MEMPHIS AUDIO VIV35CV2 Component Speaker Set Instruction Manual
- June 4, 2024
- MEMPHIS AUDIO
Table of Contents
- Features
- Woofer Technical Information
- Tweeter Technical Information
- Crossover Technical Information
- Installation
- Crossover Network
- Speaker Placement
- Tweeter Installation
- SIX FIVE SERIES WARRANTY
- Length of Warranty
- How To Obtain Service
- WIRING COMPONENTS
- Crossover Adjustments
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
AUDIO VIV35CV2 Component Speaker Set
Instruction Manual
Features
- Cast aluminum Six Five Series basket
- Dual layer composite fiber cone
- Tuned surround for extra flat response
- Audiophile-grade features and performance
- Aluminum housed silk tweeter
- Grill included
Woofer Technical Information
Woofer Size | 3.5” |
---|---|
RMS Power | 50 |
PEAK Power | 100 |
Impedance | 2Ω |
Sensitivity (dB) | 86 |
Magnet Size (oz) | 6 |
Mounting Depth (in) | 1.64 |
Frequency Response | 100Hz-20kHz |
Basket Material | Aluminum |
Cone Material | Fiberglass & Foam Composite |
Dust Cap Material | Aluminum Bullet |
Surround Material | Rubber |
Tweeter Technical Information
Dome Material | Silk |
---|---|
Dome Diameter | 1.45in // 37mm |
Voice Coil Diameter | .98in // 25mm |
Crossover Technical Information
Crossover Type | 2 Way |
---|---|
Tweeter Crossover Freq & Slope (High Pass) | 7Khz, 12dB |
Woofer Crossover Freq & Slope (Low Pass) | 6kHz, 12dB |
Woofer Crossover Freq & Slope (High Pass) | 180Hz/100Hz, 12dB |
Installation
Prior to setting up your audio system, disconnecting the negative battery
terminal from your vehicle is advised.
Prior to cutting or drilling screws, please take time to check clearances on
both sides of the mounting surface. Be mindful of any potential obstacles such
as window tracks and motors. Some vehicles are not symmetrical making it
imperative to double-check both sides of the vehicle.
Crossover Network
Always mount your crossovers in a location free from moisture and away from moving parts. Crossovers should not be mounted inside door compartments if possible as doors are not always watertight and moisture may damage your crossover. Your Crossover must be connected as shown in this manual, failure to follow these connections may void your warranty and potentially damage your system and vehicle. Failure to properly install the crossovers may void your warranty. If you are uncomfortable with any of the installation steps it is advised that you contact your local Memphis Audio dealer.
Speaker Placement
A properly installed component system will yield the best sound for a vehicle. Failure to properly place your component system can severely hinder your system’s performance. A Memphis Audio dealer should be consulted to properly position your vehicle’s components for the best possible performance. Ideally, the tweeter and woofer should be installed free from obstacles impeding sound from freely traveling throughout the vehicle. Woofers should be mounted lower in the vehicle while tweeters typically perform better in a more elevated position. Prior to cutting any holes or making any alterations to your vehicle, test fit the woofers in the factory mounting locations to confirm that they clear any obstacles such as window tracks, wire harnesses, etc. If you are mounting the woofers into a nonfactory location check both sides of the vehicle for obstacles prior to cutting or altering your vehicle in any way. A speaker cut-out template is provided in the box along with this product, again do not rely solely on the template, be certain to test fit and measure both sides of the vehicle prior to altering your vehicle. To test the tweeters prior to committing to a mounting location you can simply install the rest of your system and position your tweeters in various locations using double-sided tape until you find an ideal location.
Tweeter Installation
Tweeters should be positioned high, preferably near ear level. Optimum
performance will be obtained when tweeters are angled toward the listener.
The least conspicuous tweeter mounting option is a flush mount. The recessed
design provides superior protection for the tweeter and it blends with the
interior of your vehicle.
To mount the tweeter cut a hole in the desired panel. Slide the tweeter into
place. Use the included screw and backer bracket to tighten the tweeter into
place. The final installation should look like the above image.
TWEETER CUT OUT DIAMETER & DEPTH:
Cut Out Diameter: 1.75”
Mounting Depth: 0.53”
SIX FIVE SERIES WARRANTY
Memphis Car Audio offers a limited warranty on Memphis Car Audio products on the following terms:
Length of Warranty
SixFive Series Component Speakers – 2 Year
Ask your installing dealer about warranty extensions that may be available.
What Is Covered
This warranty applies only to Memphis Car Audio products sold to consumers by
Authorized Memphis Car Audio Dealers in the United States of America or its
possessions.
Who Is Covered
This warranty covers only the original purchaser of the Memphis Car Audio
products purchased from an Authorized Memphis Car Audio Dealer in the United
States. In order to receive service, the purchaser must provide Memphis Car
Audio with a copy of the receipt stating the consumer name, dealer name,
product purchased, and date of purchase. Products found to be defective
during the warranty period will be repaired or replaced (with a product deemed
to be equivalent) at Memphis Car Audio’s discretion.
What Is Not Covered
- Damage caused by accident, abuse, improper operation or installation, water, theft, or shipping.
- Any cost or expense related to the removal or re-installation of the product.
- Service performed by anyone other than Memphis Car Audio.
- Any product which has had the serial number defaced, altered, or removed.
- Subsequent damage to other components.
- Any product purchased outside the US.
- Any product not purchased from an authorized Memphis Car Audio Dealer.
Limit on Implied Warranties
Any implied warranties including warranties of fitness for use and
merchantability are limited in duration to the period of the express warranty
set forth above. Some states do not allow limitations on the length of an
implied warranty, so this limitation may not apply. No person is authorized to
assume for Memphis Car Audio any other liability in connection with the sale
of the product.
EU Warranty
This product meets the current EU warranty requirements. See your Authorized
dealer for details.
How To Obtain Service
Contact the Authorized Memphis Car Audio Dealer you purchased this product
from.
If you need further assistance, call
1-800-489-2300 for Memphis Car Audio’s
Customer Service.
YOU MUST OBTAIN A RETURN AUTHORIZATION (RA#) TO RETURN ANY PRODUCT TO MEMPHIS
CAR AUDIO’S WARRANTY FACILITY. NO PRODUCT WILL BE ACCEPTED WITHOUT THIS
RETURN AUTHORIZATION!
You are responsible for the shipment of products to Memphis Car Audio.
Repaired and replaced products will be returned freight prepaid.
FOR MORE INFORMATION, PLEASE VISIT:
WWW.MEMPHISCARAUDIO.COM
WIRING COMPONENTS
Crossover Adjustments
VIV35CV2 Crossovers use switches to adjust a variety of features allowing the user to dial in the perfect sound for their audio system.
Tweeter Adj. +/-3 dB Tweeter Adjustment
VIV
SIX FIVE SERIES
a half century in the making… CONTACT INFO
122 GAYOSO AVE, MEMPHIS, TN 38103
SHOW US YOUR INSTALLATION & FOLLOW US TODAY!
WWW.MEMPHISCARAUDIO.COM
@MEMPHISCARAUDIO
@MEMPHISCARAUDIOUSA