GEARLAB 5-port Gigabit Nano switch User Manual

5-port Gigabit

Package Contents

The package contains the items shown below. If any items are missing, please contact the dealer where you purchased this product. The appearance of this product may vary from the illustration.

Device Connection Diagram
(The picture is for reference only, please refer to the actual product )

• 1 pcs Switch
• 1 pcs Power Adapater
• 1 pcs Quick Installation Guide

Check whether the connection is correct according to the indicator status in the table below.

After the connection is completed correct y, the switch does not require any settings.

Installation

Precautions for Installation

•  Do not install the device in an unstable location such as on an unsteady table or an inclined surface.
• Do not place another hub or object that generates heat on this unit.
• Please route all cables properly to prevent people from tripping over them.
• Ensure the air vents on the product are not blocked by other equipment or walls.
• Only use the power cable included with the product. Using other power cables may result in damage or fire.
  Mounting to a Wall
  To mount the unit directly to the wall, use 2 screws (not included). Install the screws apart and slide the mounting holes on the base of the switch over them.
  Install on the Desk
  Put on the Desk, connect with the Network Cable and the power adapter

Specifications

Product with Box weight: 135.5g
Advanced
Functions| Green Technology, saving power up to 85% 802.3X Flow Control, Back Pressure Auto-Uplink Every Port
Environment| Operating Temperature: 0 C -40 C (32 F -104 F) Storage Temperature: -20 C -70 C (-4 1-158 1) Operating Humidity: 10%-90% non- condensing. Storage Humidity: 5%-90% non-condensing
Package
Contents| •5-Port 10/100/1000Mbps Unmanaged Desktop Switch Plastic housing
•Power Adapter

Troubleshooting

If you are unable to connect to a network, check the following.

• Is the power cable connected correctly? Also, is the power cable plugged into an outlet or surge protector?
• Is the Ethernet cable connected correctly? Are any cables disconnected?
• Is the link/act/speed LED on? If not, manually set the communication mode of the connected device to 100 Mbps half duplex or 10 Mbps half duplex.

IMPORTANT WEEE INFORMATION

****This symbol on the product(s) and/or accompanying documents indicates that under the new Directive 2012/19/EU on wage electrical and electronic equipment (WEEE), product(s) used electrical and electronic equipment (WEEE) should not be mixed with general household wage. For proper treatment, recovery and recycling please take this product(s) to designated collection points where it will be accepted free of charge.
Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate wage handling.
Please contact your local authority for further details of your nearest designated collection point. Penalties may be applicable for incorrect disposal of this wage, in accordance with your national legislation.
For professional users in the European Union If you wish to discard electrical and electronic equipment (EEE), please contact your dealer or supplier for further information.

WARRANTY

This product is covered by a 2-year warranty, please contact your dealer in case of defects.
Please take care and dispose of this product correctly according to national and local WEEE legislation.
Please note that all names, models, and trademarks are the sole property of their respective owners.
Gearlab® is a registered trademark of EET Group MS.
Device composition, specifications, and illustrations shown on the packaging are for informative purposes only and may differ from the actual product.
Imported into the EU by EET Group A/S Tempovej 41, 2750 Ballerup, Denmark
Designed in Denmark and Made in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>