Martec MLXS524WS LED Floodlight with Sensor Installation Guide
- June 5, 2024
- martec
Table of Contents
Lighting
MLXS524WS LED Floodlight with Sensor
Quick Installation Guide
| 
| 
---|---|---
Switch off the power before installing the fixture| Select installation area
and in stall between 2 meters – 3 meters above the ground| Feed the power
cable through the base cover Bracket and mount the base cover Bracket onto the
wall
| 
| 
---|---|---
Feed wires through the backplate seal and connect the wires to the terminal
block “Brown to Brown (Live) and Blue to Blue (Neutral) ” Note: an earth or
ground wire is not required as the fixture is double insulated in design.|
Align the light fixture with the base cover and ensure the backplate seal is
in place before tightening the Light fixture to the basecover using the base
cover screws and cover the screw heads with the decorative screw covers|
Switch the power back on to the fixture. A noticeable green LED light will
flicker on and off for 1 minute inside the sensor lens that indicates the warm
up process. On completion the green LED light will become stable. The fixture
has a built-in photocell to automatically become functional and active during
dusk Might time .To do a walk test after installation, push theSW4 button and
hold for 2 seconds—The LED light will turn on and rotate towards sensor
detection and after 3 minutes the LED light will automatically turnoff and
become active during night/ dusk time operations.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>