver box
REV-160| 2mm pin BX10 CVD front shaft
REV-160DB| 2mm pin BX10 CVD front shaft axle
REV-161| 2mm Pin Front CVD Drive Couple
REV-162| 2mm Front CVD drive cup
REV-163| Security parts BX10  ST10 CVD
REV-167| 2mm Rear drive cup
REV-178| 32 Pitch Center Spur gear 56T
REV-186| Slipper repair parts
REV-187| Differential washers and clips kit
REV-BX001FR| Main chassis Hobbytech BXR.S2
REV-BX002| Side Guard BXR.S2/MT
REV-BX003| F/R lower suspension arm BXR.S2
REV-BX004| BXR.S2/MT  Front to-in plate/Lower Susp arm
REV-BX005| BXR.S2 Front bumper
REV-BX006| BXR.S2/MT Plastic Front Plate
REV-BX007| BXR.S2/MT Rear Chassis Brace
REV-BX008| BXR.S1/MT Center diff and motor mount
REV-BX009| BXR.S2/MT rear diff case plate
REV-BX010| BXR.S2 Rear Brace Holder
REV-BX011| F/R lower suspension arm BXR.S1
REV-BX014| 2mm pin Front wheel alum adaptator
REV-BX015| 2mm pin Rear wheel alum adaptator
REV-BX016| Front/Rear drive pin 2×11.8mm
REV-BX020| BXR.S2/MT Front lower Susp pin 3x44mm
REV-BX021| Battery strap BXR.S2 / MT
REV-BX034| BXR-S2 complety center differential
REV-BX035| BXR-S2 center rear drive shaft
REV-BX036| BXR-S2  racing Wing mounts
REV-BX037| BXR-S2  gearbox plastics reinforcement kit
REV-BX038| BXR-S2 center front drive shaft
REV-BX039| BXR-S2 center differential mount parts
REV-OP32| BXR.S2 91 mm center rear drive shaft for 3s Slipper
REV-OP35FR| Front shock Holder 4mm Black OAS
REV-OP36FR| Rear shock Holder 4mm Black OAS
REV-SL002| 32 Pitch Center Spur gear 56T spec SL
REV-SL004| SL complety center differential
REV-SL047| Pinion diff F/R Gearbox complety set for SL
STICK-BXR.S2| Hobbytech BXR.S2 buggy stickers sheet

OPTION PARTS

WWW.HOBBYTECH-RC.COM
info@hobbytech-rc.com General information

Specification are subject to change without notice.
Photograph shows model after assembly and painting.

References

• Robinson+Cole

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>