HYUNDAI 902 OIL-FILLED RADIATOR Instruction Manual

HYUNDAI 902 OIL-FILLED RADIATOR

Dear customer, thank you for purchasing our product. Please read the operating instructions carefully before putting the appliance into operation and keep these instructions including the warranty, the receipt and, if possible, the box with the internal packing.

GENERAL SAFETY INSTRUCTIONS

• Check whether the data on the type label corresponds with the voltage in your socket. The power cord plug has to be connected to the properly connected and grounded socket according.
• This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
• Before replacing accessories, before assembly and disassembly, before cleaning or maintenance, turn off the appliance and disconnect it from the mains by pulling the power cord from the power socket!
• Do not leave the appliance plugged into the power supply without supervision!
• If the power cord of the appliance is corrupted, it has to be replaced by the manufacturer, its service technician, or a similarly qualified person so as to prevent dangerous situations.
• Never use the appliance if its power cord or plug is damaged, if it does not work properly if it fell down and was damaged and if it is leaking. In this case, take the appliance to a special service to check its safety and proper function.
• The appliance is designed exclusively for private use and for envisaged purposes. This appliance is not fit for commercial use.
• Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid), and sharp edges. Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it immediately. Do not put it in water.
• To protect children from the dangers posed by electrical appliances, make sure that the cable is hanging low and that children do not have access to the appliance.
• Check the appliance and the cable for damage on a regular basis. Do not use the appliance if it is damaged.
• Pay careful attention to the following “Special Safety Instructions for this unit“.

SPECIAL SAFETY INSTRUCTIONS FOR THIS UNIT

• Ensure the power supply to the socket into which the heater is plugged is in accordance with the rating label on the heater and that the socket is earthed.

• Keep the mains lead away from the hot body of the heater.

• Always ensure that the warmer is placed on a firm level surface. Ensure that the heater is not positioned close to curtains or furniture as this could create a fire hazard.

• Do not position the warmer in front of, or immediately below, a wall socket.

• Do not use the warmer in areas where flammable liquids are stored or where flammable fumes may be present.

• Always unplug the warmer when moving it from one location to another.

• This heater is filled with a precise quantity of special oil. Repairs requiring the opening of the oil container are only to be made by the manufacturer or his service agent who should be contacted if there id an oil leakage.

• Regulations concerning the disposal of oil when scrapping the appliance have to be followed. Please, don‘t throw it away and be burnt on purpose.
  WARNING: In order to avoid overheating do not cover the heater.

• Please disconnect the power supply when you are out or the warmer is not used for a long time.

• Do not directly put clothes and other articles on the product to warm so as to prevent fire.

• Never use the warmer in locations with high air humidity such as bathrooms, bathhouses or swimming pools, etc.

• The timer dial is only allowed to turn clockwise (slightly) as indicated by the arrow, and turning it anti-clockwise forcibly will damage the timer.

• The warmer should be away from the wall or other flammable objects such as furniture, curtain, bed sheet, or clothes by at least 90 cm.

• Take care of your children when they are near or use the warmer.

• Do not let the power line contact damp or hot objects; do not wind or let the child come near the power line.

• Do not let the warmer contact with hot gasoline or an electric burner.

• Do not remove the button parts of the warmer.

• This warmer is only suitable for use in the room.

• After dust removal, the oil left on the surface should be removed.

WARNING:
DO NOT COVER To prevent overheating, do not cover the heater.

DESCRIPTION OF THE CONTROLS

• P1 Radiator
• P2 Back hull
• P3 Control box
• P4 Fixed fing
• P5 Control panel
• P6 Temperature controller
• P7 Working indicator
• P8 Power switch knob
• P9 Timer board
• P10 Daily timer
• P11 Cord storage board
• P12 Support wheel
• P13 Base with wheels

INSTRUCTIONS FOR USE

MOUNTING
Take out the warmer and all the parts from the packing carton.

1. Make the warmer be on its head
2. Place the footplate on the top of both radiation fins
3. Secure the footplate on the warmer with a specified U-type bolt and wing nut
4. Tighten the screw
5. Make the warmer stand erect

PLACING
The warmer should be away from the wall or other objects such as furniture, and curtains at least 90 cm; do ensure that the power supply corresponds to that on the nameplate; the temperature controller switch and power switch are at the “O” position; plug in the attaching plug.

CONTROL

Setting temperature
The temperature controller can regulate room temperature. Turn the temperature controller clockwise to increase the temperature; turn it anti-clockwise to reduce the temperature until appropriate temperature is reached.

Setting power

• The power switch is a rotary switch, choose one of the options:
  • position 1 600 W
  • position 2 900 W
  • position 3 1500 W
• The working indicator will light.

Daily timer

Timer Operation

This unit has 24 hr timer which has 96 segments (T1) around its circumference, each segment being equivalent to 15 min. of time. With the aid of this timer, it is possible to preset the time and duration of the period(s) that it is desired the warmer will operate, in any 24hr period. The center of the timer has a 3-position slide switch (T3). In the central position (denoted by the clock symbol ) the timer will switch the warmer on and off at times set by the segments, (see setting the timer, below). The position denoted by the “I”, is a timer override position. The timer will continue to run but power will be fed continuously to the warmer. This enables the warmer to be on all the time if required. In the position denoted by the “O”, the timer continues to run but no power is fed to the warmer.

Setting the Timer
Ensure the slide switch on the timer is at the mid position next to the clock symbol. Rotate the outer ring of the timer in a clockwise direction until the current time is lined up with the arrow pointer (T2), i.e. if the time the timer is being set is 8 pm, rotate the outer ring until the number 20 is in line with the arrow pointer. Set the time the warmer is required to run by pulling the segments around the outer ring forward appropriate to the running period(s) required. When set, the warmer will operate each day during the times programmed.

Note:
The warmer must always be plugged into a power socket, the operation switch must be in the on position and the thermostat must be suitably set to ensure the warmer will come on. If the warmer is required to run continuously the slide switch on the timer should be set to the “I” position. If it is subsequently required to revert back to timer operation, the slide switch on the timer should be set to the central (clock ) position.

Note:
When using in timer mode, due consideration should be given to the fact that the warmer may come on whilst unattended.

CLEANING AND MAINTENANCE

• Always un-plug the warmer from the wall socket and allow it to cool down before cleaning.
• Clean the outside of the warmer by wiping with a damp cloth and buffing with a dry cloth. Do not use any detergents or abrasives and do not allow any water to enter the warmer.

Storing the heater
When the warmer is not used for long periods of time it should be protected from dust and stored in a clean dry place.

TROUBLESHOOTING

The device is not working

• Check that the mains connection cable is firmly plugged in.
• Check the positions of the switches and thermostats.

TECHNICAL SPECIFICATIONS

• Oil filled radiator
• 7 fins
• 3 heat settings 600 W, 900 W, 1500 W
• Twenty-four-hour switch – switching step 15 minutes
• Adjustable thermostat
• Functional holder for carry-in
• 4 easy moving wheels
• Power indicator light
• Color grey
• Noise level 0 dB
• Power supply: 230 V ~ 50 Hz
• Power drain: 1500 W
• Size: 44 x 67 x 16 cm
• Weight (NETTO): 9,5 kg

We reserve the right to change technical specifications.

WARNING:
Do not use this product near water, or in wet areas to avoid fire or injury of electric current. Always turn off the product when you don’t use it or before a revision. There aren’t any parts in this appliance that are reparable by consumers. Always appeal to a qualified authorized service. The product is under dangerous tension.

Disposal

Old electrical appliances, used batteries, and accumulators disposal
This symbol appears on the product, on the product accessories, or on the product packing means that the product must not be disposed of as household waste. When the product/ battery durability is over, please, deliver the product or battery (if it is enclosed) to the respective collection point, where the electrical appliances or batteries will be recycled. The places, where the used electrical appliances are collected, exist in the European Union and in other European countries as well. By proper disposal of the product, you can prevent possible negative impacts on the environment and human health, which might otherwise occur as a consequence of improper manipulation with the product or battery/ accumulator. Recycling of materials contributes to the protection of natural resources. Therefore, please, do not throw the old electrical appliances and batteries/ accumulators in the household waste. Information, about where it is possible to leave the old electrical appliances for free, is provided at your local authority, at the store where you have bought the product. Information, on where you can leave the batteries and accumulators for free, is provided to you at the store, at your local authority.

References

• Úvod - ECOBAT
• Úvod | ELEKTROWIN, a.s.
• Úvod - Envidom
• Hyundai Electronics– Hyundai CZ
• SEWA - OZV | elektroodpad | batérie | obaly

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>