AMIR UF58_6PCS-JG Motion Sensor LED Night Lights User Guide
- June 1, 2024
- AMIR
Table of Contents
AMIR UF58_6PCS-JG Motion Sensor LED Night Lights
Welcome Guide Night Light
Important Safety Instructions
Read and follow all the safety instructions:
- This device is for indoor use only.
- This device should not be exposed to dripping or splashing water
- This device is powered by three AAA batteries (not included). Do not attempt to recharge them when using non-rechargeable batteries.
- This device uses a non-replaceable light source.
- When the light source reaches the end of its lifecycle, the device should be replaced.
- Do not install near any heat sources.
- Do not place any sources of danger on this device(e.g. liquid filled objects, lighted candles).
- Do not mix different types of batteries together, e.g.lithiumion (Li-ion) and nickel-metal hydride (NiMH)batteries.
- Do not mix new and used batteries.
- Do not use metal objects to connect the terminals of the battery.
- An exhausted battery should be disposed of according to local environmental regulations.
Introduction
Thank you for purchasing our Stick-On Night Light. We use light and motion-
sensing technology to temporarily illuminate dark spaces with a soft light.
At a Glance
- Motion sensor
- LED light
Installing the Batteries
- Slide down to remove the mounting bracket on the back of night light
- Insert three AAA batteries. Make sure the positive and negative ends are facing the correct polarity direction as marked in the battery compartment.
Installing
Option A: Installing night light with the adhesive mounting bracket:
- Remove the protective film on the back of the bracket.
- Stick the bracket onto the wall. Make sure the arrow on the bracket is pointing up.
- Align the holes on the back of night light with the pins on the bracket; slide down to mount of night light.
Option B: Installing night light with the screws (Not included)
-
Measure a distance of 1.97in (50mm) between two points for the wall plugs. Use a pen to mark the drill points.
-
Use a drill bit to drill two 0.9in (23mm) deep holes and fully insert the wall plugs into the holes.
-
Align the mounting bracket with the wall plugs and hold against the wall. Insert the screws through the fixing holes and screws (not included) firmly into the wall plugs. Make
sure the arrow on the mounting bracket is pointing up when installing. -
Align the mounting holes on the back of night light with the pins on the mounting bracket; slide down to mount of night light.
Using Your Night Light
| It does not tum on in bright areas.
---|---
| In dark areas, it does not turn on if motion is not detected within its
effective range.
| In dark areas, It automatically turns on If motion Is detected within its
effective range. The light automatically rums off If motion Is not detected
for 15 seconds.
Specications
| Light Wattage | 0.8W |
|---|---|
| Battery | 3 AAA batteries (not included) |
| Dimensions | 80 x 80 x 45 mm, a.2xa.2×1.Bin |
| Weight | 67g/2.4oz |
Troubleshooting
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>