JAMARA Runty 6V Mini Quad Instructions

: June 3, 2024
: JAMARA

Table of Contents

General information
Certificate of Conformity
Box content
Parts
Troubleshooting
Spare Parts
Service centre
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

JAMARA Runty 6V Mini Quad Instructions

General information

JAMARA e.K. is not liable for any damage caused to the product itself or through this, provided this is due to improper operation or handling errors. The Customer alone bears the full responsibility for the proper use and handling, including without limitation, the assembly, the charging process, the use and choice of the operation area. Please refer to the operating and user instructions, it contains important information and warnings.

Certificate of Conformity

Hereby JAMARA e.K. declares that the products „Runty Mini Quad 6V, No. 460865, No. 460866, No. 460867, No. 460868“ comply with Directives 2014/30/EU, 2014/35/EU, 2011/65/EU and 2009/48/EC.
The full text of the EU Declaration of Conformity is available at the following Internet address:
www.jamara-shop.com/Conformity

Read the complete instructions and security instructions carefully before using the model

To prevent accidents and injuries, DO NOT leave your Child unattended during operation of the vehicle. Never let your Child out of your sight while the driving a vehicle .

DO NOT use the vehicle on public roads or places or other dangerous locations.
ONLY operate the Ride On Car in places such as private parking, private land or other safe locations. Make sure that no person or animal is endangered.

The model stops after releasing the accelerator, independently on a horizontal surface. The vehicle has no brake or parking brake. Do not operate the vehicle uphill or downhill, and secure it when parking.

DANGER

For safe driving, you should make sure that your Child understand and adheres to the following rules:
- Always sit tight, do not get up during the ride.
- Never take additional Children for a ride. (The vehicle is only suitable for 1 person)
- Hold tight.
- Never drive without shoes.
- Never drive in the dark.
- To be used with protective equipment.
Keep hands, hair, loose clothing and any other item away from any rotating parts.
The Model should not be used in rooms or halls with high humidity, in the rain or on wet surfaces. Risk of malfunction or damage to electronics and housing.
The model is not water- or splash-proof. Only operate on asphalted surfaces (such as paving stones). The model is not suitable to be operated in grass or loose soil.

Attention!
Keep the not mounted kit away from small children as it contains swallowable parts.
It must be assembled or checked by adult to make sure the car is assembled on the right way before playing.

Only use in direct supervision of an adult!
To control the vehicle a minimum skill level and caution is needed. Make sure you are familiar with the operation of the model and its characteristics. The model is heavy. This is an increased risk of injury and damage in the event of loss of control. Avoid any kind of intentional or unintentional collisions with objects or hazards to persons.

Box content

Model
Battery pack
Charger 230 V
Assembly tool
Instructions

Parts

Nut
Washer
Screw
Bumper
Wheel
Transmission
Dash
Instruction
Handle bar
Chassis
Seat
Lock seat
413070 Charger
Steering column
Rear axle
Shaft sleeve
Accessory package
Battery cover
Battery

Required tool: Screwdriver

Assembly Instructions

Front axle
Fix the steering levers with the axle plate. Push a bolt through the axle plate and through the steering levers and secure with a nut. Tighten the bolt with a screwdriver (not included in the scope of delivery) and the socket wrench (A).
Mounting the rear wheels
First mounting the rear wheels. Fit a washer (2), 2 shaft sleeves(16) and a washer (2) into the axle. Fit a wheel (5) and a washer (2) onto the rear axle (15). Fit a nut (1) to the end of the axle and tighten with a wrench (A).
Antriebsrad Install the gear (6) on the right side of the rear axle (15). Fit a wheel (5) on the axle and secure it with a washer (2) and a nut (1). Tighten the nut with a wrench (A).
Mounting the front wheels
Fit a washer (2) and a front wheel (5) onto the front axle. From the outside fitted a washer (2) and secured with a nut (1) gesichert. Tighten the nut with a wrench (A). Repeat this on the other side.
mounting the handlebars, the armature and the ram protection
Fut the handlebars on the steering column Align it so that the holes on the Match the handlebars with those on the steering column. Slide a threaded screw through the hole and secure it with a nut. Now insert the steering column through the Hole in the body and press until it clicks into place.
After pushing the handlebars through the car, turn the car around and put the handlebars through the eyelet on the steering linkage. Secure with a washer and nut.
Position the fitting on the body until it engages
Place the front bumper on the body in position and secure it with 4 screws.
Battery connection
Connect all connectors as shown. Only plug matching connectors into eachother and be sure not to reverse the polarity. Make sure the red wire is well connected with the red terminal on the battery, and same as the black one. Connect the motor cables (1) together. Cover the battery compartment with the cover.
Assembly the seat
Place the seat in the position and save the seat with the seat lock.
Functions
A ON/OFF Switch
By pressing the ON / OFF switch (1) is the model on or off
B Sound button
C Switch button
Forward: Press the switch button on the▲ position.
Press the gas pedal, the model drives forward.
Backwards: Press the switch button on the ▼ position.
Press the gas pedal, the model drives backwards.
IMPORTANT!
Always stop vehicle when changing the speed or direction to avoid damage the gears and motor.
D Accelerator pedal
Press the accelerator pedal to move the model. Remove the foot from the accelerator pedal to stop the model
Charging your vehicle
- The POWER SWITCH must be turned in OFF position when charging.
- Plug the charger port into the input socket and plug the charger plug into a wall outlet.
  The battery will begin charging.
- The charge time is 10 hours.
  Do not charge the battery more than once within 24 hours
- Charger and battery heat up during the charging process

Warning

The charger is not a toy. Only use the charger supplied.
The battery may only be charged by or under the supervision of an adult.
The terminals must not be short-circuited.
The charger must be checked regularly for damage to the cable, plug, housing and other parts. If any damage is found, the charger must not be used until the damage has been repaired.
Let the model cool off sufficiently after each use before putting it back into operation.
When using an additional batteries let it cool off for minimum 15 minutes until the model is operated again. Overheating can damage the electronics or may result in fire.
Always disconnect the model from the charger immediately after charging. Always disconnect the charger from the power supply immediately after disconnecting the model. Inserting the rechargeable model or charger after charging will result in damage tothe model, charger or the power supply (fire hazard).
Use the charger only in dry rooms.

Danger!
Always switch off the model immediately after each use. Immediately after each use, the batteries should be disconnected from the model. The batteries can be deeply discharged by leaving them switched on accidentally or leaving them plugged in. Due to deep discharge, the batteries lose power or can be damaged to such an extent that charging
or discharging is no longer possible or the batteries can self-ignite during the charging or discharging process (fire hazard). Never attempt to charge or discharge deeply discharged batteries. The voltage of a battery should never fall below 5,74 volts to avoid a deep discharge. The fully charged battery has a voltage of approx. 6,5 volts. After use, the intact batteries should be fully charged immediately after a cooling phase of min. 10 minutes but at the latest after 12 hours to avoid a subsequent deep discharge by self-discharge. If the batteries are not used or stored for a longer period of time, the batteries should be checked for voltage (min. 6,2 volts) or damage at least every 3 months and recharged or disposed of if necessary.

Troubleshooting

The vehicle does not run

The battery may low on power.
After each use, or once a month minimum, charge the battery. Do not leave the battery on the charger for more than 10 hours.
Thermal fuse has tripped.

The vehicle is equipped with a self-resetting fuse. When the vehicle is overloaded or operated incorrectly; the self-resetting fuse will be cut off for 5 – 10 seconds before becoming operational again. The self-resetting fuse is under the seat.
Cut off the power, follow these guidelines:

  * DO NOT overload the vehicle, Maximum weight allowed: 25 kg
  * DO NOT tow anything behind the vehicle.
  * DO NOT drive up steep slopes.
  * DO NOT drive into fixed objects, which may cause the wheels to spin, causing the motor to overheat.
  * DO NOT drive in very hot weather, components may overheat.
  * DO NOT tamper with the electric system, Doing so may create a short circuit, causing the fuse to trip.

Battery connector or wires are loose.
Make Sure the battery connectors are firmly plugged in to each other.
Battery is dead.
Have you properly maintained the battery according to the directions? Is the battery old?
Your battery may need to be replaced.
Electric system is damaged.
Water may have corroded the system, or loose dirt, gravel or sand might have jammed the switch.
Motor is damaged.
The motor needs professional repair.

The battery will not recharge

Battery connector or adapter connector is loose.
Make sure the battery connector and adapter connector are firmly plugged together.
Charger is not plugged in.
Make sure the charger is plugged into the wall outlet and the power flow to the outlet is on.
Charger is not working.
Is the charger warm while charging? If not, the charger may.

The vehicle does not run very long.

Battery may be undercharged.
You may not be charging the battery long enough. After each use, or once a month minimum, charge the battery. Do not leave the battery on the charger for more than 10 hours.
Battery is old.
The battery will eventually lose the ability to hold a charge. Depending on the amount of use, and varying conditions, the battery should operate for one to three years. Replace the battery with a new one.

Battery buzzes or gurgles when charging.
This is normal and not a cause for concern. It may also be silent when charging, which is also normal.

Charger feels warm when recharging battery.
This is normal and not a cause for concern

You can find further solutions to problems on the Internet in our FAQ at:

You can find further solution

Spare Parts

412303 6V 4,5Ah
Lead acid battery

413069
Soundboard

413071
Transmission

Spare Parts

404743 6V
Charger

413387
Handlebars

Spare Parts

412648
Switch forward/backward

412760
Switch gas

Disposal restrictions
Batteries and accumulators must not be disposed of in domestic waste. You are obliged to dispose of batteries (seperate collection) appropriately. After use you can return batteries free of charge to the retail store. As batteries contain substances that can be irritant, can cause allergy and are highly reactive, separate collections and proper recycling is important to the environment and to your health. If the batteries are marked with a chemical symbol Hg, Cd or Pb below the crossed-out waste bin on wheels it refers to that more than 0.0005% of mercury (Hg), more than 0.002% of cadmium (Cd) or more than 0.004% Lead (Pb) is included.

Disposal restrictions
Electrical appliances must not be disposed of in domestic waste and must be disposed of separately.
You are obliged to take out the batteries, if possible, and to dispose of the electrical equipment at the communal collection points. Should personal data be stored on the electrical appliance you must remove them by yourself.