Kiddesigns 202C10A Walkie Talkies User Manual

: May 15, 2024
: Kiddesigns

Table of Contents

Product Description
Battery Installation
FCC Information
WARRANTY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Kid designs 202C10A Walkie Talkies ****

Kid designs 202C10A Walkie Talkies

Product Description

Battery Installation

Note: Batteries should always be installed by an adult.

Use a Phillips screwdriver to open the battery compartment door located on the back of the unit.
Insert 2 “AAA” (R03) batteries into each Walkie Talkie with + and – terminals as indicated in the compartment
Replace the compartment door and tighten the screw with a Phillips screwdriver. Do not over-tighten the screw.

DON’T FORGET THE BATTERIES!

4x “AAA” BATTERIES REQUIRED (NOT INCLUDED)

FCC Information

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for This product meets the applicable Industry Canada technical specifications.

This device complies with ISED license-exempt RSS standard(s). Operation is subject to the following two conditions:

this device may not cause interference, and
this device must accept any interference, including interference that may cause undesired operation of the device. For body worn operation, this model device has been tested and meets the FCC/ISED RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that Contains no metal and that positions of the face up minimum distance f is 5 mm. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: All controls, adjustments and switches that’s instructed in the manual or follow-up instruction provided by the manufacturer that may be operated or adjusted without resulting in a violation of FCC rules.
WARNING: Any adjustment that could result in a violation of FCC rules and it’s recommended that could be performed only by or under the immediate supervision and responsibility of a person certified as technically qualified to perform transmitter maintenance and repair duties in this radio service by an organization or committee representative of users of that service. Effective September 30, 2019, no person shall sell or offer for sale hand-held portable radio equipment capable of operating under FRS and under any other licensed or licensed-by-rule radio services in CFR Title 47 Chapter I.
Replacement of any transmitter component (crystal, semiconductor, etc.) not authorized by the IC/FCC equipment authorization for this radio could violate IC/FCC rules.

Portable Radio Operation and RF Exposure

Antenna Care
Use only the supplied or an approved replacement antenna. Unauthorized antennas, modifications, or attachments could damage the radio and may violate FCC/IC regulations.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
CAN ICES-3 (B)/NMB-3(B), CAN RSS-Gen/CNR-Gen

WARRANTY

One year lin1ited warranty. Visit www.eKids.com/support for details. Valid only in U.S.A

AGE GRADE: Ages 3 and over.
CONTENTS: 2 Walkie Talkies.
REQUIRES: 4 X “AAA” (R03) batteries (not included).
Do not n1ix old and new batteries, and do not mix alkaline, carbon-zinc, or rechargeable nickel-cadmium batteries.
Insert batteries with correct polarity (+/-) as indicated.
Do not attempt to recharge non-rechargeable batteries.
To prevent battery leakage or damage, remove batteries from product if it will not be used for a month or longer.
Use extreme caution handling leaking batteries (avoid direct contact with eyes and skin). If battery leakage comes in contact with eyes, IMMEDIATELY flush the eyes with gently flowing, lukewarm water for at least 30 n1inutes. If skin contact occurs, wash skin with clean water for at least 15 minutes. Seek n1edical attention if any syn1ptoms occur.
Follow applicable laws and local regulations for the disposal and transportation of batteries.
- DO NOT DISPOSE OF BATTERIES IN A FIRE; BATTERIES MAY EXPLODE OR LEAK.
Product specifications and colors may vary from photo.
Packaging should be kept as it contains important information.