Reflying RST67 MagSpeed 2-in-1 Wireless 15W Charging Station User Manual
- June 5, 2024
- Reflying
Table of Contents
Reflying RST67 MagSpeed 2-in-1 Wireless 15W Charging Station
Attaching the Ring
For devices other than iPhone 12 series and above, apply the metal attachment ring to the outside of your phone case using the included applicator guide. Metal attachment ring is to be applied directly on the outside of phone cases only.
- Place the guide over the back of your phone.
- Align your phone vertically so that each edge matches the same number on both sides. Align your phone horizontally so that each edge matches the same letter on both sides.
- If there are no obstructions, peel the protective layer from the metal attachment ring, and apply them to your phone case using the applicator guide.
featured
- USB-C input
- Magnetic wireless output 1
- Wireless output 2
- Indicator light
Charge Your Device Wirelessly
Connect the included USB-C cable to the included wall charger, and the other
end to the USB-C input (A). Place your wireless charging device on the
magnetic wireless output (B). Your device should begin to Wirelessly charge.
To achieve fast charging, ensure you are using a charger that is capable of
fast charging. Some cases may interfere with wireless charging if they contain
metallic material or are overly thick.
Charge your AirPods
Place your AirPods wireless charging case on the wireless output 2 (C). Your
Air Pods should begin to wirelessly charge. See below for indicator light (D)
statuses for the wireless output 2 (C).
| Indicator Light | Status |
|---|---|
| Solid blue | Powered and on standby |
| Breathing red | Wirelessly charging |
| Flashing blue and red | Foreign object on wireless output |
Product Specifications
After evaluation, the product satisfied with RED Directive RF exposure required while used 20cm away from the human body.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interterence received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. these limits are designed to provide reasonable protection against narrow interference in a residential installation This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interterence to radio communications. However, there is no guarantee that interference will not OcCur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment of and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit diferent from that to which the recelver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body. Responsible Party – U.S. Contact Information
EU Declaration of Conformity
Hereby, Shenzhen Reflying Electronic Co., Ltd declares that this product is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address by clicking on the
Compliance Documentation link at: www.reflying.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>