bullfrog Spas 2024 Hot Tubs and Swim User Guide
- June 1, 2024
- bullfrog spas
Table of Contents
bullfrog Spas 2024 Hot Tubs and Swim
PREPARING YOUR SPA FOR DELIVERY
- Standard delivery may be accomplished using specialized spa moving equipment if your delivery path meets the following criteria.
- If your yard does not meet these criteria, please tell the delivery team when delivery is scheduled to make arrangements for a crane or other delivery method.
CRITERIA
- The path is reasonably flat. (The spa dolly can go over grass, gravel, and dirt.)
- The chosen path and final resting space can accommodate up to 3 feet 6 inches wide and 9 feet for our largest hot tub.
- The spa will rest no more than 4 feet off the ground.
- Your electrical is complete and up to code.
NOTE
Additional charges may apply if standard delivery criteria are not met. M9 and
A9 will require up to 12’ if the delivery requires the spa to be put on its
short side.
CHOOSING A LOCATION
Double-check the spa dimensions when deciding where to locate your spa. A
level-poured concrete slab at least 4 inches thick is recommended for the base
of your spa, but other surfaces may also be acceptable. DO NOT use shims to
level your spa.
COMMON SURFACE CHOICES
Concrete pad, pavers, contained pea gravel, and decking. This is for a
Covermate I™ Cover Lifter bar. Ask the sales associate for other lifter
options and clearance needed.
POWER REQUIREMENTS
Supply line (50amp) (60 amps for A9L, M9 and M8 Models)
Spa disconnect/breaker with GFCI
- Consult the electrician on what conduit to use.
- Example of optional stub-up location (this is underneath the spa).
- Please refer to your Owner’s Manual for specific placement of stub up location on your spa model.
- Electrical chase way option built into your hot tub (Left)
- An electrical chase way option built into your hot tub (Back)
- Electrical chase way option built into your hot tub (Right)
- Hard wire connection inside the spa
- We don’t provide electrical wiring. If you need a quote, contact a licensed electrician.
ELECTRICAL WIRE LENGTH & RECOMMENDATIONS
This document will provide you and your electrician with the amount of wiring
you will need from your GFCI box to your new Bullfrog Spa.
INSTRUCTIONS
STEP 1
Measure the distance of 1 (GFCI box to ground) and enter several feet in the
first box below.
STEP 2
Measure the distance of 2 (GFCI to the spa) and enter several feet in the
second box below.
STEP 3
Add box 1 and box 2 to get the length of wire in feet needed from GFCI to the
spa.
STEP 4
On pages 6–8, find your spa model, decide where the front of the spa will be
in your backyard, and determine what chase way you will use. (Swim Models can
be found on page 4).
STEP 5
On page 2, write in box 1, your chase-way length. In box 2, write the length
of the wire from the previous page. Add box 1 and box 2 and this will be the
total length of wire needed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>