HYUNDAI HYUHVC101 Battery powered vacuum cleaner Instruction Manual

: June 5, 2024
: HYUNDAI

Table of Contents

HYUNDAI HYUHVC101 Battery powered vacuum cleaner
SAFETY PRECAUTIONS
EQUIPMENT AND ACCESSORIES OF VACUUM CLEANER (Fig. 1).
PREPARATION AND USE OF THE VACUUM CLEANER
MAINTENANCE
TROUBLESHOOTING
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

HYUNDAI HYUHVC101 Battery powered vacuum cleaner

SAFETY PRECAUTIONS

Before the first use, read the instructions for use carefully, look at the picture and store the instructions for use for the future.
Check whether the data on the type label correspond with the voltage in your electric power socket.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children younger than 8 years must be kept out of reach of the appliance and its power cord.
If the power cord of the charger is corrupted, it has to be replaced by the manufacturer, its service technician or a similarly qualified person so as to prevent dangerous situations.
Never use the appliance if its power cord or charger is damaged, if it does not work properly, if it fell down and was damaged and it is leaking. In this case take the appliance to a special service to check its safety and proper function
Always unplug the appliance from power supply if you leave it unattended and before assembly, disassembly or cleaning.
The product is intended for home use and similar (in shops, offices and similar workplaces, in hotels, motels and other residential environments, in facilities providing accommodation with breakfast). It is not intended for commercial use!
Do not put the suction hole of the vacuum cleaner or the accessories close to your eyes and ears and do not insert them into any body orifices!
Never immerse the charger, the battery and the motor part of the vacuum cleaner into water (even partially) and protect them against humidity!
Install the holder, the vacuum cleaner and the appliance within sufficient distance from flammable objects (e.g. curtains, drapes, wood, etc.), heat sources (e.g. oven, stove, etc.) and wet surfaces (e.g. sinks, wash-basins, etc.).
Make sure that the power cord of the charger does not hang freely over an edge of a working table where children could reach it.
Plug the battery charger to a socket with alternate current only.
For charging the battery of the vacuum cleaner, use only the specific charger.
Use the charger in a room only.
Before cleaning the charger, unplug it from the electric socket.
Always switch off the vacuum cleaner when charging the battery and after the vacuum cleaner was used.
When the battery is charged, the charger is hot which is a normal condition.
Charge the battery at standard room temperature.
Do not charge the battery if electrolyte is leaking from it.
Do not expose the battery to temperatures exceeding 50 °C. This will prevent damage of the battery.
Leaking of electrolyte from the battery is caused by overloading the vacuum cleaner or by using the vacuum cleaner at extremely hot temperature. If you are splashed with electrolyte, wash the affected place with water and soap and rinse it with lemon juice with vinegar. In eye contamination, rinse the affected eye for a couple of minutes with clean water and seek medical advice immediately.
Do not through the battery into fire. There is a risk of explosion!
Do not connect the contacts of the battery or the charger! If you do not use a battery, keep it away from metal objects, such as paperclips, coins, keys, nails, screws or other small metal objects that can cause short circuit of the battery connectors. Short circuit of the battery connectors can cause burn or fire.
Before you start using the vacuum cleaner, please check that all the blocking mechanisms are in the right position.
Never vacuum without a properly inserted filter protector and filters!
Never use (switch on) the vacuum cleaner if it is placed in the holder and it is being charged!
The vacuum cleaner is not suitable for vacuuming substances that can harm the human health.
Do not vacuum sharp objects (e.g. glass, shatter), hot, flammable, explosive objects (e.g. ash, hot cigarette butts, gasoline, thinners, aerosol vapours) or greases (e.g. fats, oils). Vacuuming these objects may lead to damage of the filters or the vacuum cleaner.
When vacuuming some kinds of carpets, upholstery fabrics, etc., electrostatic discharge may occur which is not dangerous for the user.
Pores of the filter may be clogged when vacuum cleaning very fine dust (e.g. fine sand, cement dust, plaster). Thus, air permeability will be reduced and the suction performance will drop. In this case, the container has to be emptied and the filter cleaned.
Do not insert fingers or other things to input and output vents of the appliance. If the openings/elements for air flow are clogged (e.g. the accessories), turn the appliance off and remove the clogging.
If you need to use the extension cord, it has to be uncorrupted and it has to comply with the valid safety standards.
Regularly check the inlet of charging adapter!
Never use the appliance for any other purpose than for the intended purpose described in these instructions for use!
In order to ensure safety and proper function of the appliance, use only original spare parts and accessories approved by the manufacturer.
The manufacturer is not responsible for damage caused by improper use of the appliance and the accessories and its guarantee for the appliance does not apply in situations when the safety warnings above are not complied with. Failure to replace or maintain all filters regularly according to the instructions in Chapter III. and also using non-original filters, the properties of which resulted in failure or damage of the vacuum cleaner, is also understood to be improper use of the appliance.

EQUIPMENT AND ACCESSORIES OF VACUUM CLEANER (Fig. 1).

vacuum cleaner
- ON–OFF button
- light signaling
- container lock button
- holder
- power supply socket
dust container
- filter
- filter protector
- holder
- brush adapter
- slot adapter
- rubber scraper
- charged

PREPARATION AND USE OF THE VACUUM CLEANER

Remove all the packing material, take out the vacuum cleaner and the accessories.

Fastening of the holder to the wall
Fasten the holder C close enough to the electric socket using bonding material (Fig.3). Make sure that there is no electric, telephone, plumbing fittings under the plaster at the place of mounting the holder. You can also place the holder on a horizontal surface, such as a table, etc. Holder must be placed or fixed in flat position otherwise vacuum cleaner can fall down and caused injury. Then slide the vacuum cleaner A to the holder together with the accessories (D, E, F).

Charging the battery
It is necessary to charge the accumulator at least 14 to 16 hours before first use. Plug the adaptor G into the el. mains. Slide the connector of the adaptor lightly into the socket A5 in the cleaner (placed in holder C). The operation of charging of the accumulator is indicated by the indicator A2 (pic. 6). The accumulator is usually fully charged after approx. 10 hrs and gives operation time for. 13 minutes. Turn the cleaner off before charging! Maximum charging time is 10 hours, do not exceed this time!

CAUTION:

Do not charge the battery for more than 24 hours!
If you charge the battery for the first time or after long storage, about 60 % of its total capacity is charged. After repeated discharge and repeated recharge the battery is charged to 100 %.
Let the charger cool down for at least 15 minutes between charging.
After completing hard work or in hot environment, the battery may be too hot for charging. Let the battery cool down before charging.
The control light A2 does not provide any information about how much the battery is charged.

Using the vacuum cleaner
Disconnect the charger connector from the socket A5 and remove the vacuum cleaner from the holder. Choose suitable accessories (D, E, F) according to the type of the cleaned surface. Slide the selected adapter end-to-end to the hole in the dust container B (Fig. 4). You can turn the vacuum cleaner on and off by the switch A1 (Fig. 6). Let the vacuum cleaner recharge as soon as its suction performance is weaker. In everyday use of the appliance, let the vacuum cleaner connected to the charger. In this way the appliance will always be fully loaded. Battery overcharging is not possible. If you are not present for longer time (more than one day), remove the charger from the electric socket to save energy. Vacuuming dry impurities
Select the suitable accessories (D – brush adapter for cleaning fine surfaces, E – slot adapter for cleaning corners and narrow gaps). Slide the selected adapter end-to-end to the hole in the dust container B. Remove the adapter in the opposite direction.

Vacuuming wet impurities
Slide the adapter (F – rubber scraper) end-to-end to the hole in the dust container B. Push the scraper slightly to the surface that you want to clean and hold the vacuum cleaner tilted in the angle of about 30 degrees. Make sure that the scraper is constantly in contact with the surface during vacuum cleaning (Fig. 5).

CAUTION:

When vacuuming wet impurities, the vacuum cleaner cannot be turned with the dust container upside down, laid down or bent to one side or shaken.
If the level of the liquid in the container reaches the maximum gauge (it´s max 200 ml), stop vacuuming the liquid.
After every use of the vacuum cleaner for vacuuming liquids or wet impurities empty and wipe thoroughly the container, the protector and the filter before you put it in the holder.

Emptying the dust container
If the amount of impurities in the container reaches the MAX gauge, it has to be emptied. Release locking of the container B by pressing the A3 button and remove it from the vacuum cleaner by tilting (Fig. 7). Pull out the filter B1 and the filter protector B2 from the container (Fig. 8), then place the container over a dustbin and empty it into common municipal waste (Fig. 9). Slide the protector and the filter back to the container end-to-end. Put the container to the vacuum cleaner in the opposite direction and secure it by snapping in the locking button A3. For sanitary reasons we recommend emptying the container outside housing premises.

Cleaning the dust container and cleaning the filter
After about 5 emptying of the container we recommend complete cleaning of the suction system from the settled dust. Clean all parts (i.e. the container, the filter protector and the filter) in running lukewarm water (e.g. using a cloth or a soft brush) and let it dry completely (Fig. 10). Re-assemble individual parts in the opposite direction after it is completely dry.

Filter replacement
Disassemble the movable parts of the cleaner for changing of the filter (pic. 8). Slide the new filter on and fix it thoroughly reversely.

accessories
You may put the accessory (D, E, F) into the holder C, orto a safe place. Store the adaptor G on a safe, dry and dustless place inside the house, keep it out of reach of children and persons sui juris.

MAINTENANCE

Disconnect the charger from the appliance before any maintenance. Store the vacuum cleaner at a dry place, far enough from heat sources (e.g. fireplace, stove, heating element) and protect it against weather conditions (e.g. rain, sunshine). Treat the surface of the vacuum cleaner and the charger (only when disconnected from the electric socket) with a wet cloth, do not use abrasive and aggressive cleaning agents! Never dry plastic moldings over a heat source (e. g. heater, electric/gas stove).

CAUTION:

The maximum suction effect will be reached by a clean filter and an empty container.
Do not use any aggressive washing or cleaning agents or hot water to clean the filter.
The filter is not intended for washing in a dishwasher.
Cleaning the filter will not restore its original colour, but it will restore its filtration properties.
Neglecting filter cleaning may lead to breakdown of the vacuum cleaner!
Make sure that the binding surfaces and sealing elements are functional.
We recommend replacing the filter twice a year or when it cannot be cleaned properly or if it is damaged. You can buy a replacement filter in the elektro shop chain.

TROUBLESHOOTING

Problem	Cause	Solution
Motor won‘t start	The battery is discharged The „ ON-OFF “ button is not
switched on	Recharge the battery

Press the “ ON-OFF ” button

The container cannot be fixed to the vacuum cleaner| The parts of the filtration system not inserted properly in the container| Check / correct insertion of the protector and the filter in the container
The suction performance is not sufficient| Dust container full Clogged filter

The accessories are blocked

The battery is discharged

| Empty the container Clean or replace the filter

Remove the blocking objects

Recharge the battery

Removal of the battery
Remove the batteries from the appliance only when they are completely discharged (i.e. let the vacuum cleaner running until its motor stops). Screw out all bolts and open the vacuum cleaner. Gradually disconnect the lead-in wires of batteries and remove the battery (Fig.11). Replacement of parts that require intervention in the electric part of the appliance must be carried out by a specialized service! Failure to comply with the instructions of the manufacturer will lead to expiration of the right to guarantee repair!

Voltage (V) specified on the type label of the appliance
Input (W) specified on the type label of the appliance
Protection class appliance II.
Battery 4,8 V
Charged 230 V~ / 6,4 V=, 1,5 W, 200 mA
Noise level 74 dB (A)

We reserve the right to change technical specifications.
The manufacturer reserves the right for any insignifi cant deviations from the stan-dard finished product which do not have any effect on the functioning of the pro-duct.

WARNING: Do not use this product near water, in wet areas to avoid fire or injury of electric current. Always turn off the product when you don’t use it or before a revision. There aren’t any parts in this appliance which are reparable by consumer. Always appeal to a qualified authorized service. The product is under a dangerous tention.

Old electrical appliances, used batteries and accumulators disposal
This symbol appearing on the product, on the product accessories or on the product packing means that the product must not be disposed as household waste. When the product/ battery durability is over, please, deliver the product or battery (if it is enclosed) to the respective collection point, where the electrical appliances or batteries will be recycled. The places, where the used electrical appliances are collected, exist in the European Union and in other European countries as well. By proper disposal of the product you can prevent possible negative impact on environment and human health, which might otherwise occur as a consequence of improper manipulation with the product or battery/ accumulator. Recycling of materials contributes to protection of natural resources. Therefore, please, do not throw the old electrical appliances and batteries/ accumulators in the household waste. Information, where it is possible to leave the old electrical appliances for free, is provided at your local authority, at the store where you have bought the product. Information, where you can leave the batteries and accumulators for free, is provided to you at the store, at your local authority.