BaByliss ST280E Sleek Control 230 Instruction Manual
- June 5, 2024
- BaByliss
Table of Contents
BaByliss ST280E Sleek Control 230
Read the safety instructions first
BaByliss Diamond Ceramic is a high-density ceramic coating for professional use. The perfect glide and heat-transfer qualities guarantee softness, shine and protection of the hair.
PRODUCT FEATURES
- BaByliss Diamond Ceramic professional plates: 45 mm x 120 mm
- On/off switch – Automatic switch off
- LED indicator light
- i-Temperature Technology – Immediate heat-up – Perfectly stable temperature
- Temperature selector: 15 temperature levels
- Floating plates: to make gliding and handling of the straightener easier by applying constant pressure on the hair without damaging it
- Swivel cord
- Heat-resistant insulating mat
USE
- Untangle hair thoroughly. Clip the upper layers out of the way, so that you can start with the underneath sections.
- Plug in the appliance and switch on.
- Use the temperature selector to select the desired temperature.
As a rule, we recommend using a lower temperature for fine, bleached and/or damaged hair, and a higher temperaturefor curly, thick and/or difficult-to- style hair. All hair is different. We recommend using the lowest temperature at first use. Thereafter, you can gradually increase the setting if necessary. As a rough guide, see the table below:
| Temperature | Hair type |
|---|
150 – 170 °C
| Fine, bleached and/or damaged hair
170 – 200 °C
| Normal, coloured and/or wavy hair
200 – 230 °C| Thick and/or very curly hair
- The indicator light flashes until the desired temperature is reached.
- Start straightening the underneath sections of hair. Take a section of about 5 cm width and plac it between the 2 hotplates, being careful to avoid touching the hot surface of the appliance with your hand. Hold the hair firmly with the straightener and slide slowly along from the roots to the ends. Repeat again if necessary.
- Let the hair cool down before you comb it.
- After use, switch off and unplug the appliance. Allow the appliance to cool before storing.
Notes:
- The first time you use the unit, you may notice a little steam and a particular odour: this is common and will disappear by the next use.
- When you are straightening, you may see some steam.
- Do not be concerned, this could be due to evaporation of natural oils, residual hair products (leave-in hair products, hairspray, etc.) or excess moisture in the hair.
- Always select a lower temperature for the first use.
- A heat protection spray is recommended, to provide optimal protection of the hair.
- If straightening is not effective enough, tighten the plates more firmly on your section of hair and let the appliance glide more slowly.
AUTO SHUT-OFF
If the appliance is left switched on for more than 72 minutes at a time, it will automatically shut off.
MAINTENANCE
- Unplug the appliance and allow to cool completely.
- Clean the plates using a soft, dampened cloth, without soap, to preserve the optimal quality of the plates. Do not scratch the plates.
- To protect the plates, store the straightening iron with the plates closed tightly
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>