HOBO MX802 Well Cap Instruction Manual
- June 1, 2024
- Hobo
Table of Contents
HOBO MX802 Well Cap
Items Included
- Well cap with disk and screw
- Cable tie
Before you Begin
Follow these instructions before deploying the logger in the well. If the logger has already been installed in a well, remove it before continuing.
Attaching the Well Cap to a Well
This cap can be installed on a standard 5 cm (2 inch) metal or PVC pipe
without glue. It also fits on most threaded 5 cm (2 inch) pipes. If the cap is
too loose once installed on a threaded pipe, add a small piece of connector
pipe that is threaded on one end and cut off on the other end, leaving no
threads on the end to be connected to the well cap. You can add duct tape
around the threaded portion so that the cap is snug when placed on the pipe.
Place the closed well cap on the end of the well. Use a hammer or mallet to
tap the well cap firmly in place. Attach a padlock to the latch if desired.
Installing the Well Cap for a HOBO MX802 or MX2001 Logger
-
If the disk is inside the well cap, remove it. Remove the screw from the disk with a Phillips-head screwdriver.
-
Insert the top end of the logger into the opening between the two raised holes on the disk. Slide the screw through all three holes and tighten it with a screwdriver. Attach the cable tie to the disk by feeding it through the two side holes as shown below.
-
Place the disk with the installed logger into the well cap.
-
Close the well cap. Use the cable tie as a handle to pull out the logger and disk as needed.
Installing the Well Cap for a HOBO U Series Logger
-
If the disk is inside the well cap, remove it and leave the screw in place as shown below.
-
Feed the wire you are using to deploy the logger through the two side holes on the disk and crimp it as shown below using two crimps. Connect the other end of the wire to the logger. Or, you can suspend cables from the screw for mounting additional loggers.
-
Insert the logger and disk into the well cap as shown in the example in step 3 of the MX2001 logger instructions.
-
Close the well cap. Use the wire as a handle to pull out the logger and disk as needed.
Customer Support
© 2024 Onset Computer Corporation. All rights reserved. Onset and HOBO are
registered trademarks of Onset Computer Corporation. All other trademarks are
the property of their respective companies.
U.S. and International Sales:
1-508-759-9500
www.onsetcomp.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>