wouxun PSB-1000 Base Station Kit Instruction Manual
- June 5, 2024
- wouxun
Table of Contents
wouxun PSB-1000 Base Station Kit Instruction Manual
Installation Instructions
To install a Wouxun mobile radio into the base station, follow the
instructions below.
WARNING: Be sure the radio and base station power supply are turned off and
disconnected from any power source before attempting the installation
procedure.
Removing the cover will expose internal components of the power supply. For
your personal safety, do not touch or handle any circuitry within the power
supply unit. Use extreme caution when installing the radio into or removing it
from the base station kit.
-
Remove the four screws shown in fig. 1 below from each side of the base station.
-
Carefully slide the metal frame of the base station up and off the power supply housing.
-
Turn the base station frame upside down and locate the mounting bracket attached to the inside of the frame.
-
Remove the two screws that secure the mounting bracket to the base station frame (1 on each side).
-
Place the mounting bracket over the bottom of radio and in the orientation as shown in fig. 2.
-
Fasten the mounting bracket to the chassis of the radio using a screw on each side as shown in fig. 3
-
Slightly spread the sides of the frame apart and insert the radio and mounting bracket assembly inside the frame as shown in fig. 4.
-
Attach the mounting bracket assembly to the frame with a screw on each side as shown in fig. 5
-
Slide the base station frame over the power supply unit and secure it to the base with the screws as shown in fig. 6.
www.buytwowayradios.com