SUNGROW AC011E-01 Solar AC Charger Installation Guide

June 4, 2024
SUNGROW

SUNGROW AC011E-01 Solar AC Charger

SAFETY WARNING

  • The contents of the document will be periodically updated or revised due to the product development. It is probably that there are changes of document in the subsequent edition. Under no circumstances can this document replace the user manual and the safety instructions on the product.
  • Please read the user manual and relevant standards and specifications carefully before performing any operation. You can get the information by logging in Sungrow support platform via http://support.sungrowpower.com/ or scanning the QR code on the side of the product or on the back cover of the quick installation instruction.
  • All operations shall only be performed by professional personnel. Professional personnel must be trained specially, read this instruction thoroughly, master the safety instructions related to operation and be familiar with the local standards and safety regulations of electrical system.
  • Before installing the equipment, check whether the goods are complete and consistent with the order, and whether there is obvious damage according to the packing List. Contact the shipping company or SUNGROW directly in case of any damage or incompleteness.
  • Cables used for the charger must be intact and well insulated. Use insulation tools and wear personal protective equipment.
  • Violation of any of the above requirements may cause casualties or equipment damage.

SAFETY STATMENT
Failure to comply with the requirements of this document and the user manual may cause casualties or equipment damage, and Sungrow shall not assume any liability.

DANGER
High voltages are present during operation and could cause electrical shock, resulting in death, serious personal injury, or property damage.
Non-professional personnel shall not disassemble the components.

CAUTION
Keep the charger away from flammable and explosive substances. Store it in a dry, clean, and well-ventilated place, free from harmful gases. Do not store it near the corrosive objects.

NOTICE

  • During transport, the charger shall be securely packed and marked in the loading direction in a wooden box, and the charger shall not be stored upside down.
  • During transport, tighten the equipment to avoid violent shaking and bumps that damage the package.
  • After the arrival of goods, check for transport damage and, if any, contact the shipping company or us.
  • Check if the devices inside the package are the same as that of the delivery list.

Scope of delivery

Tools

Mounting place

Dimensions and weight

Cable connection/Anschluss des Kabels

Note : cable shall be connected before the charger is installed. Cable cross section: 5×2.5mm2

Wall-mounted charger installation

Before drilling, avoid the water and electricity wiring in the wall to prevent hazards. The drill size isΦ6mm and the drilling depth is about 45mm.The bearing capacity of the installation carrier shall be at least 4.5 times that of the charger!

Pile-mounted charger installation (optional)
The drill size isΦ12mm and the drilling depth is about 85mm.

Inspection before commissioning

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals