BOSCH SPV4HM Genuine Power Module Programmed Dishwashers Instruction Manual

BOSCH SPV4HM Genuine Power Module Programmed Dishwashers

INSTRUCTION MANUAL

Before using for the first time, read the instruction manual and the safety information it contains.

Setting up Home Connect

Tip: Connect your appliance to a mobile device. You can con-veniently change all settings using the Home Connect app.

1. Install the Home Connect app on your mobile device and fol-low the instructions.
2. Scan the QR code with the Home Connect app.

Overview of water hardness settings

You can find an overview of the water hardness values that can be selected here.
A table of country-specific units can be found in the instruction manual.

Setting the water softening system

1. Press ⁠ .
2. To open the basic settings, press SETUP 3 Sec for 3 seconds.

√ The display shows Hxx.

√ The display shows SET

3. Press START repeatedly until the right water hardness has been set.

4. To save the settings, press for 3 seconds.

Programmes

The programme data has been meas-ured in the laboratory according to European standard EN 60436.
The consumption figures depend on the programme and additional func-tion selected.
The running time will change if the rinse aid system is switched off or rinse aid needs to be added.

How to use your appliance

1. Load the tableware.

Only clean tableware that is suitable for dish-washers. Remove large remnants of food from the tableware. Check that the spray arms can rotate freely.

2. Add detergent.
3. Switch on the appliance ⁠.

4. Select the programme.
5. Start the programme

6. Remove the tableware at the end of the programme.

7. To cancel the programme, press approx. 4 seconds.

The programme is cancelled and ends after ap-prox. 1 minute.

Cleaning filters

1. After each wash check the filters for residue.
2. Turn the coarse filter anticlockwise (1) and remove the filter system ⁠(2).

3. Pull down the micro filter to remove.

4. Press the locking catches (1)together and lift the coarse filter out (2)⁠.

5. Clean the filter elements under running water.
6. Re-assemble the filter system.
7. Insert the filter system into the appliance and turn the coarse filter clockwise.
Make sure that the arrow markings match up.

Cleaning spray arms

1. Unscrew the upper spray arms (1) and pull down to remove (2).

2. Pull up the lower spray arm to remove.

3. Check the outlet nozzles on the spray arms for blockages under running water and remove any foreign bodies.
4. Insert the lower spray arm.
a The spray arm clicks into position.
5. Insert the upper spray arms and screw firmly in place.

Clean wastewater pump

1. Disconnect the appliance from the power supply.
2. Remove the filter system.
3. Scoop out any water.
4. Prise off the pump cover using a spoon and grip it by the crosspiece.

5. Lift the pump cover inwards at an angle and remove.
6. Remove any remnants of food and foreign bodies in the area of the impeller.
7. Insert the pump cover (1) and press down (2)⁠.
√ The pump cover clicks into position.

8. Install the filter system.

Troubleshooting

Specifications:

• Model: SPV4HMX65K

• Energy Consumption: Varies depending on the selected programme

• Water Consumption: Varies depending on the selected programme

• Connectivity: Home Connect App

Frequently Asked Questions (FAQ):

Q: How often should I add special salt and rinse aid?

A: Add special salt and rinse aid before starting each new wash cycle.

Q: Can I use any detergent in the dishwasher?

A: Use only detergent specifically designed for dishwashers to avoid damaging the appliance.

Q: What should I do if the dishwasher is not cleaning properly?

A: Check and clean the filters, ensure proper loading of tableware, and use appropriate detergent and rinse aid levels.

Q: How do I know which programme to select?

A: Refer to the programme details in the user manual based on your cleaning needs and load type.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>