LUCIDE 78396 JERREL Pendant Light Instruction Manual
- June 5, 2024
- LUCIDE
Table of Contents
LUCIDE 78396 JERREL Pendant Light
Safety Instructions
Please read this notice carefully and keep it during the lifetime of this
product. Follow the instructions for a safe and correct instal-lation and
functioning of the light fixture. The manufacturer does not accept any
responsibility for damage caused by improper installation and service.
Installation should always be done by a qualified electrician.
Always isolate the power before commencing installation, maintenance or
repair.
In case of doubts, please contact a qualified electrician.
Please pay attention to locations where the item can be installed (indoor,
outdoor, bathroom (for outdoor and bathroom installa-tion, please see
further). Indoor items cannot be used in humid places. Do not put the item in
contact with water or any liquids or inflammable products. Always respect the
minimal distance (indicated on the light) to inflammable products.
During installation, make sure that the cables will not be squeezed or damaged
by sharp edges. If the external flexible cable is damaged, it needs to be
replaced exclusively by the manufacturer, his service agent, or a qualified
electrician.
This is to avoid all risks.
Because the temperature of the item and the bulbs can get very high, they must
cool down before being touched. Always use the correct bulb (respect type and
maximal wattage as indicated on the product).
Explanation of the symbols which can appear on the fixture
-
This item is only suitable for indoor use, exclusive bathroom (except if a higher IP degree permits that the item can be used in the bathroom).
-
Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling. Electrical and electronic equipment marked with this symbol indicating separate collection of such equipment must be returned to a municipal waste collection point.
-
Class I: The item has an earth connection. The earth wire (green-yellow) needs to be connected to the earth connection (marked with this symbol).
-
Class II: The item is double insulated and must not be connected to the earth wire.
-
Class III: The item is only suitable for lower voltage supply and must not be connected to the earth wire.
-
IP 20: Protection against contact with a finger
-
If the protection glass is damaged or broken, it needs to be replaced immediately.
-
Please respect the minimum distance from the bulb to inflammable objects.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>