INNOVATIONS LIGHTING 443SW-1W Metro 1 Light 10 Inch Sconce with Switch Instruction Manual

: June 13, 2024
: INNOVATIONS LIGHTING

Table of Contents

INNOVATIONS LIGHTING 443SW-1W Metro 1 Light 10 Inch Sconce with Switch
INSTRUCTIONS
STANDARD MOUNTING PLATE INSTALLATION INSTRUCTIONS
General
Read User Manual Online (PDF format)
Download This Manual (PDF format)

INNOVATIONS LIGHTING 443SW-1W Metro 1 Light 10 Inch Sconce with Switch

ITEM: 443sw-1W
DESIGN COPYRIGHT – 11/25/2021
ALL RIGHTS RESERVED AND MAY NOT BE DUPLICATED WITHOUT OUR WRITTEN PERMISSION

INSTRUCTIONS

STANDARD MOUNTING PLATE INSTALLATION INSTRUCTIONS

FOR YOUR SAFETY WARNING

Risk of Fire, Consult a qualified electrician to ensure the correct branch circuit conductor.
Tum off the main power at the circuit breaker before installing the fixture in order to prevent possible shock.

General

All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician. Remove the fixture and the mounting package from the box and make sure that no parts are missing by referencing the illustration.

CAUTION : DISCONNECT POWER DURING INSTALLATION

If you are replacing an existing fixture, disconnect and remove the old fixture. Expose the supply wiring from the outlet box.
Fasten the mounting plate to the outlet box using the two box screws supplied with the outlet box.
Spread the electrical wires so that the black wires are on one side of the outlet box and the white wires are on the other side.
Grounding instructions:
A.) On fixtures where the mounting plate is provided with a green ground screw and two raised dimples, Wrap ground wire from the outlet box around the green ground screw and tighten.
B.) On fixtures where the mounting plate is provided with a green ground wire attached. Connect mounting plate ground wire to ground wire from outlet box with wire connector(not provided).
If the fixture is provided with ground wire. Connect fixture ground wire to ground wire from outlet box with wire connector (not provided). After following the above steps. Never connect ground wire to black or white power supply wires.
To make electrical connections: Connect the white wire(s) from the fixture to the white wire of this outlet box. Connect the black wire(s) from the fixture to the black wire of the outlet box.
NOTE : Black wire from the outlet box may be red, round & smooth, and/or have a copper conductor. White wire from the outlet box may be square & ridged and/or have a silver conductor. After the wires are connected, tuck them carefully inside the outlet box.
Place the fixture against the mounting surface allowing the machine screws to pass through the fixture backplate. then, secure the machine screws tight.