JOCEL JSE013422 Electric Fireplace User Manual
- June 5, 2024
- JOCEL
Table of Contents
- JOCEL JSE013422 Electric Fireplace
- Features of the product
- Scope of delivery
- Security Advice
- LOCATION OF CONTROLS
- Installation
- Cleaning
- Disposal
- GENERAL WARRANTY TERMS
- THE WARRANTY EXPIRES
- TECHNICAL ASSISTANCE
- DECLARATION OF CONFORMITY
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
JOCEL JSE013422 Electric Fireplace
This product is only suitable for well insulated spaces and for occasional use
Model | Voltage | Frequency | Power |
---|---|---|---|
JSE013422 | 220-240V~ | 50Hz | 1600-1800W |
Features of the product
This is an emulation flame electric fireplace. The theory of the product is to use a fan to flow the hot air heated by the heating elements in order to achieve the effect of indoor heating.
Scope of delivery
Immediately after unpacking please check that the delivery is complete and all product parts are in good condition.
1 Electric heater
| ****
1 User manual
| ****
3 Legs
| ****
3 Screws
---|---|---|---
Security Advice
- The product cannot be used outdoors.
- Any item covered or blocked the fireplace vent in any way is prohibited, or the fireplace will be dangerous caused by overheating.
- Furniture, curtains or flammable materials should ensure that 1 meter away from the fireplace.
- Cut off the power immediately if there is something wrong.
- Please turn off the power if it is not used in a long time.
- Please do not put the power cord on the front of the fireplace.
- Although the machine has reached safety standards, we do not recommend that it is used on multi-use carpet or carpet Long Hair.
- Dispose of the package carefully. Plastic packaging material may cause environmental pollution.
- The product must be connected to the ground.
- The fireplace must be used under the AC voltage rating.
- The fireplace has a tip-over switch, if the unit topples over, the power will be cut off.
- WARNING: In order to avoid overheating, do not cover the heater
- The heater must not be located immediately below a socket outlet.
- Do not use this heater in the immediate surroundings of a bath, a shower, or a swimming pool.
- This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
- In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person must place it in order to avoid a hazard.
- This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own unless constant supervision is provided.
- Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal position and they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
- CAUTION: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
- This product is fitted with a thermostatic room temperature control.
LOCATION OF CONTROLS
- Switch OFF
- Flame function – Switches flame effect and power on
- Heat function – Low heating power 900W (With flame effect)
- Flame function – Switches flame effect brighter (With low heating power)
- Heat function – High heating power 1800W (With more bright flame effect)
- Adjustable Thermostat – mechanic thermostat room temperature control
Installation
Installation of feet
Take out the whole machine, and put it on the flat table in order to avoid machine scratching, then take the feet out of the plastic bag and connector (as shown in the picture), the three foot which marks A,B, and C should fix on the match position:
Overheating safe device
If the heater stops working, turn the heater off and inspect the blockage of the inlet or outlet. Disconnect the plug and wait at least 15 minutes for the protection system to reset before attempting to restart the heater. If the safe device still switches the heater off and makes the heater fail to operate, take the heater to your nearest service center for examination or repair.
Attention: before restarting the heater, the plug must be disconnected for at least 15 minutes.
Cleaning
- Always disconnect the appliance from the main supply before cleaning.
- Clean the outside of the heater by wiping with a damp or dry cloth.
- Do not use petroleum, any other detergent or chemical solvent to clean the heater.
- When the heater is not used for a long time, it should be protected from dust and stored in a clean dry place.
Disposal
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.
Model: JSE013422
Item| Symbo
l
| Value| Unit| Item| Unit
Heat output| Type of heat input, for electric storage local space heaters only
(select one)
Nominal heat output| Pnom| 1,6-
1,8
| kW| manual heat charge control, with integrated thermostat| [NO]
Minimum heat output (indicative)| Pmin| 0.9| kW| manual heat charge control
with room and/or outdoor
temperature feedback
| [NO]
Maximum continuous heat output|
Pmax
|
1.8
|
kW
| electronic heat charge control with room and/or outdoor
temperature feedback
| [NO]
Auxiliary electricity consumption| Fan-assisted heat output| [NO]
At nominal heat output| elmax| N/A| kW| Type of heat output/room temperature
control (select one)
At minimum heat output|
Elgin
|
N/A
|
kW
| single stage heat output and no room temperature control| [NO]
In standby mode| elsb| N/A| W| Two or more manual stages, no room temperature
control| [NO]
| | | | with mechanic thermostat room temperature control| [YES]
| | | | with electronic room temperature control| [NO]
| | | | electronic room temperature control plus day timer| [NO]
| | | | electronic room temperature control plus week timer| [NO]
| | | | Other control options (multiple selections
possible)
| | | | room temperature control, with presence detection| [NO]
| | | | room temperature control, with open window detection| [NO]
| | | | with distance control option| [NO]
| | | | with adaptive start control| [NO]
| | | | with working time limitation| [NO]
| | | | with black bulb sensor| [NO]
Contact details
| Rua dos 5 Caminhos, nº516 | 4780-382 Argemil Santo Tirso | Porto, Portugal | Tef:252910350
GENERAL WARRANTY TERMS
- The warranty is valid only on the presentation of the invoice of purchase.
- This WARRANTY is limited exclusively to parts substitution ineffective due to faulty manufacture, made in our workshops.
- The elimination of several faults of the scope of the guarantee is made for repair or replacement of defective parts, according to the discretion of our technical services. Defective parts are our property.
- Are not covered under warranty damage caused by transportation, neglect or poor use, improper assembly or installation, as well as external influences such as lightning strikes or power, flooding, humidity, etc..
- Lose warranty, all appliances that are not being used according to the instructions, or connected to FEEDING NETWORKS do not guarantee a constant voltage of 220/240V.
- The warranty does not cover damages for personal injury or damage caused directly or indirectly in any capacity whatsoever.
- This warranty terminates when it is found to have been undergoing repairs, alterations, or interventions by any person not authorized by Jocel.
THE WARRANTY EXPIRES
- If the appliance has not been installed by an Accredited Technician.
- Exceeded the period of 2 years for home appliances and 06 months for industrial appliances, the warranty expires and assistance will be made by charging the costs of manpower, according to current fees.
- With the modification or disappearance of the nameplate of the appliance.
TECHNICAL ASSISTANCE
For technical assistance requests, our services are available through the following contacts:
- Telef. 00 351 252 910351
- Fax: 00 351 252 910367
- E-mail: assistencia@jocel.pt
- http://www.jocel.pt
SEDE
- Rua Alto do Curro, n.º 280
- 4770-569 S. COSME DO VALE
- V.N. de FAMALICÃO
- Telef: 252 910 350/2
- Fax: 252 910 368/9
- email: jocel@jocel.pt
- http://www.jocel.pt
DECLARATION OF CONFORMITY
We declare on our own responsibility that the machine indicated below
- Product: ELECTRIC FIREPLACE
- Brand: JOCEL
- Model: JSE013422
Complies with the following European directives and standards implementation
- Low Voltage: 2014/35/EU EN 60335-2-30:2009+A11:2012
- EN 60335-1:2012+A11:2014+A13
- :2017+A1:2019+A14:2019+A2:2019
- EN 62233:2008
- Electromagnetic Compatibility: 2014/30/EU EN 55014-1:2017
- EN IEC 61000-3-2:2019
- EN 61000-3-3:2013+A1:2019
- EN 55014-2:2015
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>