Lamps4sale 3xE27-72W-230V Bathroom Ceiling Light Instructions
- June 1, 2024
- Lamps4sale
Table of Contents
Lamps4sale 3xE27-72W-230V Bathroom Ceiling Light
TECHNICAL DATA
Power :| 1200 W (for incandescent sources)
300 W (for luminous tubes, LED lamps)
---|---
detected motion speed:| 0.6 – 1.5 m/s
Light intensity range:| 3- 2000 LUX
Power consumption:| 0,9 W (during operation)
HF System :| 5.8 GHz CW, ISM band
Transmission Power:| < 0,2 mW
Power supply:| 220-240 V / 50/60 Hz
detection reach:| 1-8 m
detection angle:| 360°
Working time :| min: 10 sec ± 3 sec; max: 12 mint 1 min
Installation height:| 2 – 6 m
INSTALLATION
-
Disconnect the power supply.
-
Connect the cab1les according to the diagram in Fig. 1.
-
Switch on the power supply and perform the sensor test.
SENSOR TEST
-
Set the time (TIME) to the minimum and sensitivity to light (LUX) to the maximum if the test is carried out in daytime -Fig. 2.
-
After switching on the power supply, the device needs 30 seconds to enter the operation mode.
-
The light the sensor is connected to should light after detecting a motion in the sensor operation field.
-
Detecting another motion during the lamp operation extends the period of operation.
-
By changing the settings of LUX, SENS and TIME we can adapt the sensor operation to individual requirements.
COMMENTS
- Connect electric cables according to the instructions and effective standards.
- The installation should be made by an authorised electrician.
- Prior to connecting the device, make sure that the main power supply has been switched off.
- Do not install the sensor neither near sources of heat, air-conditioning outlets, flue gas pass or dryers, nor during rainfall.
- The sensor is more efficient if the object supposed to activate the lighting device moves across the sensor operation field, whereas it is less efficient when the object moves towards or backwards from the sensor.
TROUBLESHOOTING
If the lamp connected to the sensor does not work:
- check whether electrical connections are correct;
- check whether the lamp is in a good working condition;
- check whether LUX settings correspond with the lighting conditions.
If the coverage/ sensitivity is too poor:
- check whether there are no obstacles in the sensor operation field;
- check whether the object moves in the sensor operation field;
- check whether the sensor is installed at an appropriate height.
The sensor does not switch off the connected lamp automatically:
- check whether there is no continuous movement in the sensor operation field;
- check whether the sensor is not set to the longest operation time (TIME),;
- check whether the power of the connected lamp does not exceed the maximum sensor load.
WEEE label sign if es the necessity of selective collection of waste electric and electronic equipment. The products thus marked must not be disposed of to the standard waste bins together with other types of waste. Such products may be environmentally harmful and require special forms of processing, recovery, recycling and neutralization.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>