V2 SPA V2 PHOX Personal Pass Transmitter Instructions

Table of Contents

Locate the receiver. This will be wired into your motor.
Press the P1 button on the receiver. The L1 LED light will illuminate.
Release the P1 button. The L1 LED light will turn off and will show a sequence of single flashings for 5 seconds. This sequence shows the selected channel.
The following step is most likely NOT required for most users, please continue to step 5. To select the further channels. Press and release the P1 button within 5 seconds. The LED changes type of flashing according to this table.

Selected Channel

| No. of Impulses P1| Flashing
---|---|---
Single| Double| Triple|

Quadruple

Channel 1

| 1| ▪| | |
Channel 2| 2| | ▪ ▪| |

Channel 3

| | ▪ ▪ ▪|
Channel 4| 4| | | |

▪ ▪ ▪ ▪

Choose the channel you want to memorize. Within 5 seconds press and hold the button on the remote that you wish to operate the motor.
The L1 LED light will turn off and on again. This means that the code has been memorized.
If you want to program additional remotes. Please repeat step 5 on each additional remote within 5 seconds.
Please wait 10-20 seconds. Press a button on the newly programmed remote to test you have programmed in successfully.

All remotes programmed using this method will share the same key configuration as the original remote used in this procedure.

Stand within 1-2 metres of the motor.
Press and hold buttons 1 and 2 (the 2 buttons closest to the LED light on the remote) for 6 seconds on your working original remote.
Release both buttons on the original remote.
Within 5 seconds, press and hold the button on the new remote that you wish to program.
Release the button on the new remote after 2-3 seconds.
Repeat steps 2 to 5 to program additional remotes
Please wait 10-20 seconds. Press a button on the newly programmed remote to test you have programmed in successfully.

Switch off the power supply of the control unit where MR1 receiver is connected.
Press and hold the P1 key on the receiver
Continue holding this while you restore power to the receiver.
Once the LED light illuminates, release the P1 key.

Read User Manual Online (PDF format)