Skullcandy Indy Fuel Earbuds User Manual

: June 2, 2024
: Skullcandy

USER MANUAL

Skullcandy Indy Fuel Earbuds

Skullcandy Indy Fuel Earbuds

Auto Pair Mode

Auto Power On

Auto Power off

Auto Power Off

Charge Earbuds

Charge Case

Pairing Mode

Off Mode

Paring Mode

Pair New Device

Indy Fuel

Pair New Device

Power-On

Left Side 01 and Right Side 02

Power-On Left Side 01 and Right Side 02

Power. Off

Left Side 01 and Right Side 02

Power. Off Left Side 01 and Right Side 02

Play/Pause

Left Side 01 or Right Side 02

Play/Pause

Track Forward

Right Side 02

Track Forward

Track Back

Left Side 01

Track Back Left Side 01

VolumeUp

Right Side 02

VolumeUp

Volume Down

Left Side 01

Volume Down

Answer/End

Left Side 01 or Right Side 02

Answer End

Activate Voice Assistant

Left Side 01 or Right Side 02

Activate Voice Assistant

Clear Paired Device

Left Side 01 and Right Side 02

Off Mode

Clear Paired Device

Tile Enabled:

Download the App

Find

Pair Tile

3 EQ Modes

Music, Movies, and Podcast

3 EQ Modes

Ambient Mode

Questions visit: Skullcandy.com

Speaker Driver: 6mm, Impedance: 32 Ohms, THD <3%@1KHz, Voltage Regulation: 5V, 500mA, Bluetooth® 5.0, Frequency Band: 2402MHz – 2480MHz, Maximum Power: 10mw, Weight: 63,5g
Skullcandy, and other marks are registered trademarks of Skullcandy, Inc. All rights reserved,
Maximum operating temperature 45°C.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

ISED Compliance Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

This device may not cause interference
This device must accept any interference, including interference that may cause undesired operation of the device.

ISED SAR Compliance Statement

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.

Americas Skullcandy, Inc. 6301 N Landmark Dr. Park City, UT 84098 U.S.A. Skullcandy.com

Europe Skullcandy Europe BV Postbus 425 5500AK Veldhoven Nederland

Contains Li-ion battery. Battery must be recycled or disposed of properly.

Made in China

MODEL: S2IFW

FCC ID Y22 S2IFW

IC 10486A-S2IFW

Standard