PJ MASKS 2140423TX Gekko Mobile 2.4 GHz Remote Control Cat Car Instructions
- June 5, 2024
- PJ MASKS
Table of Contents
2.4 GHz RADIO CONTROL
INSTRUCTION GUIDE
IF YOU HAVE QUESTIONS OR DIFFICULTY OPERATING THIS TOY
DO NOT RETURN IT TO THE STORE
CALL US TOLL-FREE: 1-855-886-JAMN (5266)
MONDAY – FRIDAY BETWEEN 9:00 AV – 5:00 PM PACIFIC STANDARD TIME OR EMAIL US
AT:
GUSTOMERSERVICE@JAMNPRODUCTS.COM
THIS DEVICE COMPLIES WITH 111TH PART 15 OF THE FCC RULES. OF OPERATION IS SU3JECT TO THE FOLLOWING TWO CONDITIONS:
- THIS DEVICE MAY NOT CAUSE -HARMFUL INTERFERENCE. AND
- TI-IS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED. INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
WARNING: CHOKING HAZARD — Smal parts. Not for children under 3 years ****
BATTERY INSTRUCTION
CONTROLLER
HOW TO PAIR THE CONTROLLER TO THE VEHICLE BEFORE PLAY
HOW TO PAIR
- INSERT BATTERIES (CAR AND CONTROLLER).
- TURN CAR & CONTROLLER SWITCH TO “ON.”
- PRESS AllY BUTTON ON THE CONTROLLER FOR 2 TO 3 SECONDS.
- PAIRING SHOULD BE SUCCESSFUL.
- IF YOU NEED TO PAIR MORE CARS WITH SEPARATE CONTROLLERS AT THE SAME TIME, THEY MUST BE PAIRED 3 METERS APART FROM EACH OTHER.
HOW TO RESET PAIRING
- TURN CAR & CONTROLLER SWFCH TO “OFF.”
- TURN CAR & CONTROLLER SWFCH TO “ON” AFTER 2 TO 3 SECONDS.
- PRESS ANY BUTTON ON THE CONTROLLER FOR 2 TO 3 SECONDS.
- PAIRING SHOULD BE SUCCESSFUL.
USING THE CONTROLLER
FORWARD
PRESS TOP ARROW BUTTONS “1” AND “3” AT THE SAME TIME TO WHEELIE / MOVE
FORWARD. 
REVERSE
PRESS THE BOTTOM ARROW BUTTONS “2” AND “4” AT THE SAME TIME TO REVERSE.
SPINNING
PRESS ARROW BUTTONS “1” AND “4” TO MOVE FORWARD / SPIN LEFT.| PRESS ARROW
BUTTONS “2” AND “3” TO MOVE FORWARD / SPIN RIGHT.
---|---
USING THE CONTROLLER
TURNING
PRESS ARROW BUTTON “1” TO MOVE FORWARD/TURN LEFT.| PRESS ARROW BUTTON “3” TO
MOVE FORWARD/TURN RIGHT.
---|---
PRESS ARROW BUTTON “2” TO MOVE IN REVERSE/TURN LEFT.| PRESS ARROW
BUTTON “4” TO MOVE IN REVERSE/TURN RIGHT.
---|---
BATTERY SAFETY INFORMATION
- DO NOT MIX OLD AND NEW BATTERIES.
- DO NOT MIX ALKALINE, STANDARD (CARBON-ZINC), OR RECHARGEABLE (NICKEL-CADMIUM) BATTERIES.
- ONLY BATTERIES OF THE SAME OR EQUIVALENT TYPE AS RECOMMENDED ARE TO BE USED.
- BATTERIES ARE TO BE INSERTED WITH THE CORRECT POLARITY.
- EXHAUSTED BATTERIES ARE TO BE REMOVED FROM THE PRODUCT.
- REMOVE BATTERIES IF THE PRODUCT IS TO BE LEFT UNUSED FOR A LONG TIME.
- THE SUPPLY TERMINALS ARE NOT TO BE SHORT-CIRCUITED.
- NON-RECHARGEABLE BATTERIES ARE NOT TO BE RECHARGED.
- RECHARGEABLE BATTERIES ARE TO BE REMOVED FROM THE PRODUCT BEFORE BEING CHARGED.
- RECHARGEABLE BATTERIES ARE ONLY TO BE CHARGED UNDER ADULT SUPERVISION.
- DISPOSE OF BATTERIES) SAFELY.
- DO NOT DISPOSE OF THIS PRODUCT IN A FIRE. THE BATTERIES INSIDE MAY EXPLODE OR LEAK.
- BATTERIES SHOULD BE CHARGED BY ADULTS ONLY.
VEHICLE OPERATION
ANY OF THE FOLLOWING CONDITIONS MAY INTERFERE WITH THE BEHAVIOR AND FUNCTION.
THE TRANSMITTER SIGNALS CAN EASILY BE INTERRUPTED.
IMPROPER HANDLING MAY HAMPER THE PERFORMANCE OF THE VEHICLE.
SAFETY PRECAUTIONS
REMEMBER TO AVOID WATER, HEAT, SAND, AND HIGH IMPACT!
- KEEP VEHICLES AWAY FROM WET SURFACES OR RAIN.
- AVOID RUNNING ON THICK CARPETS OR DUSTY FLOORS.
- AVOID COLLISIONS ON HARD SURFACES.
- KEEP VEHICLES AWAY FROM SANDY OR DUSTY AREAS.
- DO NOT OPERATE YOUR VEHICLE ON THE STREETS!
CAUTION
CHANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY APPROVED BY THE PARTY
RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE
EQUIPMENT.
NOTE
THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS
B DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE
DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A
RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES, USES, AND CAN RADIATE
RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE
INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS.
HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A
PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO
RADIO OR TELEVISION RECEPTION, V/HICH CAN BE DETERMINED BY TURNING THE
EQUIPMENT OFF AHD 011, THE USER IS ENCOURAGED TO TRY TO CORRECT THE
INTERFERENCE BY ONE OR MORE OF THE FOLLOWING MEASURES:
- REORIENT OR RELOCATE THE RECEIVING ANTENNA,
- INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.
- CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED.
- CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP.
THIS DEVICE CONTAINS LICENSE-EXEMPT TRANSMITTER(S)/RECEIVER(S) THAT COMPLY WITH INNOVATION, SCIENCE, AND ECONOMIC DEVELOPMENT CANADA’S LICENSE-EXEMPT RSS(S). OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
- THIS DEVICE MAY NOT CAUSE INTERFERENCE.
- THIS DEVICE MUST ACCEPT ANY INTERFERENCE. INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION OF THE DEVICE. ” THIS DEVICE AND ITS ANTENNA MUST NOT BE CO-LOCATED OR OPERATING IN CONJUNCTION WITH ANY OTHER ANTENNA OR TRANSMITTER.
THIS RADIO COMMUNICATION DEVICE COMPLIES WITH ALL THE REQUIREMENTS OF INDUSTRY
CANADA STANDARD RSS-210.
REQLF1ES 4 X AA LR6) AND 1 X 9V (6LR61) ALKALINE BATTERIES (NOT INCLUDED).
BATTERIES OR BATTERY PACKS MUST BE RECYCLED OR DISPOSED OF PROPERLY. WHEN THIS
PRODUCT HAS REACHED THE END OF ITS USEFUL LIFE IT SHOULD NOT BE DISPOSED OF
WITH OTHER HOUSEHOLD WASTE. THE WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
REGULATIONS REQUIRE IT TO BE SEPARATELY COLLECTED SO THAT IT CAN BE TREATED
USING THE BEST AVAILABLE RECOVERY AND RECYCLING TECHNIQUES. THIS WILL MINIMIZE
THE IMPACT ON THE ENVIRONMENT AND HUMAN HEALTH FROM SOIL AND WATER
CONTAMINATION BY ANY HAZARDOUS SUBSTANCES. DECREASE THE
RESOURCES ARE REQUIRED TO MAKE NEW
PRODUCTS AND AVOID USING UP LANDFILL SPACE. PLEASE DO YOUR PART BY KEEPING
THIS PRODUCT OUT OF THE MUNICIPAL WASTE STREAM! THE “WHEELIE BIN” SYMBOL MEANS
THAT IT SHOULD BE COLLECTED AS “WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT.”
YOU CAN RETURN AN OLD PRODUCT TO YOUR R: TAILER WHEN YOU BUY A SIMILAR NEW
ONE. FOR OTHER OPTIONS, PLEASE CONTACT YOUR LOCAL COUNCIL
MADE IN CHINA
MEETS CPSC SAFETY REQUIREMENTS
MANUFACTURED BY JAWN PRODUCTS INC.
• 4199 BANDINI BLVD. SUITE A LOS ANGELES,
CALIFORNIA 90058
WWW.JAMNPRODUCTS.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>