ATOMRC Fixed Wing Flying Fish User Manual
- June 4, 2024
- ATOMRC
Table of Contents
Fixed Wing Flying Fish
User Manual
Introduction
The Flying Fish is a special design twin motor glider for close-range FPV, the 650mm wingspan made the glider easy to fly in a small room and also easy to launch. With 2 in 1 ESC, the wiring is clean and simple, with no modification. The twin motor design made the glider very efficient.
Specifications
| Wingspan | 650mm |
|---|---|
| Length | 570mm |
| WingArea | 6.15d㎡ |
| Material | EPP |
| Motor | 1105 5000KV*2 |
| ESC | BLS 2 in 1 10A 2~4S |
| Propeller | T3018 |
| Servo | 4.3g Servo*4Pcs |
| Recommend Battery | 3S 750mAh Lipo |
Version Description
| Light-bit | State | Meaning |
|---|
Light output terminal
Red light 1| Bright flame| Turn on the output
Often off| Turn off the output
Always put out a Bright flame| Standby. screen off
Turn on the output. state of the constant voltage CC
Always off| Turn off the output
Blue lights 2| Bright flame
Always put out| Turn on the output. constant current CV state Turn off the
output
Red light 2| Bright flame| Parameter lock
Always put out| Parameter not locked
Greenlight 1| Bright flame| not disconnected
sparkle| Select the extension that has been disconnected
Turn off the flash| has been disconnected
Up and down the red| sparkle| alarm
Installation
Install the tail, then install the elevator control surface.
Plug the ESC/Servo connector into the receiver.
Install the propeller, then install the wing to the fuselage.
Install the hatch.
Tx500 VTX User manual
| Band | Channel |
|---|---|
| 1 | 2 |
| Band A | 5865 |
| Band B | 5733 |
| Band E | 5705 |
| Airwave/FS | 5740 |
| Race Band | 5658 |
| L Band | 5362 |
VTX Specs
Voltage input: 2~6S Lipo
Frequency:5.3~5.9Ghz
Power: 100/200/500mw Switchable
Power consumption: 9V 1.1A
VTX Setting
- Hold the button 3 seconds into setting mode. In setting mode. short press the button to change the band.
- Then hold the button 3 seconds into CH setting mode, and short press the button to change CH.
- Hold the button 3 seconds to get into Power setting mode, there is a short bar on the LED, short press to switch power, 1 bar means 100mW, 2 bar means 200mW, 3 bar means 500mW.
2 in 1 ESC Wiring
The throttle input is bridged on the cable, if the user wants differential throttle, please solder the input on the soldering pads.
VTX Wiring
Tips
This product is not a toy, adult supervision is required for those under 14
years old!
The CG is very important for Flying Fish CG is marked on the bottom of the
wing.
Check the CG carefully before flight.
Please download the latest user manual at
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>