PHILCO PHMF 1050 Milk Frother User Manual

PHILCO PHMF 1050 Milk Frother

IMPORTANT SAFETY INSTRUCTIONS

1. Read all instructions before using.

2. Before connecting the appliance to the power supply, check that the voltage indicated on the appliance corresponds with the voltage in your home. If this is not the case, contact your dealer and do not use the kettle.

3. The attached base can not be used for other than the intended use.

4. Do not operate the appliance without anything in it to avoid damaging the heat elements.

5. Unplug from the outlet when not in use and before cleaning. Allow cooling before putting on or taking off parts, and before cleaning the appliance.

6. Do not let the cord hang over the edge of a table or counter or touch a hot surface.

7. Do not place on or near a hot gas or electric burner or in a heated oven..

8. Ensure that the appliance is used on a fi rm and fl at a surface out of reach of children, this will prevent the appliance from overturning and prevent damage or injury.

9. Keep hands and utensils out of the container while blending to reduce the risk of severe injury to persons or damage to the blender.

10. To protect against a fi re, electric shock or personal injury, do not immerse cord, electric plugs, jar or base in water or other liquids.

11. Close supervision is necessary when any appliance is used by or near children.

12. Do not touch the hot surface. Use the handle or the button.

13. Extreme caution must be used when moving an appliance containing hot water.

14. Avoid contacting moving parts.

15. The use of attachments not recommended or sold by the manufacturer may cause fi re, electric shock or injury.

16. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair or electrical or mechanical adjustment.

17. The appliance only used for frothing and heating milk. Do not use the appliance for other than intended use.

18. This appliance has been incorporated with a grounded plug. Please ensure the wall outlet in your house is well-earthed.

19. T his appliance can be used by children aged from
    8 years and above if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised.Keep the appliance and its cord out of reach of children less than 8 years. The appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.

20. Always operate the appliance with cover in place.

21. Never place this appliance on or near a hot gas or an electric burner or where it could touch a heated appliance.

22. This appliance is intended to be used in household and similar applications such as:

    • Staff kitchen areas in shops, offi ces, and other working environments;
    • Farm houses;
    • By clients in hotels, motels and other residential-type environments;
    • Bed and breakfast type environments.

23. If the supply cord is damaged,it must be replaced by
    the manufacturer, its service agent or similarly qualifi ed persons in order to avoid a hazard.

24. The instructions for appliances normally cleaned after use,and not intended to be immersed in water for cleaning,shall state that the appliance must not be immersed.

25. Children should be supervised to ensure that they do not play with the appliance.

26. Do not use outdoors.

27. Save these instructions.

KNOW YOUR MILK FROTHER

BEFORE THE FIRST USE
The appliance can be used for fi nishing the following tasks separately: I. frothing and heating milk; II. only frothing separately, without heating; III. only heating separately, without frothing.

1. Before using your milk frother, clean all the parts according to the section “CLEANING AND MAINTENANCE”.
2. Important: do not wash any parts in the dishwasher, and do not immerse the jar in water. This may permanently damage the product and void the warranty.
3. The appliance is equipped with two accessories of mixing paddle and a frothing paddle, the mixing paddle is used for mixing milk during heating to prevent from sticking. The frothing paddle is used for frothing milk during heating or is used for frothing separately, but no heating. Select desired accessory according to your task.
   NOTE: The max capacity of the jar is 450ml.

OPERATION OF YOUR MILK FROTHER

Frothing and heating

1. Place the appliance on a fl at the surface.

2. Select the frothing paddle, then open the lid and insert the frothing paddle onto the shaft on the bottom of jar.

3. Fill the jar with the desired amount of milk (the initial temperature of milk is 5-10°C), and replace the lid.
   NOTE: The max milk quantity permitted to add is 100ml, to avoid milk overfl owing after frothing.

4. Place the jar on the power base and connect the plug into a power outlet, the indicator will light red.

5. Press the switch button once, the indicator will light blue. Then the appliance will start to work. Once the temperature of milk has achieved about 65±10°C), the heating element will stop heating and the frothing paddle will stop rotating automatically; the indicator will illuminate red again until unplugging the power outlet.
   NOTE: During operation, you can stop operating by pressing the switch button once.

6. When the appliance has stopped operating, open the lid, pour out the warmed and frothed milk to enjoy it.
   CAUTION: Minimum 3 minutes rest time must be maintained between two continuous cycles, otherwise, the appliance will enter a self-protection state automatically after working for 5 cycles continuously, the indicator will be illuminated blue and fl ash, the switch button will not be activated, after about 5 minutes, the appliance will enter standby state and you can continue operating the appliance.

7. Always turn off the milk frother and disconnect the power supply when not use.

Only frothing separately, without heating

1. According to the 1-4 steps in the section of “Frothing and heating”.

2. Press and hold the switch button for 2s, the indicator will illuminate blue and blink, the frothing paddle will rotate for frothing milk separately, but the heating element will not heat.
   And the appliance will automatically stop rotating after operating. The indicator will illuminate red again until unplugging the power outlet.
   NOTE: During operation, you can stop operating by pressing the switch button once.

3. When the appliance has stopped operating, open the lid, pour out the frothed milk and enjoy it.
   CAUTION: Minimum 3 minutes rest time must be maintained between two continuous cycles, otherwise, the appliance will enter a

4. self-protection state automatically after working for 5 cycles continuously, the working indicator will fl ash and the switch button will not be activated, after about 5 minutes, the appliance will enter standby state and you can continue operating the appliance.

5. Always turn off the milk frother and disconnect the power supply when not use.

Only heating separately, without frothing.

1. Place the appliance on a fl at the surface.

2. Select a mixing paddle according to your task. Then open the lid, and insert the mixing paddle onto the shaft on the bottom of jar.

3. Fill the jar with the desired amount of milk (the initial temperature of milk is 5-10°C), and replace the lid.
   NOTE: the max milk quantity permitted to add is 200ml, to avoid milk overfl owing after mixing or frothing.

4. Place the jar on the power base and connect the plug into a power outlet. The indicator will illuminate red.

5. Press the switch button once, the indicator will light blue. Then the appliance will start to work. Once the temperature of milk has achieved about 65±10°C, the heating element will stop heating and the mixing paddle will stop rotating automatically; the indicator will illuminate red again until unplugging the power outlet.
   NOTE: The rotation of the mixing paddle is only used for avoiding sticking. It will not froth the milk.

6. When the appliance has stopped operating, open the lid, pour out the warm milk and enjoy it.
   CAUTION: Minimum 3 minutes rest time must be maintained between two continuous cycles, otherwise, the appliance will enter a self-protection state automatically after working for 5 cycles continuously, the indicator will be illuminated blue and fl ash, the switch button will not be activated, after about 5 minutes, the appliance will enter standby state and you can continue operating the appliance.

7. Always turn off the milk frother and disconnect the power supply when not use.

CLEANING AND MAINTENANCE

Always disconnect the appliance from the power outlet and allow it to cool down before cleaning.
CAUTION: Never immerse the jar, or power base in water, or allow moisture to contact with these parts.

1. Wash lid with water and mild detergent. The lid is not a dishwasher-safe component. Rinse thoroughly and dry.
2. Remove the mixing paddle or frothing paddle, and wash them completely in warm water.
3. Wash the inner of jar with a combination of mild detergent and water and then wipe clean with a soft damp cloth.
4. Wipe the appearance of jar with a soft damp cloth or cleaner, never use a poisonous cleaner.
   Note: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of the appliance to prevent gloss loss.

ENVIRONMENT-FRIENDLY DISPOSAL
You can help protect the environment! Please remember to respect the local regulations: hand in the non-working electrical equipment to an appropriate waste disposal center.

INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING MATERIALS
Dispose of packaging material at a public waste disposal site.

DISPOSAL OF USED ELECTRICAL AND ELECTRONIC APPLIANCES
The meaning of the symbol on the product, its accessory or packaging indicates that this product shall not be treated as household waste. Please, dispose of this product at your applicable collection point for the recycling of electrical & electronic equipment waste. Alternatively in some states of the European Union or other European states you may return your products to your local retailer when buying an equivalent new product. The correct disposal of this product will help save valuable natural resources and help in preventing the potential negative impact on the environment and human health, which could be caused as a result of improper liquidation of waste.
Please ask your local authorities or the nearest waste collection center for further details.
The improper disposal of this type of waste may fall subject to national regulations for fi nes.

For business entities in the European Union
If you wish to dispose of an electrical or electronic device, request the necessary information from your seller or supplier.

Disposal in other countries outside the European Union
If you wish to dispose of this product, request the necessary information about the correct disposal method from local government departments or from your seller.
This product meets all the basic EU regulation requirements that relate to it.

Changes to the text, design and technical specifi cations may occur without prior notice and we reserve the right to make these changes.
Czech is the original version.
Address of the manufacturer: PHILCO, Praha 10, Černokostelecká 2111, CZ-10000; CZECH REPUBLIC

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>