PHILIPS PDEG Ethernet Gateway Instruction Manual
- June 4, 2024
- Philips
Table of Contents
PDEG Ethernet Gateway
**Instruction Manual
**
PDEG Ethernet Gateway
Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
|
---|---
|
Do not connect inputs to mains.
Caution – the risk of explosion if the battery is replaced by an incorrect
type.
Federal Communications Commission (FCC) Compliance
Notice: Radio Frequency Notice
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any modifications not approved by the manufacturer of this device could void
the user’s authority to operate this device.
Installation of a home and building automation and control system shall comply
with IEC 60364 (all parts). The temperature limits and current-carrying
capacities for the communication wires specified in IEC 60364-5-52 shall not
be exceeded.
© 2022 Signify Holding. All rights reserved. Specifications are subject to
change without notice. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for
any action in reliance thereon is disclaimed. Philips and the Philips Shield
Emblem have registered trademarks of Koninklijke Philips N.V. All other
trademarks are owned by Signify Holding or their respective owners.
www.lighting.philips.com/dynalite
AZZ 418 0622 R19
Documents / Resources
|
PHILIPS PDEG Ethernet
Gateway
[pdf] Instruction Manual
PDEG, Ethernet Gateway, PDEG Ethernet Gateway, PDEG II-R19
---|---
|
PHILIPS PDEG Ethernet
Gateway
[pdf] Installation Guide
PDEG Ethernet Gateway, PDEG, Ethernet Gateway, Gateway, PDEG Gateway
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>