DOMO DO7102S Steam Iron with Steam Generator Instructions

: June 5, 2024
: DOMO

Table of Contents

SAFETY INSTRUCTIONS
PARTS
BEFORE THE FIRST USE
USING THE STEAM GENERATOR
CLEANING AND MAINTENANCE
DESCALING
IRONING TABLE
WARRANTY
RECYCLING INFORMATION
Documents / Resources

DOMO DO7102S Steam Iron with Steam Generator Instructions

SAFETY INSTRUCTIONS

When using electrical appliances, basic safety precautions should always be taken, including the following:

Read all instructions carefully. Keep this manual for future reference.
Make sure all packaging materials and promotional stickers have been removed before using the appliance for the first time.
Make sure children cannot play with the packaging materials.
This appliance is intended to be used in household and similar applications such as:
- staff kitchen areas in shops, offices and other working environments;
- farm houses;
- by clients in hotels, motels and other residential type environments;
- bed and breakfast type environments.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
This appliance can be used by children aged from 16 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised.
Keep the appliance and its cord out of reach of children younger than 16 years.
The appliance must be disconnected from its power source when not in use, during service and when replacing parts. Allow to cool before putting on or taking off parts, and before cleaning the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
CAUTION: In order to avoid a hazard this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
The iron must not be left unattended while it is connected to the supply mains.
The filling aperture must not be opened during use. Follow the instructions of this booklet for safe refilling.
The iron must be used and rested on a flat, stable surface and resistant to heat and hot steam.
When placing the iron on its base: make sure that the surface that the base is on is stable and can withstand heat and hot steam.
The iron is not to be used if it has been dropped, if there are visible signs of damage or if it is leaking. Do not operate this appliance with a damaged cord or plug or in the event the appliance malfunctions or has been damaged in any manner. Return the appliance to the DOMO Service Department or its service agent for examination, repair, or electrical or mechanical adjustment. Do not try to repair the appliance yourself.
Keep the iron and its cord out of reach of children less than 16 years of age when it is energized or cooling down.

The surfaces of the machine marked with this symbol may get very hot during use. Do not touch these surfaces of the machine, always use its handles.

Do not use or store the machine outside.
Do not move the iron while in use or when still hot. Allow to cool before moving the iron or before maintenance.
Do not use this appliance for other than intended use.
Do not fill the water reservoir with any other liquid than water.
Never use the steam function when the water reservoir is empty. This may damage the machine.
Check carefully that the voltage and frequency of the power net match the indications on the rating label of the appliance.
The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local standards and requirements.
Only use the utensils delivered with the appliance.
To protect against electrical shock or burns, do not immerse unit, cord, or plug in water or other liquid.
Do not operate the appliance with wet hands.
Unwrap the cord completely to prevent overheating of the cord.
Do not let the power supply cord touch hot surfaces.
Only fill the water reservoir with no other liquid than water.
Make sure the appliance is correctly assembled, then plug the cord in the wall outlet. To disconnect, turn controls to “OFF” or “0” position, then remove the plug from the wall. Never pull the cord or appliance to remove the plug from the socket.
Failure to maintain this appliance in a clean condition could adversely affect the life of the appliance and possibly result in a hazardous situation.
Any injury or damage caused by failure to comply with these rules are at your own risk. Neither the manufacturer, importer, or the supplier may be held liable.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE

PARTS

PARTS PARTS

Filling cap
Trigger for removing the water tank
Handle
Water tank
Steam release button
Soleplate
Temperature dial
Temperature indicator
Iron
Thermal insulation pads
Steam generator
Cord clamp

Button for releasing watertank
Grasp the water reservoir by its handle and press and hold the button. You are now able to remove the water reservoir from the generator.

Filling cap
Open the filling cap and use the opening to fill the water tank.

Temperature indicator
When the iron is heating up, the temperature indicator will be lit up. When the set temperature has been reached, the light indicator will go out again. During ironing the indicator will alternately light up and go out again, as the iron is being kept at the right temperature.

Steam release button
Press the steam button on the inside of the iron’s handle to release a constant stream from the sole plate. When you release the button, you will iron dry, without steam.

Cord clamp
After use you can easily store the cord and steam hose by using the cord clamp. Pull out the clamp, lead the steam hose and the cord around the steam generator and push in the clamp to lock the cord and steam hose.

Temperature dial
Set the right temperature for the right fabric with the temperature dial.

For synthetic fabrics/silk:
For wool:
For cotton:
For linnen: MAX

BEFORE THE FIRST USE

Remove any stickers and protective film from the machine and the sole plate.
Heat up the iron until the maximum temperature and iron on a damp cloth during a couple of minutes to remove any possible residues from the soleplate. Iron according to the instructions in the section «Steam ironing».

Caution:

During the first use it is normal that a specific odeur escapes from the appliance.
This odeur will disappear after a while.
Some particles may come out of the soleplate during the first use. This is normal.
The particles are harmless and will disappear after a while.
When you turn on the machine, the steam generator may make a pumping noise.
This is normal. This noise means that water is being pumped to the sole plate.
While the soleplate is heating up, some steam will be released automatically. This is also normal and will last for about 3 seconds.

USING THE STEAM GENERATOR

This steam generator offers 2 options: dry ironing or steam ironing. Follow the instructions below. Also carefully read the ironing tips at the end of this section before using the appliance.

Dry ironing

Place the iron on the thermal insulation pads of the steam generator.
Plug in the appliance.
Select the desired temperature with the temperature dial, according to the kind of fabric that needs to be ironed. The temperature indicator will light up and the iron will start heating up.
When the temperature indicator goes out, the selected temperature has been reached. You can now start ironing.
Caution: Never touch the hot soleplate!

Steam ironing
Caution: do not plug in the appliance yet at this point.

Grasp the water reservoir from the steam generator by its handle and press the button to remove the water reservoir from the generator. Open the cover of the filler opening and fill the reservoir with water. Use demineralised water for this.
Make sure you do not exceed the maximum level (1.8 l). Close the filler opening after filling.
Replace the water reservoir back in the steam generator. Caution: if the reservoir is not replaced properly, the machine will not produce any steam.
Place the iron on the thermal isolation cushions of the steam generator.
Put the plug in the mains. Set the temperature disc at the desired temperature, depending on the type of material, and the temperature light will light up.
The water in the water reservoir will heat up and after a few minutes the temperature light will go out. This means that the steam generator has reached the correct temperature. You can now press the steam button to discharge steam.
Caution: the temperature button must be in the steam area for this (indicated by ).
Between ironing, the iron may be placed on the base for a short while.

Please note:
- Do not touch the hot sole of the iron!
- Never aim steam at people!
- The supply cable may heat up during a long ironing session.
- If the noise of the pump gets louder, the water reservoir most likely has to be filled. Make sure there is always enough water in the reservoir, at least above the minimum level.
When finished with ironing, turn the temperature disc down to its minimum and remove the plug from the mains. Place the iron on the thermal isolation cushions of the steam generator and allow to it cool completely.

Ironing tips

Always check first if there is a label on the garment with instructions for ironing.
If this is the case, then always follow these instructions.
The iron heats up faster than it cools down. Therefore, always iron the garments that require the lowest temperature first, like synthetic fabrics.
If a fabric contains several types of fibres, always choose the lowest temperature to iron the combination of these fibres.
Silk and other shiny fabrics should be ironed inside-out.
Velvet and other fabrics that easily become shiny should be ironing with slight pressure, in one direction. Always keep the iron moving.
Fabrics that are a 100% wool can be ironed with steam. Set the temperature to the maximum and use a dry cloth to place on the fabric.
Never iron over zippers or other metal objects in a garment. This can damage the soleplate. Always iron around such objects.
Caution: if you iron woollen fabrics, the fabric may become shiny. That is why you should turn the garment inside-out for ironing.

CLEANING AND MAINTENANCE

Unplug the appliance and let it cool down before cleaning it.
Wipe residues from the soleplate with a damp cloth or with a non abrasive (liquid) cleaner.
Caution: Do not use any chemical, steel, wooden or abrasive cleaners to scrape the soleplate.
Clean the upper part of the iron with a soft, damp cloth.
Wipe the water drops on the steam generator and the thermal insulation pads with a dry cloth.
When not using the steam generator for a long time, pour out the water from the water tank and place the iron on the thermal insulation pads to store the appliance.
Wind the steam hose and cord around the appliance and lock them into place with the cord clamp.

DESCALING

Descale the steam generator regularly to increase the life span of the machine and to maintain good operation.

Fill water reservoir halfway with a mixture of 1/3 vinegar and 2/3 water.
Put the plug in the mains and turn the temperature disc to its maximum.
Wait until the machine has heated up and hold the iron above a sink or washbasin.
Now press the steam button and discharge a continuous stream of steam. The machine cleans itself in this way. CAUTION: to prevent scalding make sure you do not come into contact with the hot steam!
Refill the water reservoir with only water. Repeat this cycle of discharging steam 2 to 3 !times, but then with only water, until the vinegar smell has disappeared.

IRONING TABLE

Symbol	Fabric	Variable steam
synthetic fabric/silk
wool
cotton linnen
This symbol means that the article can not be ironed!

WARRANTY

This appliance has a two year warranty period. During this period the manufacturer is responsible for any failures that are the direct result of construction failure.
When these failures occur the appliance will be repaired or replaced if necessary. The warranty will not be valid when the damage to the appliance is caused by wrong use, not following the instructions or repairs executed by a third party. The guarantee is issued with the original till receipt. All parts, which are subject to wear, are excluded from the warranty.
If your device breaks down within the 2-year warranty period, you can return the device together with your receipt to the shop where you purchased it.

Type nr. of appliance

Name __

Address __

Date of purchase __

Tel: __

RECYCLING INFORMATION

Disposal icon Recycle icon
This symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it must be brought to the applicable collection point for recycling of electricaland electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. The packaging is recyclable. Please treat the packaging ecologically

From now on, accessories and parts of Domo appliances can also be ordered online from the Domo webshop*:
http://webshop.domo-elektro.be

You can reach the webshop through the Domo website as well: www.domo elektro.be.
The accessories and parts can also still be obtained at the store where you bought the appliance.

Only in Belgium, the Netherlands, Luxemburg, France and Germany

If the power supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard.
Power Cord Supply

ORDER
the original Domo accessories and parts online at: or scan here:
webshop.domo-elektro.be

Inductions

or scan here:

Logo

Documents / Resources

| DOMO DO7102S Steam Iron with Steam Generator [pdf] Instructions
DO7102S, DO7103S, Steam Iron with Steam Generator, Steam Iron, DO7102S, Iron
---|---