PHILIPS RC4873401 Remote Control User Guide
- June 1, 2024
- Philips
Table of Contents
PHILIPS RC4873401 Remote Control User Guide
Know your Remote
Backlight Key Behavior
When “123/ Backlight” key is pressed, hidden key mode is enabled.
How to pair your RCU with TV
-
Long press (3s) ‘SOURCES’ BT Pairing Advertising.
-
BLE RC pairing name – APHRC
-
RC to stay in pairing mode for 60s. Press any key to cancel pairing mode (See Cancel Pairing)
-
RC to store pairing info upon successful pairing. White LED at mic hole stays on for 3s if pairing.
successful. -
RC will only pair to 1 TV. Pairing info will be erased if user enter pairing mode again.
Voice Function
Follow 2024 Linux RC voice protocol supporting On Demand, HTT voice models.
The White LED will be turned on for the full duration of audio sample
transmission.
Note:
During voice, any key press will not stop the voice transmission.
LED Backlight Condition
LED Backlight Condition
Key pressed| If Normal key back light OFF
If Hidden key back light OFF| If Hidden key backlight OFF| If Normal key back
light OFFIf Hidden key back light ON| If Normal key back light ON If Hidden
key back light ON
Press ‘123’ key| Hidden key back light Turns ON for 5sNormal key backlight
Turns ON for 5s| Hidden key back light Turns ON for 5 s Normal key back light
Turns ON for 5s| NA| Hidden key back light Turns OFF Normal key back light
Remains ON for 25
Pres Normal keys| Normal key backlight Tums ON for 25| Normal key backlight
Turns ON for 2s| NA| Hidden key back light Remains ON for 25 Normal key back
light Turns ON for 2s
Press Hidden keys| NA(This condition is working for normal key)| NA(This
condition is working for normal key)| NA| Hidden key backlight Remains ON for
5sNormal key backlight Remains ON for 55
Sleeping Mode
When without any activity, the RC enters sleeping for power saving purpose.
The sleeping mode behaves as below:
i) All LEDs are off.
ii) IR stopped, and no RF data transmitting or receiving, after IDLE
timeout, disconnect with host.
iii) Any key press will wake up the RC.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired
operation.
FCC Caution
Please take attention that changes or modification not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>