Panasonic EH-NE27 Hair Dryer Instruction Manual
- June 3, 2024
- Panasonic
Table of Contents
- Panasonic EH-NE27 Hair Dryer
- Safety precautions
- WARNING
- Parts identification
- How to use
- About ion (EH-NE27 only)
- About Heat Protection
- About Scalp Care
- Maintenance
- Maintaining the air inlet
- Maintaining the air outlet
- Maintaining the ion outlet (EH-NE27 only)
- Maintaining the hair dryer
- Troubleshooting
- Specifications
- Documents / Resources
Panasonic EH-NE27 Hair Dryer
Safety precautions
Make sure to follow these instructions. To prevent accidents, injuries or damage to property, please follow the instructions below.
WARNING: Indicates potential hazard that could result in serious injury
or death.
CAUTION: Indicates potential hazard that could result in minor injury or
property damage. Some parts of the safety precaution illustrations differ from
the actual product.
WARNING
Plug and Cord
- Do not use with the cord bundled.
- Do not damage the cord or plug.
- Do not deface, modify, forcefully bend or pull the cord or plug. Also, do not place anything heavy on, twist or pinch the cord.
- Do not use when the plug or cord is damaged or hot.
- Do not wrap the cord tightly around the main body when storing.
- Do not store or use the cord in a twisted state.
- Disconnect the plug by holding onto it instead of pulling on the cord.
- Always turn off the power switch and disconnect the plug from the household outlet after use.
- Insert the plug into the household outlet directly:
- Do not use with an extension cord.
- Fully insert the plug into a household outlet. Never use the appliance if the plug fits loosely.
- Always ensure the appliance is operated on an electric power source matched to the rated voltage indicated on the appliance.
- When the appliance is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the appliance is switched off.
- For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent (described in the warranty), or similarly qualified persons in order to avoid a hazard.
In case of an abnormality or malfunction
- Immediately stop using and remove the plug if there is any abnormality or malfunction. < Abnormality or malfunction cases>
- Air is not emitted
- Unit stops sporadically
- Interior becomes red-hot and smoke is emitted
- The appliance is damaged or deformed, or strange noise is emitted.
Immediately request inspection or repair at an authorized service center.
Maintenance
- When you see sparks around the air outlet while using the hot air setting, stop using and remove the lint on the air outlet and air inlet.
This appliance
- Do not block, or insert hair pins or other foreign objects into the air inlet, air outlet, or ion outlet.
- Do not leave the product with the power switch on.
- Do not keep within the reach of infants or young children. Do not let them use the appliance.
- Do not use in proximity of flammable materials (such as alcohol, benzine, thinner, spray, hair care product, nail polish remover).
- Never modify, disassemble, or repair. Doing so may cause ignition or injury due to abnormal operation. Contact an authorized service center for repair.
- Do not handle any part of the plug or appliance with wet hands.
- This appliance is not designed for commercial use, and is not intended for use without appropriate maintenance.
- Do not immerse the appliance in water.
- Do not use or store the appliance near water.
- Do not use or store the appliance near bathtubs, showers, basins or other vessels containing water.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
CAUTION
To protect your hair
- Be sure to keep a distance of over 3 cm between the air outlet and your hair.
- Be sure to keep your hair at least 10 cm away from the air inlet to avoid hair getting tangled.
Note the following precautions
- Do not drop or subject to shock.
- Do not use on children under 6 years old.
- Do not touch the air outlet and set nozzle which will become very hot.
- Do not use the appliance for any other purpose than drying hair.
Note
- This hair dryer is equipped with an automatic overheating protective device. If the hair dryer overheats, it will switch to cool air mode. Switch off the hair dryer and unplug it from the household outlet. Allow it to cool down for a few minutes before using it again. Check that no fluff, hair, etc. is in the air inlets and outlets before switching it on again.
Parts identification
- Set Nozzle
- B Air outlet
- C Ion outlet EH-NE27 only
- D Air inlet
- E Cool‑shot button
- The air remains cool while the cool-shot
- button is held down.
- F Handle
- G Ring for hanging
- H Cord
- I Plug
- Power switch
How to use
- Before using the hair dryer, confirm that the power switch is at position “ ”, then plug into a household outlet and turn on the power switch.
- Select the airflow with the power switch, and then dry your hair.
- Set the power switch to position “ ”, and then remove the plug from the household outlet.
Set nozzle
For easy styling and blow drying of hair, attach the set nozzle to the hair
dryer.
- Set nozzle helps to direct the airflow onto a specific area of the hair.
About ion (EH-NE27 only)
Ions are particles that combine negatively charged oxygen and moisture in the air, and cannot be seen through the naked eye. (Ion generation method: High- voltage discharge)
Notes
- You may notice a specific odor when using this hair dryer. This is not harmful to the human body.
- The effects of ion might not be felt by the following people. People with crimpy hair, strong curly hair, very smooth hair, short hair, or who have had a hair straightening perm in the last three or four months.
About Heat Protection
This mode provides constant and warm temperature to protect hair from heat.
About Scalp Care
This mode provides gentle warm air for scalp care blows.
Maintenance
Always turn the power switch off and disconnect the plug from the household outlet. (Except when performing maintenance on the air outlet)
Maintaining the air inlet
Clean the air inlet once a month or over.
● Clean lint, hair, or other matter from the air inlet with a toothbrush or a
vacuum cleaner.
Maintaining the air outlet
Clean the air outlet once a month.
Scrub to remove any dust, hair, etc. blocking the mesh.
- The hair dryer should be plugged into the household outlet only in case of maintenance for the air outlet.
- Select [ ], [ ] or [ ] with the power switch and held down at cool-shot button for using cool airflow to blow away the dust, etc., as you scrub with the toothbrush.
Notes
- During maintenance, do not block the air inlet with your hands, etc.
- During or after maintenance of the air outlet, dust, etc. may scatter. Ensure that the hair dryer does not blow out any dust from the air outlet before using. (Do not look into the air outlet.)
Maintaining the ion outlet (EH-NE27 only)
Clean the ion outlet about once every 1 month. This maintenance allows the hair dryer to sustain the generated level of ion over a long period.
- Use commercially available cotton swabs. (We recommend the thin cotton swabs made for babies.)
- Insert the cotton swab softly until it stops (approximately 10 mm), then rotate it softly 2 or 3 times.
Maintaining the hair dryer
Clean the hair dryer when it gets dirty. Clean the housing only with a soft cloth slightly dampened with tap water or soapy tap water.
Notes
- Do not use substances such as alcohol, nail polish remover or detergent (hand soap). Doing so may result in malfunction, cracks or discoloration.
- Do not leave the appliance with hairdressing products or cosmetics on it. Doing so will cause deterioration of the plastic, leading to discoloration or cracks.
Troubleshooting
Troubleshooting
Problem| | Possible cause| | Action
Sparks can be seen inside the product.
(These sparks are caused by a protective device (thermostat switch).
They are not dangerous.).
|
Lint has accumulated on the air inlet or air outlet.
Hair or something is blocking the air inlet.
|
Remove accumulated lint. Do not block the air inlet.
The hot air repeatedly turns into cool air.
The hot air is abnormally hot.
The plug is abnormally hot.
| The connection to the household outlet is loose.| Use a household outlet that
fits securely.
Sparks are generated inside the ion outlet. (EH-NE27 only)|
The needle portion in the inner part of the ion outlet is dirty.
|
Perform maintenance of the ion outlet.
The ion outlet emits a noise (crackling noise).
(EH-NE27 only)
If the problems still cannot be solved, contact the store where you purchased the unit or a service center authorized by Panasonic for repair.
Specifications
Power source| 220 V 50 – 60 Hz| 230 V 50 – 60 Hz| 240 V
50 – 60 Hz
---|---|---|---
Power consumption| 1 500 W| 1 650 W| 1 800 W
Accessory| Set Nozzle
This product is intended for household use only.
Documents / Resources
|
Panasonic EH-NE27 Hair
Dryer
[pdf] Instruction Manual
EH-NE27, EH-ND37, EH-NE27 Hair Dryer, Hair Dryer, Dryer
---|---
|
Panasonic EH-NE27 Hair
Dryer
[pdf] Instruction Manual
EH-NE27 Hair Dryer, EH-NE27, Hair Dryer, Dryer
|
Panasonic EH-NE27 Hair
Dryer
[pdf] User Manual
EH-NE27 Hair Dryer, EH-NE27, Hair Dryer, Dryer
|
Panasonic EH-NE27 Hair
Dryer
[pdf] Instruction Manual
EH-NE27, EH-ND37, EH-NE27 Hair Dryer, EH-NE27, Hair Dryer, Dryer
|
Panasonic EH-NE27 Hair
Dryer
[pdf] Instruction Manual
EH-NE27, EH-ND37, EH-NE27 Hair Dryer, Hair Dryer, Dryer
|
Panasonic EH-NE27 Hair
Dryer
[pdf] Instruction Manual
EH-NE27 Hair Dryer, EH-NE27, Hair Dryer, Dryer
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>